- 您現在的位置：買賣IC網 > PDF目錄231493 > WE128K32P-300H1CA 128K X 32 EEPROM 5V MODULE, 300 ns, CPGA66 PDF資料下載
參數資料
| 型號： | WE128K32P-300H1CA |
| 元件分類： | PROM |
| 英文描述： | 128K X 32 EEPROM 5V MODULE, 300 ns, CPGA66 |
| 封裝： | CERAMIC, HIP-66 |
| 文件頁數： | 2/15頁 |
| 文件大小： | 296K |
| 代理商： | WE128K32P-300H1CA |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁
10
White Electronic Designs Corporation (602) 437-1520 www.whiteedc.com
WE128K32-XXX
HARDWARE DATA PROTECTION
These features protect against inadvertent writes to the
WE128K32-XXX. These are included to improve reliability
during normal operation:
a) VCC power on delay
As VCC climbs past 3.8V typical the device will wait 5msec
typical before allowing write cycles.
b) VCC sense
While below 3.8V typical write cycles are inhibited.
c) Write inhibiting
Holding OE low and either CS or WE high inhibits write
cycles.
d) Noise filter
Pulses of <8ns (typ) on WE or CS will not initiate a write
cycle.
SOFTWARE DATA PROTECTION
A software write protection feature may be enabled or disabled
by the user. When shipped by White Microelectronics, the WE-
128K32-XXX has the feature disabled. Write access to the
device is unrestricted.
To enable software write protection, the user writes three
access code bytes to three special internal locations. Once
write protection has been enabled, each write to the EEPROM
must use the same three byte write sequence to permit writing.
After setting software data protection, any attempt to write to
the device without the three-byte command sequence will start
the internal write timers. No data will be written to the device,
however, for the duration of tWC. The write protection feature
can be disabled by a six byte write sequence of specific data to
specific locations. Power transitions will not reset the
software write protection.
Each 128K byte block of the EEPROM has independent write
protection. One or more blocks may be enabled and the rest
disabled in any combination. The software write protection
guards against inadvertent writes during power transitions, or
unauthorized modification using a PROM programmer.
FIG. 11
SOFTWARE DATA PROTECTION
DISABLE ALGORITHM(1)
EXIT DATA
PROTECT STATE
NOTES:
1. Data Format: D7 - D0 (Hex);
Address Format: A16 - A0 (Hex).
2. Write Protect state will be activated at end of write even if no other
data is loaded.
3. Write Protect state will be deactivated at end of write period even if
no other data is loaded.
4. 1 to 128 bytes of data may be loaded.
(3)
LOAD DATA AA
TO
ADDRESS 5555
LOAD DATA 55
TO
ADDRESS 2AAA
LOAD DATA 80
TO
ADDRESS 5555
LOAD DATA AA
TO
ADDRESS 5555
LOAD DATA 55
TO
ADDRESS 2AAA
LOAD DATA 20
TO
ADDRESS 5555
LOAD DATA XX
TO
ANY ADDRESS(4)
LOAD LAST BYTE
TO
LAST ADDRESS
相關PDF資料 |
PDF描述 |
|---|---|
| WE128K32P-250H1M | 128K X 32 EEPROM 5V MODULE, 250 ns, CPGA66 |
| WMS256K16L-35FLI | 256K X 16 STANDARD SRAM, 35 ns, CDFP44 |
| WMS256K16L-17FLCA | 256K X 16 STANDARD SRAM, 17 ns, CDFP44 |
| WMS256K16-20FLM | 256K X 16 STANDARD SRAM, 20 ns, CDFP44 |
| WE32K32-90G1UMA | 32K X 32 EEPROM 5V MODULE, 90 ns, CQFP68 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| WE128K32P-300H1I | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:x32 EEPROM Module |
| WE128K32P-300H1IA | 制造商:WEDC 制造商全稱:White Electronic Designs Corporation 功能描述:128Kx32 EEPROM MODULE, SMD 5962-94585 |
| WE128K32P-300H1M | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:x32 EEPROM Module |
| WE128K32P-300H1MA | 制造商:WEDC 制造商全稱:White Electronic Designs Corporation 功能描述:128Kx32 EEPROM MODULE, SMD 5962-94585 |
| WE128K32P-300H1Q | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:x32 EEPROM Module |
發布緊急采購，3分鐘左右您將得到回復。