參數資料
型號: USB20H04
廠商: SMSC Corporation
英文描述: 4-PORT USB2.0 HUB CONTROLLER
中文描述: 4端口USB2.0集線器控制器
文件頁數: 21/38頁
文件大小: 919K
代理商: USB20H04
4-Port USB2.0 Controller
Datasheet
SMSC USB20H04
Page 21
Revision 1.63 (10-14-04)
DATASHEET
7.9
Transaction Translator (TT)
The transaction translator supports full-speed and low-speed devices attached to downstream ports in the
high-speed environment. To provide the highest level of performance, the USB20H04 Hub provides one
Transaction Translator (TT) per port (defined as multiple-TT).
7.10 Port Controller
The port controller provides status and control of individual downstream ports. Any port status change is
reported to the host via the hub status change (interrupt) endpoint.
7.11 Downstream PHY
Each of the downstream PHYs include a transmitter and receiver that operate in high-speed, full-speed or
low-speed mode, depending on the attached device. The required termination resistors are internal to the
USB20H04.
7.12 OC Sense/Switch Driver
One output per port is provided to control an external port power switch and one input per port is provided
to sense an external over-current sense. Both ganged and individual (per-port) configurations are
supported. See Figure 10.1 - High Level Block Diagram of a Self-Powered Hub for a typical
implementation.
7.12.1 Over-Current Sense
An external device monitors the current being provided to attached peripherals, and generates an output
during over-current conditions. This output is connected to the OCSx_N input of the USB20H04. This input
pin has an internal pull up resistor.
This input is filtered by the USB20H04 for the amount of time configured in the Over-Current Timer field
(See Table 8.4 - Address 8; Config_Byte_1) If the input continues to be asserted beyond the configured
time, the USB20H04 reports the over-current condition to the host and disables the power switch output
associated with that particular port. For use with typical silicon-based power controllers, configure the timer
to a value greater than zero to avoid glitches when devices are attached.
7.12.2 Switch Driver
Power to downstream ports is controlled by the VBUSx_N (where x stands for the port number) output
connected to an external power switch device. This output may be disabled when an over-current
condition has been reported, as described in Section 7.12.1.
7.13 LED Drivers
As per the specification, each downstream port of the hub supports an optional status indicator. The
USB20H04 provides one output per port for a green LED and one output per port for an amber LED.
相關PDF資料
PDF描述
USB2223-03 BUS POWERED USB 2.0 FLASH MEDIA CONTROLLER
USB2223-NE-03 BUS POWERED USB 2.0 FLASH MEDIA CONTROLLER
USB2223-NU-03 BUS POWERED USB 2.0 FLASH MEDIA CONTROLLER
USB2229 5TH GENERATION HI-SPEED USB FLASH MEDIA & IrDA CONTROLLER WITH INTEGRATED CARD POWER FETs
USB2229-NE-03 5TH GENERATION HI-SPEED USB FLASH MEDIA & IrDA CONTROLLER WITH INTEGRATED CARD POWER FETs
相關代理商/技術參數
參數描述
USB20H04-JD 制造商:SMSC 功能描述:LAN HUB CONTROLLER, 64 Pin, QFP
USB20H04-JT 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel
USB20H04-JT-E6 制造商:Rochester Electronics LLC 功能描述:- Bulk
USB20X2GY 制造商:Hubbell Wiring Device-Kellems 功能描述:Hubbell USB20X2GY NEMA 5-15R AC Duplex Receptacle w/2USB Ports - Gray 20 amp 制造商:Hubbell Wiring Device-Kellems 功能描述:USB CHARGER RECEPTACLE, 20A, 125VAC, GREY; Connector Type:Electrical AC Receptacle, USB Charger; Series:-; Current Rating:20A; Connector Color:Grey; Connector Body Material:-; Voltage Rating VAC:125V
USB20X2I 制造商:Hubbell Wiring Device-Kellems 功能描述:Hubbell USB20X2I NEMA 5-15R AC Duplex Receptacle w/2USB Ports - Ivory 20 amp 制造商:Hubbell Premise Wiring 功能描述:USB CHARGER RECEPTACLE 20A 1 制造商:Hubbell Wiring Device-Kellems 功能描述:USB CHARGER RECEPTACLE, 20A, 125VAC, IVO 制造商:Hubbell Wiring Device-Kellems 功能描述:USB CHARGER RECEPTACLE, 20A, 125VAC, IVORY; Connector Type:Electrical AC Receptacle, USB Charger; Series:-; Current Rating:20A; Connector Color:Ivory; Connector Body Material:-; Voltage Rating VAC:125V