參數資料
型號： AD7707BRU
廠商： Analog Devices Inc
文件頁數： 40/52頁
文件大小： 0K
描述： IC ADC 16BIT 3CH 20-TSSOP
標準包裝： 75
位數： 16
采樣率（每秒）： 500
數據接口： DSP，MICROWIRE?，QSPI?，串行，SPI?
轉換器數目： 1
功率耗散（最大）： 1mW
電壓電源： 模擬和數字
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 20-TSSOP（0.173"，4.40mm 寬）
供應商設備封裝： 20-TSSOP
包裝： 管件
輸入數目和類型： 1 個單端，單極；1 個單端，雙極；2 個偽差分，單極；2 個偽差分，雙極
AD7707
Rev. B | Page 45 of 52
PRESSURE MEASUREMENT
Other typical applications for the AD7707 include temperature
and pressure measurement. Figure 28 shows the AD7707 used
with a pressure transducer, the BP01 from Sensym. The pressure
transducer is arranged in a bridge network and gives a differential
output voltage between its OUT(+) and OUT() terminals.
With rated full-scale pressure (in this case 300 mmHg) on the
transducer, the differential output voltage is 3 mV/V of the input
voltage (that is, the voltage between its IN(+) and IN() termin-
als). Assuming a 5 V excitation voltage, the full-scale output
range from the transducer is 15 mV. The low level input channels
are ideal for this type of low signal measurement application.
The excitation voltage for the bridge is also used to generate the
reference voltage for the AD7707. Therefore, variations in the
excitation voltage do not introduce errors in the system. Choosing
resistor values of 24 kΩ and 15 kΩ, as per Figure 28, gives a 1.92 V
reference voltage for the AD7707 when the excitation voltage is 5 V.
Using the part with a programmed gain of 128 results in the
full-scale input span of the AD7707 being 15 mV, which
corresponds with the output span from the transducer.
AD7707
DVDD
5V
REF IN(–)
AGND
MCLK IN
MCLK OUT
DRDY
REF IN(+)
24k
AVDD
AIN1
LOCOM
DGND
OUT(–)
SCLK
DIN
DOUT
CS
CONTROLLER
15k
OUT(+)
EXCITATION VOLTAGE = 5V
IN(–)
IN(+)
08
691-
028
Figure 28. Pressure Measurement Using the AD7707
THERMOCOUPLE MEASUREMENT
Another application area for the AD7707 is in temperature
measurement. Figure 29 outlines a connection from a thermo-
couple to the AD7707. In this application, the AD7707 is operated
in its unbuffered mode to accommodate signals of ±100 mV on
the front end. Cold conjunction compensation is implemented
using the AD590 temperature transducer that produces an
output current proportional to absolute temperature.
AD7707
DVDD
5V
AIN2
REF IN(–)
AGND
MCLK IN
MCLK OUT
DRDY
REF IN(+)
8.2k
CJC
AVDD
AD590
5V
AIN1
LOCOM
DGND
OUT
SCLK
DIN
DOUT
THERMOCOUPLE
JUNCTION
CS
CONTROLLER
REF192
5V
GND
0869
1-
029
Figure 29. Thermocouple Measurement Using the AD7707
RTD MEASUREMENT
Figure 30 shows another temperature measurement application
for the AD7707. In this case, the transducer is an RTD (resistive
temperature device), a PT100. The arrangement is a 4-lead RTD
configuration. There are voltage drops across the lead
resistances, RL1 and RL4, but these simply shift the common-
mode voltage. There is no voltage drop across lead resistances
RL2 and RL3 because the input current to the AD7707 is very low.
The lead resistances present a small source impedance so it is
generally not necessary to turn on the buffer on the AD7707.
If the buffer is required, the common-mode voltage should be
set accordingly by inserting a small resistance between the bottom
end of the RTD and GND of the AD7707. In the application
shown, an external 400 μA current source provides the excitation
current for the PT100 and generates the reference voltage
the AD7707 via the 6.25 kΩ resistor. Variations in the excitation
current do not affect the circuit because both the input voltage
and the reference voltage vary radiometrically with the
excitation current. However, the 6.25 kΩ resistor must have a low
temperature coefficient to avoid errors in the reference voltage over
temperature.
AD7707
DVDD
5V
REF IN(–)
AGND
MCLK IN
MCLK OUT
DRDY
RTD
AVDD
AIN1
LOCOM
DGND
SCLK
DIN
DOUT
CS
CONTROLLER
RL3
6.25k
RL2
RL4
RL1
REF IN(+)
400A
REF IN(+)
REF IN(–)
08
69
1-
03
0
Figure 30. RTD Measurement Using the AD7707
相關PDF資料
PDF描述
AD7709ARU IC ADC 16BIT SIGMA-DELTA 24TSSOP
AD7710AQ IC ADC 24BIT DIFF INP 24-CDIP
AD7711AAR IC ADC 24BIT RTD I SOURCE 24SOIC
AD7711AN IC ADC 24BIT RTD I SOURCE 24-DIP
AD7712AR IC ADC SIGNAL COND LC2MOS 24SOIC
相關代理商/技術參數
參數描述
AD7707BRU-REEL 制造商:Analog Devices 功能描述:ADC Single Delta-Sigma 500sps 16-bit Serial 20-Pin TSSOP T/R 制造商:Analog Devices 功能描述:ADC SGL DELTA-SIGMA 0.5KSPS 16BIT SERL 20TSSOP - Tape and Reel
AD7707BRU-REEL7 功能描述:IC ADC 16BIT 3CH 20-TSSOP T/R RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
AD7707BRUZ 功能描述:IC ADC 16BIT 3CH 20-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
AD7707BRUZ-REEL 功能描述:IC ADC 16BIT 3CH 20-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
AD7707BRUZ-REEL7 功能描述:IC ADC 16BIT 3CHAN 20TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*