- 您現在的位置：買賣IC網 > PDF目錄11674 > AD693AQ (Analog Devices Inc)IC TRANSMITTER 4-20MA 20-CDIP PDF資料下載
參數資料
| 型號： | AD693AQ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 12/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TRANSMITTER 4-20MA 20-CDIP |
| 標準包裝： | 18 |
| 類型： | 信號調節器 |
| 輸入類型： | 電壓 |
| 輸出類型： | 電壓 |
| 接口： | 3 線 |
| 電流 - 電源： | 20mA |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 20-CDIP（0.300"，7.62mm） |
| 供應商設備封裝： | 20-CDIP |
| 包裝： | 管件 |
| 產品目錄頁面： | 798 (CN2011-ZH PDF) |
AD693
REV. A
–9–
Figure 15. Local Powered Operation with 0–20 mA Output
OPTIONAL INPUT FILTERING
Input filtering is recommended for all applications of the
AD693 due to its low input signal range. An RC filter network
at each input of the signal amplifier is sufficient, as shown in
Figure 16. In the case of a resistive signal source it may be
necessary only to add the capacitors, as shown in Figure 18.
The capacitors should be placed as close to the AD693 as
possible. The value of the filter resistors should be kept low to
minimize errors due to input bias current. Choose the 3 dB
point of the filter high enough so as not to compromise the
bandwidth of the desired signal. The RC time constant of the
filter should be matched to preserve the ac common-mode
rejection.
Figure 16. Optional Input Filtering
INTERFACING PLATINUM RTDS
The AD693 has been specially configured to accept inputs from
100
Platinum RTDs (Resistance Temperature Detectors).
Referring to Figure 17, the RTD and the temperature stable
100
resistor form a feedback network around the Auxiliary
Amplifier resulting in a noninverting gain of (1 + RT/100
),
where RT is the temperature dependent resistance of the RTD.
The noninverting input of the Auxiliary Amplifier (Pin 2) is
then driven by the 75 mV signal from the Voltage Divider (Pin
4). When the RTD is at 0, its 100
resistance results in an
amplifier gain of +2 causing VX to be 150 mV. The Signal
Amplifier compares this voltage to the 150 mV output (Pin 3) so
that zero differential signal results. As the temperature (and
therefore, the resistance) of the RTD increases, VX will likewise
increase according to the gain relationship. The difference
between this voltage and the zero degree value of 150 mV drives
the Signal Amp to modulate the loop current. The AD693 is
precalibrated such that the full 4-20mA output span corresponds
to a 0 to 104
°C range in the RTD. (This assumes the European
Standard of
α = 0.00385.) A total of 6 precalibrated ranges for
three-wire (or two-wire) RTDs are available using only the pin
strapping options as shown in Table I.
A variety of other temperature ranges can be realized by using
different application voltages. For example, loading the Voltage
Divider with a 1.5 k
resistor from Pin 3 to Pin 6 (common)
will approximately halve the original application voltages and
allow for a doubling of the range of resistance (and therefore,
temperature) required to fill the two standard spans. Likewise,
Table I. Precalibrated Temperature
Range Options Using a European
Standard 100
RTD and the AD693
Temperature
Range
Pin Connections
0 to + 104
°C
12 to 13
0 to +211
°C
12 to 13, and
15 to 16
+25
°C to +130°C 12 to 14
+51
°C to +266°C 12 to 14, and
15 to 16
–50
°C to +51°C
12 to 11
–100
°C to +104°C 12 to 11 and
15 to 16
Figure 17. 0-to-104
°C Direct Three-Wire 100 RTD lnterface, 4-20mA Output
相關PDF資料 |
PDF描述 |
|---|---|
| VE-J3K-IY-F3 | CONVERTER MOD DC/DC 40V 50W |
| AD9845BJSTZ | IC CCD SIGNAL PROC 12BIT 48-LQFP |
| 3-1478978-1 | CONN JACK SMA 50 OHM R/A PCB |
| AD9949AKCPZ | IC CCD SIGNAL PROCESSOR 40-LFCSP |
| VE-J3K-IY-F2 | CONVERTER MOD DC/DC 40V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD693BQ | 制造商:AD 制造商全稱:Analog Devices 功能描述:Loop-Powered 4a??20 mA Sensor Transmitter |
| AD694 | 制造商:AD 制造商全稱:Analog Devices 功能描述:4.20 mA Transmitter |
| AD694_02 | 制造商:AD 制造商全稱:Analog Devices 功能描述:4a??20 mA Transmitter |
| AD694AQ | 功能描述:IC SGNL COND 4-20MA TX 16-CDIP RoHS:否 類別:集成電路 (IC) >> 接口 - 傳感器和探測器接口 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:74 系列:- 類型:觸控式傳感器 輸入類型:數字 輸出類型:數字 接口:JTAG，串行 電流 - 電源:100µA 安裝類型:表面貼裝 封裝/外殼:20-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:20-TSSOP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。