- 您現在的位置：買賣IC網 > PDF目錄384027 > TPS61090EVM-029 (Texas Instruments, Inc.) TPS61090 Evaluation Module(TPS61090評估模塊) PDF資料下載
參數資料
| 型號： | TPS61090EVM-029 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | TPS61090 Evaluation Module(TPS61090評估模塊) |
| 中文描述： | TPS61090評估模塊（TPS61090評估模塊） |
| 文件頁數： | 11/18頁 |
| 文件大小： | 224K |
| 代理商： | TPS61090EVM-029 |
Input/Output Connector Descriptions
2-2
2.1
Input/Output Connector Descriptions
2.1.1
J1—VBAT
This is the positive connection to the input power supply. The leads to the input
supply should be twisted and kept as short as possible to minimize EMI trans-
mission.
2.1.2
J2—GND
This is the return connection for the input power supply.
2.1.3
J3—VOUT
This is the positive connection from the output of the power supply. Connect
this pin to the positive input of the load.
2.1.4
J4—GND
This is the negative connection from the output of the power supply. Connect
this pin to the negative input of the load.
2.1.5
J5—LBO
The LBO pin is an open-drain output configured with a 1M pull-up resistor.
2.1.6
J6—GND
This is the ground connection for the LBO pin.
2.1.7
JP1—SYNC
This jumper enables or disables the power save mode at light loads. If SYNC
is connected to VBAT, the power save mode is disabled. Connecting SYNC to
GND enables the power save mode. When the SYNC pin is not connected to
VBAT or GND, the switch of the frequency of the device will synchronize to a
user-provided signal of 500kHz to 700kHz.
2.1.8
JP2—EN
This jumper enables and disables the TPS61090 on the EVM.
2.2
Setup
Connect an input supply between J1 and J2. The voltage range on this supply
should stay between 1.8V and 5.0V. Connect a load between J3 and J4. En-
able the output by positioning a jumper to connect the EN and ON pins. Config-
ure the SYNC jumper to the desired setting.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS61170DRV | 1.2A High Voltage Boost Converter in 2x2mm2 QFN Package |
| TPS62046EVM | 1.2-A High-Efficiency Step-Down Converters Evaluation Module(1.2A高效率降壓轉換器TPS62046評估模塊) |
| TPS62040EVM | 1.2-A High-Efficiency Step-Down Converters Evaluation Module(1.2A高效率降壓轉換器TPS62040評估模塊) |
| TPS62205DBV | HIGH-EFFICIENCY, SOT23 STEP-DOWN, DC-DC CONVERTER |
| TPS62207DBV | HIGH-EFFICIENCY, SOT23 STEP-DOWN, DC-DC CONVERTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS61090RSA | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SYNCHRONOUS BOOST CONVERTER WITH 2A SWITCH |
| TPS61090RSAR | 功能描述:直流/直流開關調節器 Adj 500-mA 96% Eff Boost Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS61090RSARG4 | 功能描述:直流/直流開關調節器 Adj 500-mA 96% Eff Boost Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS61091 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SYNCHRONOUS BOOST CONVERTER WITH 2A SWITCH |
| TPS61091RSA | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SYNCHRONOUS BOOST CONVERTER WITH 2A SWITCH |
發布緊急采購，3分鐘左右您將得到回復。