參數(shù)資料
型號: 935263912551
廠商: NXP SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: 1 CHANNEL(S), 400M bps, SERIAL COMM CONTROLLER, PQFP100
封裝: 14 X 14 MM, 1 MM HEIGHT, PLASTIC, SOT-386-1, TQFP-100
文件頁數(shù): 4/56頁
文件大?。?/td> 277K
代理商: 935263912551
Philips Semiconductors
Preliminary specification
PDI1394L21
1394 full duplex AV link layer controller
2000 Jun 06
12
12.3.5
The CPU bus interface signals
The CPU interface is directly compatible with an 8051 microcontroller. It uses a separate HIF RD_N and HIF WR_N inputs and a HIF CS_N chip
select line, all of which are active LOW. There are 9 address inputs (HIF A0..HIF A8) and 8 data in/out lines HIF D0..HIF D7. An open drain
HIF INT_N output is used to signal interrupts to the CPU.
The CPU is not required to run at a clock that is synchronous to the 1394 base clock. The control signals will be resampled by the host interface
before being used internally.
An access through the host interface starts when HIF CS_N = 0 and either HIF WR_N = 0 or HIF RD_N = 0. Typically the chip select signal is
derived from the upper address lines of the CPU (address decode stage), but it could also be connected to a port pin of the CPU to avoid the
need for an external address decoder in very simple CPU systems. When both HIF CS_N = 0 and HIF RD_N = 0 the host interface will start a
read access cycle, so the cycle is triggered at the falling edge of either HIF CS_N or HIF RD_N, whichever is later.
SV00686
TAS
HIF CS_N
HIF RD_N
HIF WR_N
HIF A0..HIF A7
HIF D0..HIF D7
TAS
TACC
RSRO
RSRn
HIF A8
Figure 4. Read cycle signal timing (2 independent read cycles)
SV00687
TAS
HIF CS_N
HIF RD_N
HIF WR_N
HIF A0..HIF A8
HIF D0..HIF D7
TAS
<WRITE DATA>
<VALID ADDRESS>
Figure 5. Write cycle signal timing (2 independent write cycles)
12.4
The Asynchronous Packet Interface
The PDI1394L21 provides an interface to asynchronous data packets through the registers in the host interface. The format of the
asynchronous packets is specified in the following sections.
12.4.1
Reading an Asynchronous Packet
Upon reception of a packet, the packet data is stored in the appropriate receive FIFO, either the Request or Response FIFO. The location of the
packet is indicated by either the RREQQQAV or RRSPQAV status bit being set in the Asynchronous Interrupt Acknowledge (ASYINTACK)
register. The packet is transferred out of the FIFO by successive reads of the Asynchronous Receive Request (RREQ) or Asynchronous
Receive Response (RRSP) register. The end of the packet (the last quadlet) is indicated by either the RREQQLASTQ or RRSPQLASTQ bit set
in ASYINTACK. Attempting to read the FIFO when either RREQQQAV bit or RRSPQQAV bit is set to 0 (in the Asynchronous RX/TX interrupt
acknowledge (ASYINTACK) register) will result in a queue read error.
相關PDF資料
PDF描述
08-1101-00 DREHSCHALTER 1POL 12STELLUNGEN
08-1260-00 ************GESTRICHEN************
08-1341-00 DREHSCHALTER 3POL 4STELLUNGEN
08-2101-00 DREHSCHALTER 2POL 12STELLUNGEN
08-2261-00 DREHSCHALTER 4POL 6STELLUNGEN
相關代理商/技術參數(shù)
參數(shù)描述
935264217557 制造商:NXP Semiconductors 功能描述:SUB ONLY IC
935267356112 制造商:NXP Semiconductors 功能描述:IC TEA1507PN
935268081112 制造商:NXP Semiconductors 功能描述:SUB ONLY IC
935268721125 制造商:NXP Semiconductors 功能描述:Buffer/Line Driver 1-CH Non-Inverting 3-ST CMOS 5-Pin TSSOP T/R
935269304128 制造商:ST-Ericsson 功能描述:IC AUDIO CODEC W/TCH SCRN 48LQFP