參數資料
型號： TPS62113RSAT
廠商： TEXAS INSTRUMENTS INC
元件分類： 穩壓器
英文描述： 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
封裝： GREEN, PLASTIC, QFN-16
文件頁數： 4/28頁
文件大小： 842K
代理商： TPS62113RSAT
DETAILED DESCRIPTION
OPERATION
CONSTANT-FREQUENCY MODE OF OPERATION (SYNC = HIGH)
POWER-SAVE MODE OF OPERATION (SYNC = LOW)
SLVS585A – JULY 2005 – REVISED FEBRUARY 2009 .................................................................................................................................................... www.ti.com
The TPS6211x is a synchronous step-down converter that operates with a 1-MHz fixed-frequency pulse-width
modulation (PWM) at moderate-to-heavy load currents and enters the power-save mode at light load current.
During PWM operation, the converter uses a unique fast-response voltage-mode control scheme with
input-voltage feedforward. Good line and load regulation is achieved with the use of small input and output
ceramic capacitors. At the beginning of each clock cycle initiated by the clock signal (S), the P-channel MOSFET
switch is turned on, and the inductor current ramps up until the comparator trips and the control logic turns the
switch off. The switch is turned off by the current-limit comparator if the current limit of the P-channel switch is
exceeded. After the dead time prevents current shoot through, the N-channel MOSFET rectifier is turned on, and
the inductor current ramps down. The next cycle is initiated by the clock signal turning off the N-channel rectifier,
and turning on the P-channel switch.
The error amplifier as well as the input voltage determines the rise time of the sawtooth generator. Therefore,
any change in input voltage or output voltage directly controls the duty cycle of the converter, giving a very good
line- and load-transient regulation.
In constant-frequency mode, the output voltage is regulated by varying the duty cycle of the PWM signal in the
range of 100% to 10%. Connecting the SYNC pin to a voltage greater than 1.5 V forces the converter to operate
permanently in the PWM mode even at light or no-load currents. The advantage is that the converter operates
with a fixed switching frequency that allows simple filtering of the switching frequency for noise-sensitive
applications. In this mode, the efficiency is lower compared to the power-save mode during light loads. The
N-MOSFET of the devices stays on even when the current into the output drops to zero. This prevents the device
from going into discontinuous mode, and the device transfers unused energy back to the input. Therefore, there
is no ringing at the output, which usually occurs in discontinuous mode. The duty cycle range in
constant-frequency mode is 100% to 10%.
It is possible to switch from forced PWM mode to the power-save mode during operation by pulling the SYNC pin
LOW. The flexible configuration of the SYNC pin during operation of the device allows efficient power
management by adjusting the operation of the TPS6211x to the specific system requirements.
As the load current decreases, the converter enters the power-save mode of operation. During power-save
mode, the converter operates with reduced switching frequency in pulse-frequency modulation (PFM), and with a
minimum quiescent current to maintain high efficiency. Whenever the average output current goes below the skip
threshold, the converter enters the power-save mode. The average current depends on the input voltage. It is
about 200 mA at low input voltages and up to 400 mA with maximum input voltage. The average output current
must be below the threshold for at least 32 clock cycles to enter the power-save mode. During the power-save
mode, the output voltage is monitored with a comparator, and the output voltage is regulated to a typical value
between the nominal output voltage and 0.8% above the nominal output voltage. When the output voltage falls
below the nominal output voltage, the P-channel switch turns on. The P-channel switch is turned off as the peak
switch current is reached. The N-channel rectifier is turned on, and the inductor current ramps down. As the
inductor current approaches zero, the N-channel rectifier is turned off and the switch is turned on starting the
next pulse. When the output voltage cannot be reached with a single pulse, the device continues to switch with
its normal operating frequency until the comparator detects the output voltage to be 0.8% above the nominal
output voltage. This control method reduces the quiescent current to 20 A (typical), and reduces the switching
frequency to a minimum that achieves the highest converter efficiency.
12
Copyright 2005–2009, Texas Instruments Incorporated
Product Folder Link(s): TPS62110 TPS62111 TPS62112 TPS62113
相關PDF資料
PDF描述
TPS62110RSAR 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62111RSATG4 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62111RSAR 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62112RSATG4 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62110RSARG4 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
相關代理商/技術參數
參數描述
TPS62113RSAT 制造商:Texas Instruments 功能描述:DC/DC Converter IC 制造商:Texas Instruments 功能描述:IC, STEP-DOWN CONVERTER, QFN-16
TPS6211XEVM-101 功能描述:電源管理IC開發工具 TPS6211X Eval Module RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS62120DCNR 功能描述:直流/直流開關轉換器 15V75mA96% Eff Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT
TPS62120DCNT 功能描述:直流/直流開關轉換器 15V75mA96% Eff Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT
TPS62120DCNT 制造商:Texas Instruments 功能描述:Buck Converter 制造商:Texas Instruments 功能描述:IC, DC-DC CONV, 800kHz, 8-SOT-23
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*