參數資料
型號： TPS62082DSGT
廠商： TEXAS INSTRUMENTS INC
元件分類： 穩壓器
英文描述： 0.002 A SWITCHING REGULATOR, PDSO8
封裝： 2 X 2 MM, GREEN, PLASTIC, WSON-8
文件頁數： 6/26頁
文件大?。?/td> 872K
代理商： TPS62082DSGT
SLVSAE8
– SEPTEMBER 2011
RDS(on) = High side FET on-resistance
RL = Inductor ohmic resistance
ENABLING / DISABLING THE DEVICE
The device is enabled by setting the EN input to a logic HIGH. Accordingly, a logic LOW disables the device. If
the device is enabled, the internal power stage will start switching and regulate the output voltage to the
programmed threshold. The EN input must be terminated with a resistance less than 1M
Ω pulled to VIN or GND.
OUTPUT DISCHARGE
The output gets discharged by the SW pin with a typical discharge resistor of RDIS whenever the device shuts
down. This is the case when the device gets disabled by enable, thermal shutdown trigger, and undervoltage
lockout trigger.
SOFT START
After enabling the device, an internal soft-start circuitry monotonically ramps up the output voltage and reaches
the nominal output voltage during a soft start time (100
s, typical). This avoids excessive inrush current and
creates a smooth output voltage rise slope. It also prevents excessive voltage drops of primary cells and
rechargeable batteries with high internal impedance.
If the output voltage is not reached within the soft start time, such as in the case of heavy load, the converter will
enter regular operation. Consequently, the inductor current limit will operate as described below. The TPS6208x
is able to start into a pre-biased output capacitor. The converter starts with the applied bias voltage and ramps
the output voltage to its nominal value.
POWER GOOD
The TPS6208x has a power good output going low when the output voltage is below its nominal value. The
power good keeps high impedance once the output is above 95% of the regulated voltage, and is driven to low
once the output voltage falls below typically 90% of the regulated voltage. The PG pin is a open drain output and
is specified to sink typically up to 0.5mA. The power good output requires a pull up resistor that is recommended
connecting to the device output. When the device is off due to disable, UVLO or thermal shutdown, the PG pin is
at high impedance.
The PG signal can be used for sequencing of multiple rails by connecting to the EN pin of other converters.
Leave the PG pin unconnected when not used.
UNDER VOLTAGE LOCKOUT
To avoid mis-operation of the device at low input voltages, an under voltage lockout is implemented, that shuts
down the device at voltages lower than VUVLO with a VHYS_UVLO hysteresis.
THERMAL SHUTDOWN
The device goes into thermal shutdown once the junction temperature exceeds typically TJSD. Once the device
temperature falls below the threshold the device returns to normal operation automatically.
INDUCTOR CURRENT LIMIT
The Inductor Current Limit prevents the device from high inductor current and drawing excessive current from the
battery or input voltage rail. Excessive current might occur with a shorted/saturated inductor or a heavy
load/shorted output circuit condition.
The incorporated inductor peak current limit measures the current during the high side and low side power
MOSFET on-phase in PWM mode. Once the high side switch current limit is tripped, the high side MOSFET is
turned off and the low side MOSFET is turned on to reduce the inductor current. Until the inductor current drops
down to low side switch current limit, the low side MOSFET is turned off and the high side switch is turned on
again. This operation repeats until the inductor current does not reach the high side switch current limit. Due to
the internal propagation delay, the real current limit value can exceed the static current limit in the electrical
characteristics table.
14
Copyright
2011, Texas Instruments Incorporated
Product Folder Link(s): TPS62080 TPS62081 TPS62082
相關PDF資料
PDF描述
TPS62081DSG 0.002 A SWITCHING REGULATOR, PDSO8
TPS62110MRSAREP 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62110RSAT 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62113RSAT 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
TPS62110RSAR 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16
相關代理商/技術參數
參數描述
TPS62085EVM-169 制造商:Texas Instruments 功能描述:EVAL MOD STEP-DOWN CTRLR 3A
TPS62085RLTR 制造商:Texas Instruments 功能描述:IC REG BUCK SYNC ADJ 3A 7QFN
TPS62085RLTT 制造商:Texas Instruments 功能描述:HIGH PERFORMANCE 3A BUCK CONV HOTROD 2X2 - Cut TR (SOS) 制造商:Texas Instruments 功能描述:HIGH PERFORMANCE 3A BUCK CONV HOTROD 2X2 - Tape and Reel 制造商:Texas Instruments 功能描述:IC REG BUCK SYNC ADJ 3A 7VQFN 制造商:Texas Instruments 功能描述:IC, DC-DC CONVERTOR, 2.4MHZ, VQFN-7 制造商:Texas Instruments 功能描述:DC-DC CONV, BUCK, ADJ, 2.4MHZ, VQFN-7, Primary Input Voltage:6V, No. of Outputs:1, Output Current:3A, No. of Pins:7, Operating Temperature Min:-40C, Operating Temperature Max:85C, Package / Case:7-VQFN
TPS62086RLTR 功能描述:Buck Switching Regulator IC Positive Fixed 3.3V 1 Output 3A 7-VFDFN 制造商:texas instruments 系列:DCS-Control?? 包裝:剪切帶（CT） 零件狀態:有效 功能:降壓 輸出配置:正 拓?fù)?降壓 輸出類型:固定 輸出數:1 電壓 - 輸入（最小值）:2.5V 電壓 - 輸入（最大值）:6V 電壓 - 輸出（最小值/固定）:3.3V 電壓 - 輸出（最大值）:- 電流 - 輸出:3A 頻率 - 開關:2.4MHz 同步整流器:是 工作溫度:-40°C ~ 125°C （TJ） 安裝類型:表面貼裝 封裝/外殼:7-VFDFN 供應商器件封裝:7-VSON（2x2） 標準包裝:1
TPS62086RLTT 制造商:Texas Instruments 功能描述:3A HIGH EFF STEP DOWN IN HOTROD 3.3VOUT - Cut TR (SOS) 制造商:Texas Instruments 功能描述:IC, DC-DC CONVERTOR, 2.4MHZ, VQFN-7
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*