參數資料
型號: TS1871IAIYDT
廠商: STMICROELECTRONICS
元件分類: 運算放大器
英文描述: OP-AMP, 1500 uV OFFSET-MAX, 1.6 MHz BAND WIDTH, PDSO8
封裝: LEAD FREE, SOP-8
文件頁數: 20/26頁
文件大?。?/td> 434K
代理商: TS1871IAIYDT
TS1871-TS1872-TS1874
Absolute maximum ratings and operating conditions
3/26
1
Absolute maximum ratings and operating conditions
Table 1.
Absolute maximum ratings
Symbol
Parameter
Value
Unit
VCC
Supply voltage(1)
7V
Vid
Differential input voltage(2)
±1
V
Vin
Input voltage
VDD -0.3 to VCC +0.3
V
Tstg
Storage temperature
-65 to +150
°C
Tj
Maximum junction temperature
150
°C
Rthja
Thermal resistance junction to ambient (3)
SOT23-5
DIP8
DIP14
MiniSO-8
SO-8
SO-14
TSSOP8
TSSOP14
250
85
66
190
125
103
120
100
°C/W
Rthjc
Thermal resistance junction to case
SOT23-5
DIP8
DIP14
MiniSO-8
SO-8
SO-14
TSSOP8
TSSOP14
81
41
33
39
40
31
37
32
°C/W
ESD
HBM: human body model(4)
MM: machine model(5)
CDM: charged device model(6)
2
200
1.5
kV
V
kV
Latch-up immunity
200
mA
Lead temperature (soldering, 10 sec)
250
°C
Output short-circuit duration
see note(7)
1.
All voltage values, except differential voltage are with respect to network terminal.
2.
Differential voltages are the non-inverting input terminal with respect to the inverting input terminal. If Vid > ±1V, the
maximum input current must not exceed ±1mA. When Vid > ±1V, add an input series resistor to limit input current.
3.
Short-circuits can cause excessive heating. Destructive dissipation can result from simultaneous short-circuits on all
amplifiers.
4.
Human body model: A 100pF capacitor is charged to the specified voltage, then discharged through a 1.5k
Ω resistor
between two pins of the device. This is done for all couples of connected pin combinations while the other pins are floating.
5.
Machine model: A 200pF capacitor is charged to the specified voltage, then discharged directly between two pins of the
device with no external series resistor (internal resistor < 5
Ω). This is done for all couples of connected pin combinations
while the other pins are floating.
6.
Charged device model: all pins and the package are charged together to the specified voltage and then discharged directly
to the ground through only one pin. This is done for all pins.
7.
Short-circuits from the output to VCC can cause excessive heating. The maximum output current is approximately 80mA,
independent of the magnitude of VCC. Destructive dissipation can result from simultaneous short-circuits on all amplifiers.
相關PDF資料
PDF描述
TS1871IAIYD OP-AMP, 1500 uV OFFSET-MAX, 1.6 MHz BAND WIDTH, PDSO8
TS1871IYDT OP-AMP, 6000 uV OFFSET-MAX, 1.6 MHz BAND WIDTH, PDSO8
TS1871IYD OP-AMP, 6000 uV OFFSET-MAX, 1.6 MHz BAND WIDTH, PDSO8
TS1935CX5RF SWITCHING REGULATOR, 1850 kHz SWITCHING FREQ-MAX, PDSO5
TS3V555AID PULSE, 2 MHz, TIMER, PDSO8
相關代理商/技術參數
參數描述
TS1871ID 功能描述:運算放大器 - 運放 Single Rail-to-Rail RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
TS1871IDT 功能描述:運算放大器 - 運放 Single Rail-to-Rail RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
TS1871ILT 功能描述:運算放大器 - 運放 Single Rail-to-Rail RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
TS1871IYD 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:1.8V input/output rail-to-rail low power operational amplifiers
TS1871IYDT 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:1.8V input/output rail-to-rail low power operational amplifiers