- 您現在的位置：買賣IC網 > PDF目錄98284 > TPS62291TDRVRQ1 (TEXAS INSTRUMENTS INC) 1 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO6 PDF資料下載
參數資料
| 型號： | TPS62291TDRVRQ1 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 1 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO6 |
| 封裝： | 2 X 2 MM, 0.8 MM HEIGHT, GREEN, PLASTIC, SON-6 |
| 文件頁數： | 7/25頁 |
| 文件大?。?/td> | 817K |
| 代理商： | TPS62291TDRVRQ1 |
V
OUT + VREF
1 )
R
1
R
2
DIL + VOUT
1 *
V
OUT
V
IN
L
f
I
L max + Iout max )
DIL
2
www.ti.com
SLVSAI5 – SEPTEMBER 2010
OUTPUT VOLTAGE SETTING
The output voltage can be calculated to:
with an internal reference voltage VREF typical 0.6V.
To minimize the current through the feedback divider network, R2 should be 180 k or 360 k. The sum of R1
and R2 should not exceed ~1M, to keep the network robust against noise. An external feed forward capacitor
C1 is required for optimum load transient response. The value of C1 should be in the range between 22pF and
33pF.
Route the FB line away from noise sources, such as the inductor or the SW line.
OUTPUT FILTER DESIGN (INDUCTOR AND OUTPUT CAPACITOR)
The TPS6229x-Q1 is designed to operate with inductors in the range of 1.5mH to 4.7mH and with output
capacitors in the range of 4.7mF to 22mF. The part is optimized for operation with a 2.2mH inductor and 10mF
output capacitor. Larger or smaller inductor values can be used to optimize the performance of the device for
specific operation conditions. For stable operation, the L and C values of the output filter may not fall below 1mH
effective inductance and 3.5mF effective capacitance.
Inductor Selection
The inductor value has a direct effect on the ripple current. The selected inductor has to be rated for its dc
resistance and saturation current. The inductor ripple current (
ΔIL) decreases with higher inductance and
increases with higher VI or VO.
The inductor selection has also impact on the output voltage ripple in PFM mode. Higher inductor values will lead
to lower output voltage ripple and higher PFM frequency, lower inductor values will lead to a higher output
voltage ripple but lower PFM frequency.
Equation 1 calculates the maximum inductor current under static load conditions. The saturation current of the
inductor should be rated higher than the maximum inductor current as calculated with Equation 2. This is
recommended because during heavy load transient the inductor current will rise above the calculated value.
(1)
(2)
With:
f = Switching Frequency (2.25MHz typical)
L = Inductor Value
ΔIL = Peak to Peak inductor ripple current
ILmax = Maximum Inductor current
A more conservative approach is to select the inductor current rating just for the maximum switch current of the
corresponding converter.
Accepting larger values of ripple current allows the use of low inductance values, but results in higher output
voltage ripple, greater core losses, and lower output current capability.
The total losses of the coil have a strong impact on the efficiency of the dc/dc conversion and consist of both the
losses in the dc resistance (R(DC)) and the following frequency-dependent components:
The losses in the core material (magnetic hysteresis loss, especially at high switching frequencies)
Additional losses in the conductor from the skin effect (current displacement at high frequencies)
Magnetic field losses of the neighboring windings (proximity effect)
Radiation losses
Copyright 2010, Texas Instruments Incorporated
15
相關PDF資料 |
PDF描述 |
|---|---|
| TPS62361BYZHT | 4.3 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, BGA16 |
| TPS62400QDRCQ1 | SWITCHING REGULATOR, PDSO10 |
| TPS62410DRCTG4 | 1.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62420DRCT | 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62420DRC | 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS62293DRVR | 功能描述:直流/直流開關調節器 2.25MHz 1A Step-Down Cnvrtr RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS62293DRVRG4 | 功能描述:直流/直流開關調節器 2.25MHz 1A Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS62293DRVT | 功能描述:直流/直流開關調節器 2.25MHz 1A Step-Down Cnvrtr RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS62293DRVTG4 | 功能描述:直流/直流開關調節器 2.25MHz 1A Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS62293TDRVRQ1 | 功能描述:直流/直流開關調節器 AC 2.25MHz 1A Step- Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
發布緊急采購，3分鐘左右您將得到回復。