- 您現在的位置：買賣IC網 > PDF目錄383964 > TPS71025PW (Texas Instruments, Inc.) LOW-DROPOUT VOLTAGE REGULATOR PDF資料下載
參數資料
| 型號： | TPS71025PW |
| 廠商： | Texas Instruments, Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | LOW-DROPOUT VOLTAGE REGULATOR |
| 中文描述： | 低壓差穩壓器 |
| 文件頁數： | 15/20頁 |
| 文件大小： | 308K |
| 代理商： | TPS71025PW |
TPS71025
LOW-DROPOUT VOLTAGE REGULATOR
SLVS162A – MAY 1997 – REVISED MAY 1998
15
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
external capacitor requirements
An input capacitor is not required; however, a ceramic bypass capacitor (0.047 pF to 0.1
μ
F) improves load
transient response and noise rejection if the TPS71025 is located more than a few inches from the power supply.
A higher-capacitance electrolytic capacitor may be necessary if large (hundreds of milliamps) load transients
with fast rise times are anticipated.
As with most LDO regulators, the TPS71025 requires an output capacitor for stability. A low-ESR 10-
μ
F
solid-tantalum capacitor connected from the regulator output to ground is sufficient to ensure stability over the
full load range (see Figure 11). Adding high-frequency ceramic or film capacitors (such as power-supply bypass
capacitors for digital or analog ICs) can cause the regulator to become unstable unless the ESR of the tantalum
capacitor is less than 1.2
over temperature. Capacitors with published ESR specifications such as the
AVX TPSD106K035R0300 and the Sprague 593D106X0035D2W work well because the maximum ESR at
25
°
C is 300 m
(typically, the ESR in solid-tantalum capacitors increases by a factor of 2 or less when the
temperature drops from 25
°
C to –40
°
C). Where component height and/or mounting area is a problem,
physically smaller, 10-
μ
F devices can be screened for ESR. Figure 7 through Figure 14 show the stable regions
of operation using different values of output capacitance with various values of ceramic load capacitance.
In applications with little or no high-frequency bypass capacitance (< 0.2
μ
F), the output capacitance can be
reduced to 4.7
μ
F, provided ESR is maintained between 0.7 and 2.5
. Because minimum capacitor ESR is
seldom if ever specified, it may be necessary to add a 0.5-
to 1-
resistor in series with the capacitor and limit
ESR to 1.5
maximum. As shown in the ESR graphs (Figure 7 through Figure 14), minimum ESR is not a
problem when using 10-
μ
F or larger output capacitors.
Below is a partial listing of surface-mount capacitors usable with the TPS71025. This information (along with
the ESR graphs, Figure 7 through Figure 14) is included to assist in selection of suitable capacitance for the
application. When necessary to achieve low height requirements along with high output current and/or high
ceramic load capacitance, several higher ESR capacitors can be used in parallel to meet the guidelines above.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS71025Y | LOW-DROPOUT VOLTAGE REGULATOR |
| TPS715 | 50 mA, 24 V, 3.2 uA Supply Current Low-Dropout Linear Regulator |
| TPS728XX | 200mA Low-Dropout Linear Regulator with Pin-Selectable Dual-Voltage Level Output |
| TPS75315Q | FAST-TRANSIENT-RESPONSE 1.5-A LOW-DROPOUT VOLTAGE REGULATORS |
| TPS75318Q | FAST-TRANSIENT-RESPONSE 1.5-A LOW-DROPOUT VOLTAGE REGULATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS71025PWR | 功能描述:低壓差穩壓器 - LDO LDO Reg RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS71025PWRG4 | 功能描述:低壓差穩壓器 - LDO LDO Reg RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS71025Y | 制造商:TI 制造商全稱:Texas Instruments 功能描述:LOW-DROPOUT VOLTAGE REGULATOR |
| TPS71202 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SYNCHRONOUS SEPIC / FLYBACK CONVERTER WITH 1.1A SWITCH AND INTEGRATED LDO |
| TPS71202DRCR | 功能描述:低壓差穩壓器 - LDO Dual 250 mA Output UltraLow Noise RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。