參數資料
型號： AD73322LARZ
廠商： Analog Devices Inc
文件頁數： 6/48頁
文件大?。?/td> 0K
描述： IC ANALOG FRONT END DUAL 28-SOIC
標準包裝： 27
位數： 16
通道數： 4
功率（瓦特）： 73mW
電壓 - 電源，模擬： 2.7 V ~ 5.5 V
電壓 - 電源，數字： 2.7 V ~ 5.5 V
封裝/外殼： 28-SOIC（0.295"，7.50mm 寬）
供應商設備封裝： 28-SOIC W
包裝： 管件
AD73322L
Rev. A | Page 14 of 48
FUNCTIONAL DESCRIPTIONS
ENCODER CHANNELS
Both encoder channels consist of a pair of inverting op amps
with feedback connections that can be bypassed if required, a
switched capacitor PGA and a sigma-delta analog-to-digital
converter (ADC). An on-board digital filter, which forms part
of the sigma-delta ADC, also performs critical system-level
filtering. Due to the high level of oversampling, the input
antialias requirements are reduced such that a simple single-
pole RC stage is sufficient to give adequate attenuation in the
band of interest.
PROGRAMMABLE GAIN AMPLIFIER
Each encoder section’s analog front end comprises a switched
capacitor PGA, which also forms part of the sigma-delta
modulator. The SC sampling frequency is DMCLK/8. The
PGA, whose programmable gain settings are shown in Table 8,
may be used to increase the signal level applied to the ADC
from low output sources such as microphones, and can be
used to avoid placing external amplifiers in the circuit. The
input signal level to the sigma-delta modulator should not
exceed the maximum input voltage permitted.
The PGA gain is set by bits IGS0, IGS1, and IGS2 (CRD:0–2) in
control register D.
Table 8. PGA Settings for the Encoder Channel
IGS2
IGS1
IGS0
Gain (dB)
0
1
6
0
1
0
12
0
1
18
1
0
20
1
0
1
26
1
0
32
1
38
ADC
Both ADCs consist of an analog sigma-delta modulator and a
digital antialiasing decimation filter. The sigma-delta modulator
noise-shapes the signal and produces 1-bit samples at a
DMCLK/8 rate. This bit stream, representing the analog input
signal, is input to the antialiasing decimation filter. The
decimation filter reduces the sample rate and increases the
resolution.
ANALOG SIGMA-DELTA MODULATOR
The AD73322L’s input channels employ a sigma-delta
conversion technique, which provides a high resolution 16-bit
output with system filtering being implemented on-chip.
Sigma-delta converters employ a technique known as
oversampling, where the sampling rate is many times the
highest frequency of interest. In the case of the AD73322L, the
initial sampling rate of the sigma-delta modulator is DMCLK/8.
The main effect of oversampling is that the quantization noise is
spread over a very wide bandwidth, up to FS/2 = DMCLK/16
(Figure 13). This means that the noise in the band of interest is
much reduced. Another complementary feature of sigma-delta
converters is the use of a technique called noise-shaping. This
technique has the effect of pushing the noise from the band of
interest to an out-of-band position (Figure 14). The combin-
ation of these techniques, followed by the application of a
digital filter, sufficiently reduces the noise in band to ensure
good dynamic performance from the part (Figure 15).
FS/2
DMCLK/16
DIGITAL FILTER
NOISE SHAPING
A.
00691-012
BAND
OF
INTEREST
FS/2
DMCLK/16
B.
BAND
OF
INTEREST
FS/2
DMCLK/16
C.
BAND
OF
INTEREST
Figure 12. Sigma-Delta Noise Reduction
Figure 13 through Figure 16 show the various stages of filtering
that are employed in a typical AD73322L application. Figure 13
shows the transfer function of the external analog antialias
filter. Even though it is a single RC pole, its cutoff frequency
is sufficiently far away from the initial sampling frequency
(DMCLK/8) that it takes care of any signals that could be
aliased by the sampling frequency. This also shows the major
difference between the initial oversampling rate and the band-
width of interest. In Figure 14, the signal and noise-shaping
responses of the sigma-delta modulator are shown. The
signal response provides further rejection of any high
frequency signals, while the noise-shaping pushes the inherent
quantization noise to an out-of-band position. The detail of
相關PDF資料
PDF描述
MAX934CSE+ IC COMPARATOR QUAD W/REF 16-SOIC
VI-23X-CV-B1 CONVERTER MOD DC/DC 5.2V 150W
AD7730LBRUZ-REEL7 IC ADC TRANSDUCER BRIDGE 24TSSOP
MAX9050BEUK+T IC COMPARATOR SGL SOT23-5
VI-23W-IW CONVERTER MOD DC/DC 5.5V 100W
相關代理商/技術參數
參數描述
AD73322LARZ-REEL 制造商:Analog Devices 功能描述:DUAL-CHANNEL, 3 V FRONT-END PROCESSOR FOR GENERAL PURPOSE - Tape and Reel
AD73322LAST 制造商:Rochester Electronics LLC 功能描述:SPEECH AND TELEPHONY CODEC I.C. - Tape and Reel 制造商:Analog Devices 功能描述:
AD73322LAST-REEL 制造商:Analog Devices 功能描述:Audio Codec 2ADC / 2DAC 16-Bit 44-Pin LQFP T/R 制造商:Rochester Electronics LLC 功能描述:SPEECH AND TELEPHONY CODEC I.C. - Tape and Reel
AD73322LASTZ 制造商:Analog Devices 功能描述: 制造商:Rochester Electronics LLC 功能描述:
AD73322LYR 制造商:Rochester Electronics LLC 功能描述:SPEECH AND TELEPHONY CODEC I.C. - Bulk 制造商:Analog Devices 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*