- 您現在的位置：買賣IC網 > PDF目錄10281 > AD7193BCPZ-RL7 (Analog Devices Inc)IC ADC 24BIT SPI 4.8KHZ 32LFCSP PDF資料下載
參數資料
| 型號： | AD7193BCPZ-RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 24/57頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 24BIT SPI 4.8KHZ 32LFCSP |
| 標準包裝： | 1,500 |
| 位數： | 24 |
| 采樣率（每秒）： | 4.8k |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-WFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 32-LFCSP-WQ（5x5） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 4 個差分，單極；4 個差分，雙極；8 個偽差分，單極；8 個偽差分，雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁
Data Sheet
AD7193
Rev. D | Page 29 of 56
DATA REGISTER
RS2, RS1, RS0 = 011; Power-On/Reset = 0x000000
The conversion result from the ADC is stored in this data register.
This is a read-only, 24-bit register. Upon completion of a read
operation from this register, the RDY pin/bit is set. When the
DAT_STA bit in the mode register is set to 1, the contents of the
status register are appended to each 24-bit conversion. This is
advisable when several analog input channels are enabled because
the four LSBs of the status register (CHD3 to CHD0) identify
the channel from which the conversion originated.
ID REGISTER
RS2, RS1, RS0 = 100; Power-On/Reset = 0xX2
The identification number for the AD7193 is stored in the ID
register. This is a read-only register.
GPOCON REGISTER
RS2, RS1, RS0 = 101; Power-On/Reset = 0x00
The GPOCON register is an 8-bit register from which data can
be read or to which data can be written. This register is used to
enable the general-purpose digital outputs.
Table 25 outlines the bit designations for the GPOCON register.
GP0 through GP7 indicate the bit locations. GP denotes that the
bits are in the GPOCON register. GP7 denotes the first bit of
the data stream. The number in parentheses indicates the
power-on/reset default status of that bit.
GP7
GP6
GP5
GP4
GP3
GP2
GP1
GP0
0(0)
BPDSW(0)
GP32EN(0)
GP10EN(0)
P3DAT(0)
P2DAT(0)
P1DAT(0)
P0DAT(0)
Table 25. GPOCON Register (GP) Bit Designations
Bit Location
Bit Name
Description
GP7
0
This bit must be programmed with a Logic 0 for proper operation.
GP6
BPDSW
Bridge power-down switch control bit.
This bit is set by the user to close the bridge power-down switch BPDSW to AGND. The switch can sink up
to 30 mA.
The bit is cleared by the user to open the bridge power-down switch. When the ADC is placed in power-
down mode, the bridge power-down switch remains active.
GP5
GP32EN
Digital Output P3 and Digital Output P2 enable.
When GP32EN is set, the P3 and P2 digital outputs are active.
When GP32EN is cleared, the P3 and P2 pins are tristated, and the P3DAT and P2DAT bits are ignored.
GP4
GP10EN
Digital Output P1 and Digital Output P0 enable.
When GP10EN is set, the P1 and P0 digital outputs are active. The P1 and P0 pins can be used as a reference
input to REFIN2 when the REFSEL bit in the configuration register is set to 1.
When GP10EN is cleared, the P1 and P0 outputs are tristated, and the P1DAT and P0DAT bits are ignored.
GP3
P3DAT
Digital Output P3.
When GP32EN is set, the P3DAT bit sets the value of the P3 general-purpose output pin. When P3DAT is
high, the P3 output pin is high.
When P3DAT is low, the P3 output pin is low. When the GPOCON register is read, the P3DAT bit reflects the
status of the P3 pin if GP32EN is set.
GP2
P2DAT
Digital Output P2.
When GP32EN is set, the P2DAT bit sets the value of the P2 general-purpose output pin. When P2DAT is
high, the P2 output pin is high.
When P2DAT is low, the P2 output pin is low. When the GPOCON register is read, the P2DAT bit reflects the
status of the P2 pin if GP32EN is set.
GP1
P1DAT
Digital Output P1.
When GP10EN is set, the P1DAT bit sets the value of the P1 general-purpose output pin. When P1DAT is
high, the P1 output pin is high.
When P1DAT is low, the P1 output pin is low. When the GPOCON register is read, the P1DAT bit reflects the
status of the P1 pin if GP10EN is set.
GP0
P0DAT
Digital Output P0.
When GP10EN is set, the P0DAT bit sets the value of the P0 general-purpose output pin. When P0DAT is
high, the P0 output pin is high.
When P0DAT is low, the P0 output pin is low. When the GPOCON register is read, the P0DAT bit reflects the
status of the P0 pin if GP10EN is set.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-27T-MX-S | CONVERTER MOD DC/DC 6.5V 75W |
| MS27497E10A99SA | CONN RCPT 7POS WALL MNT W/SCKT |
| AD7193BCPZ-RL | IC ADC 24BIT SPI 4.8KHZ 32LFCSP |
| AD7898AR-3REEL7 | IC ADC 12BIT SRL HS 5V 8-SOIC |
| VI-2TW-MX-S | CONVERTER MOD DC/DC 5.5V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7193BRUZ | 功能描述:IC ADC 24BIT SPI 4.8K 28-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| AD7193BRUZ | 制造商:Analog Devices 功能描述:IC ADC 24BIT 4.8KHZ TSSOP-28 |
| AD7193BRUZ-REEL | 功能描述:IC ADC 24BIT SPI 4.8KHZ 28TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7194 | 制造商:AD 制造商全稱:Analog Devices 功能描述:8-Channel, 4.8 kHz, Ultralow Noise, 24-Bit Sigma-Delta ADC with PGA |
| AD7194BCPZ | 功能描述:IC ADC 24BIT SPI 4.8K 32-LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。