參數(shù)資料
型號: TS4961TIQT
廠商: STMICROELECTRONICS
元件分類: 音頻/視頻放大
英文描述: 1.5 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC16
封裝: 3 X 3 MM, ROHS COMPLIANT, QFN-16
文件頁數(shù): 31/49頁
文件大?。?/td> 1351K
代理商: TS4961TIQT
TS4961T
Application component information
37/49
4.2
Low frequency response
If a low frequency bandwidth limitation is required, it is possible to use input coupling
capacitors.
In the low frequency region, Cin (input coupling capacitor) starts to have an effect. Cin forms,
with Rin, a first order high-pass filter with a -3 dB cut-off frequency:
Therefore, for a desired cut-off frequency FCL, Cin is calculated as follows:
with Rin in Ω and FCL in Hz.
4.3
Decoupling of the circuit
A power supply capacitor, referred to as CS, is necessary to correctly bypass the class D
part of the TS4961T.
The TS4961T has a typical switching frequency at 250 kHz and an output fall and rise time
at approximately 5 ns. Because of these very fast transients, careful decoupling is
mandatory.
A 1 F ceramic capacitor is enough, but it must be located very close to the TS4961T in
order to avoid any extra parasitic inductance created by a long track wire. In relation with
dI/dt, this parasitic inductance introduces an overvoltage that decreases the global
efficiency and, if it is too high, may cause a breakdown of the device.
In addition, even if a ceramic capacitor has an adequate high frequency ESR value, its
current capability is also important. A 0603 size is a good compromise, particularly when a
4
Ω load is used.
Another important parameter is the rated voltage of the capacitor. A 1 F/6.3 V capacitor
used at 5 V, loses about 50% of its value. In fact, with a 5 V power supply voltage, the
decoupling value is about 0.5 F instead of 1 F. Since CS has a particular influence on the
THD+N in the medium-high frequency region, this capacitor variation becomes decisive. In
addition, less decoupling means higher overshoots, which can be problematic if they reach
the power supply AMR value (6 V).
4.4
Wake-up time (tWU)
There is a wait of approximately 5 ms when standby is released to set the device ON. The
TS4961T has an internal digital delay that mutes the outputs and releases them after this
time in order to avoid any pop noise.
F
CL
1
2
π R
in
×
C
in
×
--------------------------------------
(Hz)
=
C
in
1
2
π R
in
×
F
CL
×
----------------------------------------
(F)
=
相關PDF資料
PDF描述
TS4962EIJT 3 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9
TS4962EIKJT 3 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9
TS4962EKIJT 3 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9
TS4962IJT 3 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9
TS4962IQT 2.8 W, 1 CHANNEL, AUDIO AMPLIFIER, DSO8
相關代理商/技術參數(shù)
參數(shù)描述
TS4962 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2.8W filter-free mono class D audio power amplifier
TS4962_07 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2.8W filter-free mono class D audio power amplifier
TS4962_10 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2.8 W filter-free mono class D audio power amplifier
TS4962EIJT 制造商:STMicroelectronics 功能描述:AUD AMP SPKR 1CH MONO 2W CLS-D 9PIN FLIP-CHIP - Tape and Reel
TS4962EKIJT 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:3W Filter-free Class D Audio Power Amplifier