- 您現在的位置：買賣IC網 > PDF目錄3766 > XR16C850CM-F (Exar Corporation)IC UART FIFO 128B 48TQFP PDF資料下載
參數資料
| 型號： | XR16C850CM-F |
| 廠商： | Exar Corporation |
| 文件頁數： | 54/56頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC UART FIFO 128B 48TQFP |
| 標準包裝： | 250 |
| 特點： | * |
| 通道數： | 1，UART |
| FIFO's： | 128 字節 |
| 規程： | RS485 |
| 電源電壓： | 2.97 V ~ 5.5 V |
| 帶自動流量控制功能： | 是 |
| 帶IrDA 編碼器/解碼器： | 是 |
| 帶故障啟動位檢測功能： | 是 |
| 帶調制解調器控制功能： | 是 |
| 帶CMOS： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-TQFP |
| 供應商設備封裝： | 48-TQFP（7x7） |
| 包裝： | 托盤 |
| 其它名稱： | 1016-1658 XR16C850CM-F-ND |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁當前第54頁第55頁第56頁
xr
XR16C850
REV. 2.3.1
2.97V TO 5.5V UART WITH 128-BYTE FIFO
7
Pin type: I=Input, O=Output, I/O= Input/output, OD=Output Open Drain.
Factory Test Mode
For devices with top mark date code of "EC YYWW" and older devices, please note that if IOR# (or IOR) and
IOW# (or IOW) are both asserted simultaneously, the 850 will enter a Factory Test Mode. The most noticeable
Factory Test Mode symptom is the continuous transmission of the same character on the TX pin. This usually
happens during power-up or when another device in the design requires both signals to be asserted
simultaneously (like an SDRAM). A solution to this would be to OR (AND if using active-high signals) the chip
selects with the read and write signals to the XR16C850 as shown below:
For devices with top mark date code of "F2 YYWW" and higher devices, the solution for the Factory Test Mode
given in the figure above has been incorporated into the UART. It will only enter Factory Test Mode when all
three signals (chip select, read and write) are asserted simultaneously.
OP1#/
RS485
38
34
O
Output Port 1 (General purpose output) or RS-485 Direction Control Signal. RS-
485 direction control can be selected when FCTR Bit-3 is set to “1”. During data
transmit cycle, RS485 pin is low. An inverter is usually required before connecting
to RS-485 Transceiver.
RESET
39
35
I
Reset Input (active high). When it is asserted, the UART configuration registers are
reset to default values, see
VCC
44
42
Pwr Power supply input. All inputs are 5V tolerant except for XTAL1 for devices with top
mark date code of "F2 YYWW" and newer. Devices with top mark date code of "EC
YYWW" and older do not have 5V tolerant inputs.
GND
22
18
Pwr Power supply common ground.
NAME
44-PIN
PLCC
48-PIN
TQFP
TYPE
DESCRIPTION
CS2#
IOR#
IOW#
CS0 or CS1
IOR
IOW
(Active Low Signals)
(Active High Signals)
CS#
IOR#
IOW#
CS
IOR
IOW
(from CPU
or PLD)
(from CPU
or PLD)
XR16C850
相關PDF資料 |
PDF描述 |
|---|---|
| XR16L2750IM-F | IC UART FIFO 64B DUAL 48TQFP |
| ST16C2550CQ48-F | IC DUART FIFO 16B 48TQFP |
| XR88C681CP/40-F | IC UART CMOS DUAL 40PDIP |
| AT89C51RB2-RLRIM | IC MCU FLASH 8051 16K 5V 44-VQFP |
| XR16V2550IM-F | IC UART FIFO 16B 48TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XR16C850CMTR-F | 功能描述:UART 接口集成電路 UART w/128 Bytes FIFO & IrDA RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR16C850CP | 制造商:EXAR 制造商全稱:EXAR 功能描述:UART with 128-byte FIFO’s FIFO Counters and Half-duplex Control |
| XR16C850CQ | 制造商:EXAR 制造商全稱:EXAR 功能描述:UART with 128-byte FIFO’s FIFO Counters and Half-duplex Control |
| XR16C850IJ | 制造商:EXAR 制造商全稱:EXAR 功能描述:2.97V TO 5.5V UART WITH 128-BYTE FIFO |
| XR16C850IJ-F | 功能描述:UART 接口集成電路 UARTW/128BYTE FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。