• <dfn id="qi9lt"><pre id="qi9lt"><strong id="qi9lt"></strong></pre></dfn>
    <var id="qi9lt"><tbody id="qi9lt"></tbody></var>
    <dfn id="qi9lt"><pre id="qi9lt"></pre></dfn>
  • <thead id="qi9lt"></thead>
    <thead id="qi9lt"><delect id="qi9lt"></delect></thead>
  • <li id="qi9lt"></li>
    參數資料
    型號: TS87C51RD2-LIB
    廠商: International Rectifier
    英文描述: High Performance 8-bit Microcontroller
    中文描述: 高性能8位微控制器
    文件頁數: 44/85頁
    文件大?。?/td> 762K
    代理商: TS87C51RD2-LIB
    44
    4188E–8051–08/06
    AT/TS8xC51Rx2
    6.6
    Idle Mode
    An instruction that sets PCON.0 causes that to be the last instruction executed before going into
    the Idle mode. In the Idle mode, the internal clock signal is gated off to the CPU, but not to the
    interrupt, Timer, and Serial Port functions. The CPU status is preserved in its entirety: the Stack
    Pointer, Program Counter, Program Status Word, Accumulator and all other registers maintain
    their data during Idle. The port pins hold the logical states they had at the time Idle was acti-
    vated. ALE and PSEN hold at logic high levels.
    There are two ways to terminate the Idle. Activation of any enabled interrupt will cause PCON.0
    to be cleared by hardware, terminating the Idle mode. The interrupt will be serviced, and follow-
    ing RETI the next instruction to be executed will be the one following the instruction that put the
    device into idle.
    The flag bits GF0 and GF1 can be used to give an indication if an interrupt occured during nor-
    mal operation or during an Idle. For example, an instruction that activates Idle can also set one
    or both flag bits. When Idle is terminated by an interrupt, the interrupt service routine can exam-
    ine the flag bits.
    The other way of terminating the Idle mode is with a hardware reset. Since the clock oscillator is
    still running, the hardware reset needs to be held active for only two machine cycles (24 oscilla-
    tor periods) to complete the reset.
    6.7
    Power-down Mode
    To save maximum power, a power-down mode can be invoked by software (Refer to
    Table 6-15
    ,
    PCON register).
    In power-down mode, the oscillator is stopped and the instruction that invoked power-down
    mode is the last instruction executed. The internal RAM and SFRs retain their value until the
    power-down mode is terminated. V
    CC
    can be lowered to save further power. Either a hardware
    reset or an external interrupt can cause an exit from power-down. To properly terminate power-
    down, the reset or external interrupt should not be executed before V
    CC
    is restored to its normal
    operating level and must be held active long enough for the oscillator to restart and stabilize.
    Only external interrupts INT0 and INT1 are useful to exit from power-down. For that, interrupt
    must be enabled and configured as level or edge sensitive interrupt input.
    Holding the pin low restarts the oscillator but bringing the pin high completes the exit as detailed
    in Figure 6-14. When both interrupts are enabled, the oscillator restarts as soon as one of the
    two inputs is held low and power down exit will be completed when the first input will be
    released. In this case the higher priority interrupt service routine is executed.
    Once the interrupt is serviced, the next instruction to be executed after RETI will be the one fol-
    lowing the instruction that put TS80C51Rx2 into power-down mode.
    相關PDF資料
    PDF描述
    TS87C51RD2-LIE High Performance 8-bit Microcontroller
    TS87C51RD2-MCA High Performance 8-bit Microcontroller
    TS87C51RD2-MCB High Performance 8-bit Microcontroller
    TS87C51RD2-MCE High Performance 8-bit Microcontroller
    TS80C51RA2-LCE High Performance 8-bit Microcontroller
    相關代理商/技術參數
    參數描述
    TS87C51RD2-LIBB 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
    TS87C51RD2-LIBD 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
    TS87C51RD2-LIBR 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
    TS87C51RD2-LIE 功能描述:IC MCU 8BIT 64K OTP 30MHZ 44VQFP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:87C 標準包裝:1,500 系列:AVR® ATtiny 核心處理器:AVR 芯體尺寸:8-位 速度:16MHz 連通性:I²C,LIN,SPI,UART/USART,USI 外圍設備:欠壓檢測/復位,POR,PWM,溫度傳感器,WDT 輸入/輸出數:16 程序存儲器容量:8KB(4K x 16) 程序存儲器類型:閃存 EEPROM 大小:512 x 8 RAM 容量:512 x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 11x10b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 包裝:帶卷 (TR)
    TS87C51RD2-LIEB 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller