- 您現在的位置：買賣IC網 > PDF目錄372715 > XC61FN3852ML (TOREX SEMICONDUCTOR LTD.) Voltage Detectors ( Delay Circuit Built-In) PDF資料下載
參數資料
| 型號： | XC61FN3852ML |
| 廠商： | TOREX SEMICONDUCTOR LTD. |
| 英文描述： | Voltage Detectors ( Delay Circuit Built-In) |
| 中文描述： | 電壓檢測器（延遲電路內置） |
| 文件頁數： | 8/12頁 |
| 文件大?。?/td> | 204K |
| 代理商： | XC61FN3852ML |
164
2
G
Notes on Use
1. Oscillation
(1) Oscillation as a result of output current with the CMOS output configuration :
When the voltage applied at IN rises, release operations commence and the detector's output voltage increases. Load
current (I
OUT
) will flow through R
L
. Because a voltage drop ( R
IN
x I
OUT
) is produced at the R
IN
resistor, located between
the input (IN) and the V
IN
pin, the load current will flow via the IC's V
IN
pin. The voltage drop will also lead to a fall in the
voltage level at the V
IN
pin. When the V
IN
pin voltage level falls below the detect voltage level, detect operations will
commence. Following detect operations, load current flow will cease and since voltage drop at R
IN
will disappear, the
voltage level at the V
IN
pin will rise and release operations will begin over again.
Oscillation may occur with this " release - detect - release " repetition.
Further, this condition will also appear via means of a similar mechanism during detect operations.
(2) Oscillation as a result of through current :
Since the XC61F series are CMOS IC
S
, through current will flow when the IC's internal circuit switching operates ( during
release and detect operations ). Consequently, oscillation is liable to occur during release voltage operations as a result
of output current which is influenced by this through current ( Diagram 3 ).
Since hysteresis exists during detect operations, oscillation is unlikely to occur.
1.
2.
Please use this IC within the stated maximum ratings. The IC is liable to malfunction should the ratings be exceeded.
When a resistor is connected between the V
IN
pin and the input with CMOS output configurations, oscillation may occur
as a result of voltage drops at R
IN
if load current (I
OUT
) exists.
It is therefore recommend that no resistor be added. ( refer to N.B. 1 - (1) below )
When a resistor is connected between the V
IN
pin and the input with CMOS output configurations, irrespective of N-ch
output configurations, oscillation may occur as a result of through current at the time of voltage release even if load
current (I
OUT
) does not exist. ( refer to N.B. 1 - (2) below )
With a resistor connected between the V
IN
pin and the input, detect and release voltage will rise as a result of the IC's
supply current flowing through the V
IN
pin.
If a resistor (R
IN
) must be used, then please use with as small a level of input impedance as possible in order to control
the occurences of oscillation as described above.
Further, please ensure that R
IN
is less than 10k
3.
4.
5.
μ
IN
G
N.B.
相關PDF資料 |
PDF描述 |
|---|---|
| XC61FN3852MR | Voltage Detectors ( Delay Circuit Built-In) |
| XC61FN3852PB | Voltage Detectors ( Delay Circuit Built-In) |
| XC61FN3852PH | Voltage Detectors ( Delay Circuit Built-In) |
| XC61FC2512LB | Voltage Detectors ( Delay Circuit Built-In) |
| XC61FC2512LH | Voltage Detectors ( Delay Circuit Built-In) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XC61FN4212MRN | 制造商:Torex Semiconductor LTD 功能描述: |
| XC61FN4412MRN | 制造商:Torex Semiconductor LTD 功能描述: |
| XC61FN4512MR | 制造商:Torex Semiconductor LTD 功能描述:VOLT DETECTOR NCH 4.5V SOT-23-3 制造商:Torex Semiconductor LTD 功能描述:VOLT DETECTOR NCH 4.5V, SOT-23-3 |
| XC61FN4512MRN | 制造商:Torex Semiconductor LTD 功能描述: |
| XC61FN6012MR-G | 功能描述:VOLTAGE DETECTOR, XC61FN SERIES RoHS:是 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:3,000 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:推挽式，圖騰柱 復位:高有效 復位超時:最小為 100 ms 電壓 - 閥值:3.06V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:SC-70，SOT-323 供應商設備封裝:SC-70-3 包裝:帶卷 (TR) 其它名稱:ADM1817-5AKSREEL7 |
發布緊急采購，3分鐘左右您將得到回復。