- 您現在的位置：買賣IC網 > PDF目錄225472 > USB2601-NU-04 (STANDARD MICROSYSTEMS CORP) PDF資料下載
參數資料
| 型號： | USB2601-NU-04 |
| 廠商： | STANDARD MICROSYSTEMS CORP |
| 元件分類： | 存儲控制器/管理單元 |
| 中文描述： | FLASH MEMORY DRIVE CONTROLLER, PQFP128 |
| 封裝： | 14 X 14 MM, 1 MM HEIGHT, GREEN, TQFP-128 |
| 文件頁數： | 8/26頁 |
| 文件大?。?/td> | 421K |
| 代理商： | USB2601-NU-04 |
4th Generation USB2.0 Flash Media Controller with Integrated Card Power FETs and HS Hub
Datasheet
Revision 1.5 (07-24-06)
16
SMSC USB2601/USB2602
DATASHEET
CF
IO Read
CF_nIOR
O8
This pin is an active low read strobe signal for CF
device.
CF
IO Write Strobe
CF_nIOW
O8
This pin is an active low write strobe signal for CF
device.
SmartMedia INTERFACE
SM
Write Protect
SM_nWP
O8PD
This pin is an active low write protect signal for the SM
device.
This pin has a weak pull-down resistor that is
permanently enabled
SM
Address Strobe
SM_ALE
O8PD
This pin is an active high Address Latch Enable signal
for the SM device.
This pin has a weak pull-down resistor that is
permanently enabled
SM
Command Strobe
SM_CLE
O8PD
This pin is an active high Command Latch Enable signal
for the SM device.
This pin has a weak pull-down resistor that is
permanently enabled
SM
Data7-0
SM_D[7:0]
I/O8PD
These pins are the bi-directional data signal SM_D7-
SM_D0.
The bi-directional data signal has an internal weak pull-
down resistor.
SM
Read Enable
SM_nRE
08PU
This pin is an active low read strobe signal for SM
device.
When using the internal FET, this pin has an internal
weak pull-up resistor that is tied to the output of the
internal Power FET.
08
If an external FET is used (Internal FET is disabled),
then the internal pull-up is not available (external pull-
ups must be used, and should be connected to the
applicable Card Power Supply).
SM
Write Enable
SM_nWE
O8PU
This pin is an active low write strobe signal for SM
device.
When using the internal FET, this pin has an internal
weak pull-up resistor that is tied to the output of the
internal Power FET.
08
If an external FET is used (Internal FET is disabled),
then the internal pull-up is not available (external pull-
ups must be used, and should be connected to the
applicable Card Power Supply).
SM
Write Protect Switch
SM_nWPS
IPU
A write-protect seal is detected, when this pin is low.
This pin has an internally controlled weak pull-up
resistor.
SM
Busy or Data Ready
SM_nB/R
I
This pin is connected to the BSY/RDY pin of the SM
device.
An external pull-up resistor is required on this signal.
The pull-up resistor must be pulled up to the same
power source that powers the SM/NAND flash device.
NAME
SYMBOL
BUFFER
TYPE
DESCRIPTION
相關PDF資料 |
PDF描述 |
|---|---|
| USB3315-CP-TR | |
| USB3329C-GL-TR | |
| USB3321C-GL-TR | |
| USC-RCM5-J-006 | 50/125 um, MULTI MODE, SIMPLEX SC CONNECTOR |
| NSC-09DS-J-006 | MULTI MODE, SIMPLEX SC CONNECTOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| USB2601-NU-05 | 功能描述:USB 接口集成電路 USB2.0 FLASH MEDIA CONTROLLER W/FET HS RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| USB2601-NU-06 | 功能描述:USB 接口集成電路 USB 2.0 Flash Media Cntrlr and 4Port Hub RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| USB2601-NU-XX | 制造商:SMSC 制造商全稱:SMSC 功能描述:4th Generation USB2.0 Flash Media Controller with Integrated Card Power FETs and HS Hub |
| USB2602 | 制造商:SMSC 制造商全稱:SMSC 功能描述:4th Generation USB2.0 Flash Media Controller with Integrated Card Power FETs and HS Hub |
| USB2602-NE-02 | 功能描述:USB 接口集成電路 USB 2.0 Flash Media 4-PORT HUB RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
發布緊急采購，3分鐘左右您將得到回復。