- 您現在的位置：買賣IC網 > PDF目錄103068 > TPS61122PWG4 (TEXAS INSTRUMENTS INC) 1.6 A BATTERY CHARGE CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | TPS61122PWG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 1.6 A BATTERY CHARGE CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | GREEN, PLASTIC, TSSOP-16 |
| 文件頁數： | 8/32頁 |
| 文件大?。?/td> | 844K |
| 代理商： | TPS61122PWG4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
www.ti.com
Capacitor Selection
C
min +
I
OUT
V
OUT *
V
BAT
DV
V
OUT
(7)
DVESR + IOUT
R
ESR
(8)
A
REG +
d
V
FB
+
10
(R3 ) R6)
R6
(1 ) i
w
1.6 ms)
(9)
TPS61120
TPS61122, TPS61121
SLVS427C – JUNE 2002 – REVISED APRIL 2004
List of Inductors
VENDOR
RECOMMENDED INDUCTOR SERIES
CDRH5D18
Sumida
CDRH6D28
Wurth Electronik
7447789___
7447779___
DR73
Coiltronics
DR74
TDK
SLF 7032
EPCOS
B82462G
Input Capacitor
At least a 10-F input capacitor is recommended to improve transient behavior of the regulator and EMI behavior
of the total power supply circuit. A ceramic capacitor or a tantalum capacitor with a 100-nF ceramic capacitor in
parallel, placed close to the IC, is recommended.
Output Capacitor DC/DC Converter
The major parameter necessary to define the output capacitor is the maximum allowed output voltage ripple of
the converter. This ripple is determined by two parameters of the capacitor, the capacitance and the ESR. It is
possible to calculate the minimum capacitance needed for the defined ripple, supposing that the ESR is zero, by
using Equation 7:
Parameter f is the switching frequency and
V is the maximum allowed ripple.
With a chosen ripple voltage of 10 mV, a minimum capacitance of 22 F is needed. The total ripple is larger due
to the ESR of the output capacitor. This additional component of the ripple can be calculated using Equation 8:
An additional ripple of 20 mV is the result of using a tantalum capacitor with a low ESR of 80 m
. The total ripple
is the sum of the ripple caused by the capacitance and the ripple caused by the ESR of the capacitor. In this
example, the total ripple is 30 mV. Additional ripple is caused by load transients. This means that the output
capacitance needs to be larger than calculated above to meet the total ripple requirements. The output capacitor
has to completely supply the load during the charging phase of the inductor. A reasonable value of the output
capacitance depends on the speed of the load transients and the load current during the load change. In typical
applications a 100 F capacitance is recommended. For economical reasons this usually is a tantalum capacitor.
Because of this the control loop has been optimized for using output capacitors with an ESR of above 30 m
.
The minimum value for the output capacitor is 22 F.
Small Signal Stability
When using output capacitors with lower ESR, like ceramics, it is recommended to use the adjustable voltage
version. The missing ESR can be easily compensated there in the feedback divider. Typically a capacitor in the
range of 10 pF in parallel with R3 helps to obtain small signal stability, with the lowest ESR output capacitors.
For more detailed analysis the small signal transfer function of the error amplifier and regulator, which is given in
Equation 9, can be used.
16
相關PDF資料 |
PDF描述 |
|---|---|
| TPS62421DRC | 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TC54VC3302EMBTR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PSSO3 |
| TC54VC4501EMBRT | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PSSO3 |
| TC54VC5302ECBRT | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO3 |
| TC54VN1802ECBTR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO3 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS61122PWR | 功能描述:開關變換器、穩壓器與控制器 3.6V Boost Cnvrtr w/3.3V 200mA LDO RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| TPS61122PWRG4 | 功能描述:開關變換器、穩壓器與控制器 3.6V Boost Cnvrtr w/3.3V 200mA LDO RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| TPS61130 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SYNCHRONOUS SEPIC / FLYBACK CONVERTER WITH 1.1A SWITCH AND INTEGRATED LDO |
| TPS61130EVM-206 | 功能描述:電源管理IC開發工具 TPS61130-206 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS61130PW | 功能描述:直流/直流開關調節器 Adj 90% Eff SEPIC Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
發布緊急采購，3分鐘左右您將得到回復。