- 您現在的位置：買賣IC網 > PDF目錄384027 > TPS60125PWPR (Texas Instruments, Inc.) REGULATED 3.3 V, 200-mA HIGH EFFICIENCY CHARGE PUMP DC/DC CONVERTERS PDF資料下載
參數資料
| 型號： | TPS60125PWPR |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | REGULATED 3.3 V, 200-mA HIGH EFFICIENCY CHARGE PUMP DC/DC CONVERTERS |
| 中文描述： | 穩壓3.3伏，200毫安高效率電荷泵DC / DC轉換器 |
| 文件頁數： | 4/27頁 |
| 文件大?。?/td> | 561K |
| 代理商： | TPS60125PWPR |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
TPS60120, TPS60121, TPS60122, TPS60123, TPS60124, TPS60125
REGULATED 200-mA HIGH EFFICIENCY CHARGE PUMP
DC/DC CONVERTERS
SLVS257B – NOVEMBER 1999 – REVISED AUGUST 2000
4
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
Terminal Functions
TERMINAL
NAME
I/O
DESCRIPTION
NO.
C1+
6
Positive terminal of the flying capacitor C1
C1–
8
Negative terminal of the flying capacitor C1
C2+
15
Positive terminal of the flying capacitor C2
C2–
13
Negative terminal of the flying capacitor C2
ENABLE
3
I
ENABLE input. Connect ENABLE to IN for normal operation. When ENABLE is a logic low, the device turns off and
the supply current decreases to 0.05
μ
A. The output is disconnected from the input when the device is placed in
shutdown.
FB
4
I
Feedback input. Connect FB to OUT as close to the load as possible to achieve best regulation. Resistive divider
is on the chip to match the internal reference voltage of 1.21 V.
GND
1, 2,
19, 20
Ground. Analog ground for internal reference and control circuitry. Connect to PGND through a short trace.
IN
7,14
I
Supply input. Connect to an input supply in the 1.8-V to 3.6-V range. Bypass IN to PGND with a (CO/2)
μ
F capacitor.
Connect both INs through a short trace.
LBO/PG
17
O
Low battery detector output or power good output. Open drain output of the low battery or power-good comparator.
It can sink 1 mA. A 100-k
to 1-M
pullup is recommended. Leave terminal unconnected if not used.
Low battery detector input (TPS60120/TPS60122/TPS60124 only). The input is compared to the internal 1.21-V
reference voltage. Connect terminal to ground if the low-battery detector function is not used. On the TPS60121,
TPS60123, and TPS60125, this terminal is not connected.
LBI/NC
18
I
OUT
5, 16
O
Regulated power output. Connect both OUT terminals through a short trace and bypass OUT to GND with the output
filter capacitor CO.
Power ground. Charge-pump current flows through this pin. Connect all PGND pins together.
PGND
9–12
detailed description
operating principle
The TPS6012x charge pumps provide a regulated 3.3-V or 3-V output from a 1.8-V to 3.6-V input. They are
designed for a maximum load current of at least 200 mA or 100 mA, respectively. Designed specifically for
space-critical, battery-powered applications, the complete charge pump circuit requires only four external
capacitors. The circuit is optimized for efficiency over a wide input voltage range.
The TPS6012x charge pumps consist of an oscillator, a 1.21-V bandgap reference, an internal resistive
feedback circuit, an error amplifier, high current MOSFET switches, a shutdown/start-up circuit, a low-battery
or power-good comparator, and a control circuit (see the functional block diagram).
The device consists of two single-ended charge pumps. The power stages of the charge pump are automatically
configured to amplify the input voltage with a conversion factor of 1.5 or 2. The conversion ratio depends on
input voltage and output current. With input voltages lower than approximately 2.4 V, the convertor will run in
a voltage doubler mode with a gain of two. With a higher input voltage, the converter operates with a gain of
1.5. This assures high efficiency over the wide input voltage range of a two-cell battery stack and is further
described in the adaptive mode switchingsection.
adaptive mode switching
The ON-resistance of the MOSFETs that are in the charge path of the flying capacitors is regulated when the
charge pump operates in voltage doubler-mode. It is changed depending on the output voltage that is fed back
into the control loop. This way, the time-constant during the charging phase can be modified and increased
versus a time-constant for fully switched-on MOSFETs. The ON-resistance of both switches and the
capacitance of the flying capacitor define the time constant. The MOSFET switches in the discharge path of the
charge pump are always fully switched on to their minimum r
DS(on)
. With the time-constant during charge phase
being larger than the time constant in discharge phase, the voltage on the flying capacitors stabilizes to the
lowest possible value necessary to get a stable V
O
.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS60125PWPRG4 | REGULATED 3.3 V, 200-mA HIGH EFFICIENCY CHARGE PUMP DC/DC CONVERTERS |
| TPS60242DGKR | 170-uVrms ZERO-RIPPLE SWITCHED CAP BUCK-BOOST CONVERTER FOR VCO SUPPLY |
| TPS60250RTE | HIGH EFFICIENCY CHARGE PUMP FOR 7 WLEDs WITH I2C INTERFACE |
| TPS61030EVM-029 | TPS61030 Evaluation Module(TPS61030評估模塊) |
| TPS61032EVM-208 | For High-Efficient High Output Current Boost Converter(用于高效率高輸出電流的升壓轉換器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS60125PWPRG4 | 功能描述:電荷泵 Reg 3.0-V High Eff Charge Pump RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
| TPS60130 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:REGULATED 5-V, 300 mA HIGH EFFICIENCY CHARGE PUMP DC/DC CONVERTERS |
| TPS60130EVM-143 | 功能描述:電源管理IC開發工具 3 batt cells/1 Li-Ion cell RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS60130PWP | 功能描述:電荷泵 Reg 5V Hi-Eff Charge Pump DC/DC Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
| TPS60130PWPG4 | 功能描述:電荷泵 Reg 5V Hi-Eff Charge Pump DC/DC Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。