參數資料
型號： TPS62112RSATG4
廠商： TEXAS INSTRUMENTS INC
元件分類： 穩壓器
英文描述： 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
封裝： GREEN, PLASTIC, QFN-16
文件頁數： 8/28頁
文件大?。?/td> 842K
代理商： TPS62112RSATG4
O
I
L
O
L
O
V
1
V
I
V
I max
I
max
L
f
2
-
D
=
=
+
(3)
SLVS585A – JULY 2005 – REVISED FEBRUARY 2009 .................................................................................................................................................... www.ti.com
output capacitor, e.g., for a low-transient output-voltage change. From a stability point of view, the inductor value
could be decreased to keep the L × C product constant. However, there are drawbacks if the inductor value is
decreased. A low inductor value causes a high inductor ripple current, and therefore reduces the maximum dc
output current. Table 2 gives the advantages and disadvantages when designing the inductor and output
capacitor.
Table 2. Advantages and Disadvantages When Designing the Inductor and Output Capacitor
INFLUENCE ON STABILITY
ADVANTAGE
DISADVANTAGE
Less output voltage ripple
Increase Cout (>22 F)
Uncritical
None
Less output voltage overshoot /
undershoot during load transient
Higher output voltage ripple
Critical
High output voltage overshoot /
Decrease Cout (<22 F)
Increase inductor value > 6.8 H
None
undershoot during load
also
transient
Less gain and phase margin
Less inductor current ripple
More energy stored in the
inductor
→ higher voltage
overshoot during load transient
Higher dc output current possible if
Smaller current rise
→ higher
Increase L (>6.8 H)
Uncritical
operated close to the current limit
voltage undershoot during load
transient
→ do not decrease the
value of Cout due to these
effects
Critical
High inductor-current ripple
Small voltage overshoot / undershoot
especially at high input voltage
Decrease L (<6.8 H)
Increase output capacitor value >
during load transient
and low output voltage
22 F also
As shown in Table 2, the inductor value can be increased to higher values. For good performance, the
peak-to-peak inductor-current ripple should be less than 30% of the maximum dc output current. Especially at
input voltages above 12 V, it makes sense to increase the inductor value in order to keep the inductor-current
ripple low. In such applications, the inductor value can be increased to 10 H or 22 H. Values above 22 H
should be avoided in order to keep the voltage overshoot during load transient in an acceptable range.
After choosing the inductor value, two additional inductor parameters should be considered:
1. current rating of the inductor
2. dc resistance
The dc resistance of the inductance directly influences the efficiency of the converter. Therefore, an inductor with
lowest dc resistance should be selected for highest efficiency. In order to avoid saturation of the inductor, the
inductor should be rated at least for the maximum output current plus the inductor ripple current which is
calculated as:
where:
f = Switching frequency (1000 kHz typical)
L = Inductor value
ΔIL = Peak-to-peak inductor ripple current
IL(max) = Maximum inductor current
The highest inductor current occurs at maximum VI. A more-conservative approach is to select the inductor
current rating just for the maximum switch current of the TPS6211x, which is 2.4 A (typically). See Table 1 for
recommended inductors.
16
Copyright 2005–2009, Texas Instruments Incorporated
Product Folder Link(s): TPS62110 TPS62111 TPS62112 TPS62113
相關PDF資料
PDF描述
TPS62110RSARG4 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62225DDCT 0.4 A SWITCHING REGULATOR, 1850 kHz SWITCHING FREQ-MAX, PDSO5
TPS62225DDCR 0.4 A SWITCHING REGULATOR, 1850 kHz SWITCHING FREQ-MAX, PDSO5
TPS62229DDC 0.88 A SWITCHING REGULATOR, 1850 kHz SWITCHING FREQ-MAX, PDSO5
TPS6223-1.5DRYT 1.22 A SWITCHING REGULATOR, 3800 kHz SWITCHING FREQ-MAX, PDSO6
相關代理商/技術參數
參數描述
TPS62113EVM-465 功能描述:電源管理IC開發工具 TPS62113EVM-465 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS62113RSAR 功能描述:直流/直流開關調節器 1.5A,17Vin Step- Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62113RSAT 功能描述:直流/直流開關調節器 1.5A,17Vin Step- Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62113RSAT 制造商:Texas Instruments 功能描述:DC/DC Converter IC 制造商:Texas Instruments 功能描述:IC, STEP-DOWN CONVERTER, QFN-16
TPS6211XEVM-101 功能描述:電源管理IC開發工具 TPS6211X Eval Module RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*