- 您現在的位置：買賣IC網 > PDF目錄98284 > TPS61080DRCTG4 (TEXAS INSTRUMENTS INC) 0.5 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | TPS61080DRCTG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.5 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | 3 X 3 MM, 1 MM HEIGHT, GREEN, PLASTIC, QFN-10 |
| 文件頁數： | 4/25頁 |
| 文件大?。?/td> | 925K |
| 代理商： | TPS61080DRCTG4 |
www.ti.com
FREQUENCY SELECTION
MAXIMUM and MINIMUM OUTPUT CURRENT
Ip +
1
L
1
Vout)Vf*Vin
)
1
Vin
Fs
(1)
Iout_max +
Vin
Ilim *
Ip
2
h
Vout
(2)
Ipeak +
2
Iload
Vout ) Vf * Vin
L
Fs
D + L
Ipeak
Vin
Fs
(3)
SLVS644B – FEBRUARY 2006 – REVISED JANUARY 2007
The FSW pin can be connected to either a logic high or logic low to program the switching frequency to1.2MHz
or 600kHz respectively. The 600kHz switching frequency provides better efficiency because of lower switching
losses. This advantage becomes more evident at light load when switching losses dominate overall losses. The
higher switching frequency shrinks external component size and thus the size of power solution. High switching
frequency also improves load transient response since the smaller value inductor takes less time to ramp up and
down current. The other benefits of high switching frequency are lower output ripples and a higher maximum
output current. Overall, it is recommended to use 1.2MHz switching frequency unless light load efficiency is a
major concern.
The FSW pin has internal 800k
pull up resistor to the VIN pin. Floating this pin programs the switching
frequency to 1.2MHz.
The over-current limit in a boost converter limits the maximum input current and thus maximum input power from
a given input voltage. Maximum output power is less than maximum input power due to power conversion
losses. Therefore, the over-current limit, the input voltage, the output voltage and the conversion efficiency all
affect maximum current output. Since the over-current limit clamps the peak inductor current, the current ripple
has to be subtracted to derive maximum DC current. The current ripple is a function of the switching frequency,
the inductor value and the duty cycle.
where
Ip = inductor peak to peak ripple
L = inductor value
Vf = power diode forward voltage
Fs = Switching frequency
The following equations take into account of all the above factors for maximum output current calculation.
where
Ilim = overcurrent limit
η = conversion efficiency
To minimize the variation in the overcurrent limit threshold, the TPS61080/1 uses the VIN and OUT pin voltage
to compensate for the variation caused by the slope compensation. However, the threshold still has some
dependency on the VIN and OUT voltage. Use Figure 6 to Figure 9 to identify the typical over-current limit in
your application, and use 25% tolerance to account for temperature dependency and process variations.
Because of the minimum duty cycle of each power switching cycle of TPS61080/1, the device can lose
regulation at the very light load. Use the following equations to calculate PWM duty cycle under discontinues
conduction mode (DCM).
Where
Ipeak = inductor peak to peak ripple in DCM
Iload = load current
D = PWM switching duty cycle
12
相關PDF資料 |
PDF描述 |
|---|---|
| TPS61093DSK | 1.5 A SWITCHING REGULATOR, 1400 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61122PWRG4 | 1.6 A BATTERY CHARGE CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS61131PWG4 | 1.6 A BATTERY CHARGE CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS61221DCKR | 0.4 A BATTERY CHARGE CONTROLLER, PDSO6 |
| TPS61251DSGT | SWITCHING REGULATOR, 3500 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS61080EVM-147 | 功能描述:電源管理IC開發工具 TPS61080-147 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS61081 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:HIGH VOLTAGE DC/DC BOOST CONVERTER WITH 0.5-A/1.3-A INTEGRATED SWITCH |
| TPS61081DRCR | 功能描述:LED照明驅動器 High Vge DC/DC Boost Converter RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| TPS61081DRCRG4 | 功能描述:LED照明驅動器 27V 1.2A SW 1.2MHz Boost Cnvrtr RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| TPS61081DRCT | 功能描述:LED照明驅動器 High Vge DC/DC Boost Converter RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
發布緊急采購，3分鐘左右您將得到回復。