參數資料
| 型號： | AD7707BRU |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 50/52頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 16BIT 3CH 20-TSSOP |
| 標準包裝： | 75 |
| 位數： | 16 |
| 采樣率（每秒）： | 500 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 1mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 20-TSSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個單端，單極；1 個單端，雙極；2 個偽差分，單極；2 個偽差分，雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁當前第50頁第51頁第52頁
AD7707
Rev. B | Page 7 of 52
Parameter
B Version1
Unit
Conditions/Comments
Normal Mode Power Dissipation17
AVDD = DVDD = 3 V; digital inputs = 0 V or DVDD; external
MCLK IN excluding dissipation in the AIN3 attenuator
1.05
mW max
Typically 0.84 mW; BUF = 0; fCLKIN = 1 MHz, all gains
2.04
mW max
Typically 1.53 mW; BUF = 1; fCLK IN = 1 MHz; all gains
1.35
mW max
Typically 1.11 mW; BUF = 0; fCLK IN = 2.4576 MHz,
gain = 1 to 4
2.34
mW max
Typically 1.9 mW; BUF = 1; fCLK IN = 2.457 6 MHz;
gain = 1 to 4
Normal Mode Power Dissipation17
AVDD = DVDD = 5 V; digital inputs = 0 V or DVDD;
external MCLKIN
2.1
mW max
Typically 1.75 mW; BUF = 0; fCLKIN = 1 MHz; all gains
3.75
mW max
Typically 2.9 mW; BUF = 1; fCLKIN = 1 MHz; all gains
3.1
mW max
Typically 2.6 mW; BUF = 0; fCLK IN = 2.4576 MHz
4.75
mW max
Typically 3.75 mW; BUF = 1; fCLK IN = 2.4576 MHz
18
μA max
External MCLK IN = 0 V or DVDD; typically 9 μA;
AVDD = 5 V
8
μA max
External MCLK IN = 0 V or DVDD; typically 4 μA;
AVDD = 3 V
1 Temperature range as follows: B Version, 40°C to +85°C.
2 These numbers are established from characterization or design at initial product release.
3 A calibration is effectively a conversion so these errors are of the order of the conversion noise shown in Table 7 and Table 9 for the low level input channels AIN1 and
AIN2. This applies after calibration at the temperature of interest.
4 Recalibration at any temperature removes these drift errors.
5 Positive full-scale error includes zero-scale errors (unipolar offset error or bipolar zero error) and applies to both unipolar and bipolar input ranges.
6 Full-scale drift includes zero-scale drift (unipolar offset drift or bipolar zero drift) and applies to both unipolar and bipolar input ranges.
7 Gain error does not include zero-scale errors. It is calculated as full-scale error—unipolar offset error for unipolar ranges and full-scale error—bipolar zero error for
bipolar ranges.
8 Gain error drift does not include unipolar offset drift/bipolar zero drift. It is effectively the drift of the part if
zero-scale calibrations were performed.
9 Error is removed following a system calibration.
10 This common-mode voltage range is allowed provided that the input voltage on analog inputs does not go more positive than AVDD + 30 mV or go more negative
than AGND 100 mV. Parts are functional with voltages down to AGND 200 mV, but with increased leakage at high temperature.
11 The analog input voltage range on AIN(+) is given here with respect to the voltage on LCOM on the low level input channels (AIN1 and AIN2) and is given with
respect to the HCOM input on the high level input channel, AIN3. The absolute voltage on the low level analog inputs should not go more positive than AVDD +
100 mV, or go more negative than GND 100 mV for specified performance. Input voltages of AGND 200 mV can be accommodated, but with increased leakage at
high temperature.
12 VREF = REF IN(+) REF IN().
13 These logic output levels apply to the MCLK OUT only when it is loaded with one CMOS load.
14 Sample tested at +25°C to ensure compliance.
15 After calibration, if the analog input exceeds positive full scale, the converter outputs all 1s. If the analog input is less than negative full scale, the device outputs all 0s.
16 These calibration and span limits apply provided that the absolute voltage on the analog inputs does not exceed AVDD + 30 mV or go more negative than AGND
mV. The offset calibration limit applies to both the unipolar zero point and the bipolar zero point.
17 When using a crystal or ceramic resonator across the MCLK pins as the clock source for the device, the DVDD current and power dissipation varies depending on the
crystal or resonator type (see the Clocking and Oscillator Circuit section).
18 Measured at dc and applies in the selected pass band. PSRR at 50 Hz exceeds 120 dB with filter notches of 25 Hz or 50 Hz. PSRR at 60 Hz exceeds 120 dB with filter
notches of 20 Hz or 60 Hz.
20 If the external master clock continues to run in standby mode, the standby current increases to 150 μA typical at 5 V and 75 μA typical at 3 V. When using a crystal or
ceramic resonator across the MCLK pins as the clock source for the device, the internal oscillator continues to run in standby mode and the power dissipation depends
on the crystal or resonator type (see the Standby Mode section).
Table 2. Low Level Input Channels, AIN1 and AIN2
Gain
1
2
4
8 to 128
AVDD = 3 V
86
78
85
93
AVDD = 5 V
90
78
84
91
Table 3. High Level Input Channel, AIN3
Gain
1
2
4
8 to 128
AVDD = 3 V
68
60
67
75
AVDD = 5 V
72
60
66
73
相關PDF資料 |
PDF描述 |
|---|---|
| AD7709ARU | IC ADC 16BIT SIGMA-DELTA 24TSSOP |
| AD7710AQ | IC ADC 24BIT DIFF INP 24-CDIP |
| AD7711AAR | IC ADC 24BIT RTD I SOURCE 24SOIC |
| AD7711AN | IC ADC 24BIT RTD I SOURCE 24-DIP |
| AD7712AR | IC ADC SIGNAL COND LC2MOS 24SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7707BRU-REEL | 制造商:Analog Devices 功能描述:ADC Single Delta-Sigma 500sps 16-bit Serial 20-Pin TSSOP T/R 制造商:Analog Devices 功能描述:ADC SGL DELTA-SIGMA 0.5KSPS 16BIT SERL 20TSSOP - Tape and Reel |
| AD7707BRU-REEL7 | 功能描述:IC ADC 16BIT 3CH 20-TSSOP T/R RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7707BRUZ | 功能描述:IC ADC 16BIT 3CH 20-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯(lián) 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| AD7707BRUZ-REEL | 功能描述:IC ADC 16BIT 3CH 20-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7707BRUZ-REEL7 | 功能描述:IC ADC 16BIT 3CHAN 20TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
發(fā)布緊急采購，3分鐘左右您將得到回復。