- 您現在的位置：買賣IC網 > PDF目錄10680 > AD7792BRUZ (Analog Devices Inc)IC ADC 16BIT SIG-DEL 3CH 16TSSOP PDF資料下載
參數資料
| 型號： | AD7792BRUZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/33頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 16BIT SIG-DEL 3CH 16TSSOP |
| 標準包裝： | 96 |
| 位數： | 16 |
| 采樣率（每秒）： | 500 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 2.5mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 3 個差分，單極；3 個差分，雙極 |
| 產品目錄頁面： | 779 (CN2011-ZH PDF) |
| 配用： | EVAL-AD7792EBZ-ND - BOARD EVALUATION FOR AD7792 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
AD7792/AD7793
Rev. B | Page 18 of 32
Bit Location
Bit Name
Description
CON7
REFSEL
Reference Select Bit. The reference source for the ADC is selected using this bit.
REFSEL
Reference Source
0
External Reference Applied between REFIN(+) and REFIN(–).
1
Internal Reference Selected.
CON6 to
CON5
0
These bits must be programmed with a Logic 0 for correct operation.
CON4
BUF
Configures the ADC for buffered or unbuffered mode of operation. If cleared, the ADC operates in unbuffered
mode, lowering the power consumption of the device. If set, the ADC operates in buffered mode, allowing the
user to place source impedances on the front end without contributing gain errors to the system. The buffer
can be disabled when the gain equals 1 or 2. For higher gains, the buffer is automatically enabled.
With the buffer disabled, the voltage on the analog input pins can be from 30 mV below GND to 30 mV above
AVDD. When the buffer is enabled, it requires some headroom, so the voltage on any input pin must be limited
to 100 mV within the power supply rails.
CON3
0
This bit must be programmed with a Logic 0 for correct operation.
CON2 to
CON0
CH2 to
CH0
Channel Select Bits. Written by the user to select the active analog input channel to the ADC.
CH2
CH1
CH0
Channel
Calibration Pair
0
AIN1(+) – AIN1(–)
0
1
AIN2(+) – AIN2(–)
1
0
1
0
AIN3(+) – AIN3(–)
2
0
1
AIN1(–) – AIN1(–)
0
1
0
Reserved
1
0
1
Reserved
1
0
Temp Sensor
Automatically selects gain = 1 and internal reference
1
AVDD Monitor
Automatically selects gain = 1/6 and 1.17 V
reference
DATA REGISTER
RS2, RS1, RS0 = 0, 1, 1; Power-On/Reset = 0x0000(00)
The conversion result from the ADC is stored in this data register. This is a read-only register. On completion of a read operation from
this register, the RDY bit/pin is set.
ID REGISTER
RS2, RS1, RS0 = 1, 0, 0; Power-On/Reset = 0xXA (AD7792)/0xXB (AD7793)
The identification number for the AD7792/AD7793 is stored in the ID register. This is a read-only register.
IO REGISTER
RS2, RS1, RS0 = 1, 0, 1; Power-On/Reset = 0x00
The IO register is an 8-bit register from which data can be read or to which data can be written. This register is used to enable and select
the value of the excitation currents. Table 18 outlines the bit designations for the IO register. IO0 through IO7 indicate the bit locations;
IO denotes that the bits are in the IO register. IO7 denotes the first bit of the data stream. The number in parentheses indicates the power-
on/reset default status of that bit.
IO7
IO6
IO5
IO4
IO3
IO2
IO1
IO0
0(0)
IEXCDIR1(0)
IEXCDIR0(0)
IEXCEN1(0)
IEXCEN0(0)
相關PDF資料 |
PDF描述 |
|---|---|
| VI-J20-MY-F2 | CONVERTER MOD DC/DC 5V 50W |
| VI-J20-MY-F1 | CONVERTER MOD DC/DC 5V 50W |
| VI-2WH-MY-B1 | CONVERTER MOD DC/DC 52V 50W |
| LTC2309HF#PBF | IC ADC 12BIT SAR 20-TSSOP |
| VI-2WB-MY-B1 | CONVERTER MOD DC/DC 95V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7792BRUZ | 制造商:Analog Devices 功能描述:IC ADC 16BIT 470SPS TSSOP-16 |
| AD7792BRUZ1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:3-Channel, Low Noise, Low Power, 16-/24-Bit ?￡-?? ADC with On-Chip In-Amp and Reference |
| AD7792BRUZ-REEL | 功能描述:IC ADC 16BIT 3CH LP 16-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7792BRUZ-REEL1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:3-Channel, Low Noise, Low Power, 16-/24-Bit ?￡-?? ADC with On-Chip In-Amp and Reference |
| AD7793 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, 16/24-Bit Sigma-Delta ADC with Low-Noise In-Amp and Embedded Reference |
發布緊急采購，3分鐘左右您將得到回復。