- 您現在的位置：買賣IC網 > PDF目錄10672 > AD7329BRUZ (Analog Devices Inc)IC ADC 12BIT 8CH MUX SPI 24TSSOP PDF資料下載
參數資料
| 型號： | AD7329BRUZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 13/41頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT 8CH MUX SPI 24TSSOP |
| 標準包裝： | 62 |
| 位數： | 12 |
| 采樣率（每秒）： | 1M |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 30mW |
| 電壓電源： | 雙 ± |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 24-TSSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 8 個單端，單極；8 個單端，雙極；4 個差分，單極；4 個差分，雙極 |
| 產品目錄頁面： | 777 (CN2011-ZH PDF) |
| 配用： | EVAL-AD7329CBZ-ND - BOARD EVALUATION FOR AD7329CBZ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
Data Sheet
AD7329
Rev. B | Page 19 of 40
D
VDD
ADCIN–
MUXOUT–
C2
R1
VIN–
VSS
C1
C3
C4
05402-
030
D
VDD
ADCIN+
MUXOUT+
C2
R1
VIN+
VSS
C1
C3
C4
Figure 31. Equivalent Analog Input Circuit, Differential Mode
Care should be taken to ensure that the analog input does not
exceed the VDD and VSS supply rails by more than 300 mV.
Exceeding this value causes the diodes to become forward
biased and to start conducting into either the VDD supply rail or
the VSS supply rail. These diodes can conduct up to 10 mA
without causing irreversible damage to the part.
In Figure 30 and Figure 31, Capacitor C1 is typically 4 pF and
can primarily be attributed to pin capacitance. Resistor R1 is a
lumped component made up of the on resistance of the input
multiplexer and the track-and-hold switch. Capacitor C2 is the
sampling capacitor; its capacitance varies depending on the
analog input range selected (see the Specifications section).
TRACK-AND-HOLD SECTION
The track-and-hold on the analog input of the AD7329 allows
the ADC to accurately convert an input sine wave of full-scale
amplitude to 13-bit accuracy. The input bandwidth of the track-
and-hold is greater than the Nyquist rate of the ADC. The
AD7329 can handle frequencies up to 20 MHz.
The ADCIN pins connect directly to the input stage of the track-
and-hold circuit. This is a high impedance input. Connecting
the MUXOUT pins directly to the ADCIN pins connects the
multiplexer output to the track-and-hold circuit. The input
voltage range on the ADCIN pins is determined by the range
register bits for the input channel selected. The user must
ensure that the input voltage to the ADCIN pins is within the
selected voltage range.
The track-and-hold enters its tracking mode on the 14th SCLK
rising edge after the CS falling edge. The time required to
acquire an input signal depends on how quickly the sampling
capacitor is charged. With zero source impedance, 300 ns is
sufficient to acquire the signal to the 13-bit level.
The acquisition time required is calculated using the following
formula:
tACQ = 10 × ((RSOURCE + R)C)
where C is the sampling capacitance, and R is the resistance
seen by the track-and-hold amplifier looking at the input.
For the AD7329, the value of R includes the on resistance of the
input multiplexer and is typically 300 . RSOURCE should include
any extra source impedance on the analog input.
When the AD7329 is run at a throughput rate of 1 MSPS with
a 20 MHz SCLK signal, the ADC has approximately 1.5 SCLK
periods plus t8 and the quiet time, tQUIET, to acquire the analog
input signal. The ADC goes back into hold mode on the CS
falling edge.
The current required to drive the ADC is extremely small when
using the external op amp between the MUXOUT and ADCIN
pins. This is due to the high input impedance of the op amp
placed between the MUXOUT and ADCIN pins. This can be seen
in Figure 32, where the current required to drive the AD7329
input is <0.2 μA when AD8021 is placed between the MUXOUT
and ADCIN pins.
0.20
0.14
0
1000
05402-
056
THROUGHPUT RATE (kSPS)
INP
UT
CURRE
NT
(
A)
0.19
0.18
0.17
0.16
0.15
100
200
300
400
500
600
700
800
900
VDD = 12V, VSS = –12V
VCC = VDRIVE = 5V
SINGLE-ENDED MODE
50kHz ON SELECTED CHANNEL
fIN = 50kHz
TA = 25°C
AD8021 BETWEEN MUXOUT
AND ADCIN PINS
Figure 32. Input Current vs. Throughput Rate
35
0
1000
05402-
057
THROUGHPUT RATE (kSPS)
INP
UT
CURRE
NT
(
A)
100
200
300
400
500
600
700
800
900
VDD = 12V, VSS = –12V
VCC = VDRIVE = 5V
SINGLE-ENDED MODE
50kHz ON SELECTED CHANNEL
fIN = 50kHz
TA = 25°C
WIRE LINK BETWEEN MUXOUT
AND ADCIN PINS
30
25
20
15
10
5
Figure 33. Input Current vs. Throughput Rate
with a Wire Link Between MUXOUT and ADCIN
相關PDF資料 |
PDF描述 |
|---|---|
| AD7328BRUZ | IC ADC 12BIT+ SAR 8CHAN 20TSSOP |
| AD7476AYKSZ-500RL7 | IC ADC 12BIT 1MSPS SC70-6 |
| NCS2200SN2T1G | IC COMPARATOR 1V LOW PWR 5TSOP |
| DS90CR218AMTD/NOPB | IC RCVR 21BIT CHAN LINK 48TSSOP |
| LTC2440IGN#PBF | IC ADC DIFFER 24-BIT HS 16-SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7329BRUZ-REEL | 功能描述:IC ADC 12BIT+SAR 8CHAN 24-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7329BRUZ-REEL7 | 功能描述:IC ADC 12BIT+SAR 8CHAN 24-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD73311 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Cost, Low Power CMOS General Purpose Analog Front End |
| AD73311AR | 制造商:Analog Devices 功能描述:Audio Codec 1ADC / 1DAC 16-Bit 20-Pin SOIC W 制造商:Rochester Electronics LLC 功能描述:SPEECH & TELEPHONY CODEC I.C. - Bulk 制造商:Analog Devices 功能描述:SPEECH/TELEPHONY CODEC SMD 73311 |
| AD73311AR-REEL | 制造商:Analog Devices 功能描述:Audio Codec 1ADC / 1DAC 16-Bit 20-Pin SOIC W T/R |
發布緊急采購，3分鐘左右您將得到回復。