- 您現在的位置：買賣IC網 > PDF目錄10329 > AD7265BSUZ-REEL (Analog Devices Inc)IC ADC 12BIT 3CHAN 1MSPS 32TQFP PDF資料下載
參數資料
| 型號： | AD7265BSUZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 14/29頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT 3CHAN 1MSPS 32TQFP |
| 設計資源： | AD7265 in Differential and Single-Ended Configurations Using AD8022 (CN0048) |
| 標準包裝： | 2,000 |
| 位數： | 12 |
| 采樣率（每秒）： | 1M |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 21mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-TQFP |
| 供應商設備封裝： | 32-TQFP（7x7） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 12 個單端，單極；6 個差分，單極；6 個偽差分，單極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
AD7265
Rev. A | Page 20 of 28
To exit this mode of operation and power up the AD7265 again,
a dummy conversion is performed. On the falling edge of CS,
the device begins to power up and continues to power up as
long as CS is held low until after the falling edge of the 10th
SCLK. The device is fully powered up after approximately 1 μs
has elapsed, and valid data results from the next conversion, as
shown in Figure 36. If CS is brought high before the second
falling edge of SCLK, the AD7265 again goes into partial
power-down. This avoids accidental power-up due to glitches
on the CS line. Although the device may begin to power up on
the falling edge of CS, it powers down again on the rising edge
of CS. If the AD7265 is already in partial power-down mode
and CS is brought high between the second and 10th falling
edges of SCLK, the device enters full power-down mode.
FULL POWER-DOWN MODE
This mode is intended for use in applications where throughput
rates slower than those in the partial power-down mode are
required, as power-up from a full power-down takes
substantially longer than that from partial power-down. This
mode is more suited to applications where a series of
conversions performed at a relatively high throughput rate are
followed by a long period of inactivity and thus power-down.
When the AD7265 is in full power-down, all analog circuitry is
powered down. Full power-down is entered in a similar way as
partial power-down, except the timing sequence shown in
Figure 35 must be executed twice. The conversion process must
be interrupted in a similar fashion by bringing CS high anywhere
after the second falling edge of SCLK and before the 10th falling
edge of SCLK. The device enters partial power-down at this
point. To reach full power-down, the next conversion cycle
must be interrupted in the same way, as shown in Figure 37.
Once CS is brought high in this window of SCLKs, the part
completely powers down.
CS
Note that it is not necessary to complete the 14 SCLKs once
is brought high to enter a power-down mode.
To exit full power-down and power up the AD7265, a dummy
conversion is performed, as when powering up from partial
power-down. On the falling edge of CS, the device begins to
power up and continues to power up, as long as CS is held low
until after the falling edge of the 10th SCLK. The required
power-up time must elapse before a conversion can be initiated,
as shown in Figure 38. See the Power-Up Times section for the
power-up times associated with the AD7265.
SCLK
CS
DOUTA
DOUTB
INVALID DATA
VALID DATA
110
14
1
THE PART BEGINS
TO POWER UP.
THE PART IS FULLY
POWERED UP; SEE
POWER-UP TIMES
SECTION.
tPOWER-UP1
04674-031
Figure 36. Exiting Partial Power-Down Mode
THREE-STATE
110
14
2
SCLK
CS
DOUTA
DOUTB
THREE-STATE
110
2
INVALID DATA
THE PART BEGINS
TO POWER UP.
THE PART ENTERS
PARTIAL POWER DOWN.
THE PART ENTERS
FULL POWER DOWN.
04674-032
14
Figure 37. Entering Full Power-Down Mode
相關PDF資料 |
PDF描述 |
|---|---|
| D38999/26WE8BN | CONN HSG PLUG 8POS STRGHT SCKT |
| VI-B2V-IW-B1 | CONVERTER MOD DC/DC 5.8V 100W |
| 3182-2SG-315 | CONN PLUG 2POS CABLE SKT |
| VI-B2L-IW-B1 | CONVERTER MOD DC/DC 28V 100W |
| MS3106F22-13S | CONN PLUG 5POS STRAIGHT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7265BSUZ-REEL7 | 功能描述:IC ADC 12BIT 3CHAN 1MSPS 32TQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7266 | 制造商:Analog Devices 功能描述:- Bulk |
| AD7266ACP | 制造商:Analog Devices 功能描述:ADC DUAL SAR 2MSPS 12-BIT SERL 32LFCSP - Bulk |
| AD7266ASU | 制造商:Analog Devices 功能描述:ADC DUAL SAR 2MSPS 12-BIT SERL 32TQFP - Bulk |
| AD7266BCP | 制造商:Analog Devices 功能描述:ADC Dual SAR 2Msps 12-bit Serial 32-Pin LFCSP EP 制造商:Rochester Electronics LLC 功能描述:DUAL, 2 MSPS, 3-CH SIMULTANEOUS SAMPLING ADC - Bulk |
發布緊急采購，3分鐘左右您將得到回復。