參數資料
型號： TPS62110MRSAREP
廠商： TEXAS INSTRUMENTS INC
元件分類： 穩壓器
英文描述： 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
封裝： GREEN, PLASTIC, QFN-16
文件頁數： 7/25頁
文件大?。?/td> 630K
代理商： TPS62110MRSAREP
ENABLE
UNDERVOLTAGE LOCKOUT
SYNCHRONIZATION
POWER GOOD COMPARATOR
LOW-BATTERY DETECTOR
www.ti.com .............................................................................................................................................................. SLVS630C – APRIL 2007 – REVISED MAY 2008
DETAILED DESCRIPTION (continued)
Logic low on EN forces the TPS6211x into shutdown. In shutdown, the power switch, drivers, voltage reference,
oscillator, and all other functions are turned off. The supply current is reduced to less than 2
A in the shutdown
mode. When the device is in thermal shutdown, the bandgap is forced to be switched on even if the device is set
into shutdown by pulling EN to GND.
If an output voltage is present when the device is disabled, which could be due to an external voltage source or a
super capacitor, the reverse leakage current is specified under electrical characteristics. Pulling the enable pin
high starts up the TPS6211x with the soft start. If the EN pin is connected to any voltage other than VI or GND,
an increased leakage current of typically 10
A and up to 20 A can occur.
The undervoltage lockout circuit prevents the device from misoperation at low-input voltages. It prevents the
converter from turning on the switch or rectifier MOSFET under undefined conditions. The minimum input voltage
to start up the TPS6211x is 3.4 V (worst case). The device shuts down at 2.8 V minimum.
If no clock signal is applied, the converter operates with a typical switching frequency of 1 MHz. It is possible to
synchronize the converter to an external clock within a frequency range from 0.8 MHz to 1.4 MHz. The device
automatically detects the rising edge of the first clock and synchronizes immediately to the external clock. If the
clock signal is stopped, the converter automatically switches back to the internal clock and continues operation.
The switch over is initiated if no rising edge on the SYNC pin is detected for a duration of four clock cycles.
Therefore, the maximum delay time can be 6.25
s if the internal clock has its minimum frequency of 800 kHz.
If the device is synchronized to an external clock, the power save mode is disabled, and the devices stay in
forced PWM mode.
Connecting the SYNC pin to the GND pin enables the power save mode. The converter operates in the PWM
mode at moderate-to-heavy loads, and in the PFM mode during light loads, which maintains high efficiency over
a wide load current range.
The power good (PG) comparator has an open-drain output capable of sinking 1 mA (typical). The PG is active
only when the device is enabled (EN=high). When the device is disabled (EN=low), the PG pin is pulled to GND.
The PG output is valid only after a 250-
s delay when the device is enabled, and the supply voltage is greater
than the undervoltage lockout V(UVLO). PG is low during the first 250 s after shutdown and in shutdown.
The PG pin becomes active high when the output voltage exceeds 98.4% (typical) of its nominal value. Leave
the PG pin unconnected when not used.
The low-battery output (LBO) is an open-drain type which goes low when the voltage at the low-battery input
(LBI) falls below the trip point of 1.256 V ±1.5%. The voltage at which the low-battery warning is issued can be
adjusted with a resistive divider as shown in Figure 19. The sum of resistors (R1 + R2) as well as the sum of (R5
+ R6) is recommended to be in the 100 k
to 1 M range for high efficiency at low output current. An external
pullup resistor can be connected to OUT, or any other voltage rail in the voltage range of 0 V to 16 V. During
start-up, the LBO output signal is invalid for the first 500
s. LBO is high impedance when the device is disabled.
If the low-battery comparator function is not used, connect LBI to ground. The low-battery detector is disabled
when the device is disabled.
The logic level of the LBO pin is not defined for the first 500
s after EN is pulled high.
When the LBI is used to supervise the battery voltage and shut down the TPS62111 at low-input voltages, the
battery voltage rises when the current drops to zero. The implemented hysteresis on the LBI pin may not be
sufficient for all types of batteries. Figure 19 shows how an additional external hysteresis can be implemented.
Copyright 2007–2008, Texas Instruments Incorporated
15
Product Folder Link(s): TPS62110-EP TPS62111-EP TPS62112-EP
相關PDF資料
PDF描述
TPS62110RSAT 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62113RSAT 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62110RSAR 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62111RSATG4 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62111RSAR 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
相關代理商/技術參數
參數描述
TPS62110QRSAREP 功能描述:IC REG BUCK SYNC ADJ 1.5A 16QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:20 系列:SIMPLE SWITCHER® 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:12V 輸入電壓:4 V ~ 60 V PWM 型:電壓模式 頻率 - 開關:52kHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 包裝:管件 供應商設備封裝:16-DIP 其它名稱:*LM2575HVN-12LM2575HVN-12
TPS62110QRSARQ1 功能描述:直流/直流開關轉換器 AC Adj,1.5A,17V Vin Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT
TPS62110RSA 制造商:Texas Instruments 功能描述:
TPS62110RSAR 功能描述:直流/直流開關調節器 Adj 1.5-A 17-V Vin Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62110RSARG4 功能描述:直流/直流開關轉換器 Adj 1.5-A 17-V Vin Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*