參數資料
型號: TPA2001D2PWPR
廠商: TEXAS INSTRUMENTS INC
元件分類: 音頻/視頻放大
英文描述: 1 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24
封裝: GREEN, PLASTIC, HTSSOP-24
文件頁數: 13/16頁
文件大?。?/td> 370K
代理商: TPA2001D2PWPR
TPA2001D2
1-W FILTERLESS STEREO CLASS-D AUDIO POWER AMPLIFIER
SLOS292A – MARCH 2000 – REVISED APRIL 2000
6
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
0 V
–5 V
+5 V
Current
OUT+
OUT–
Differential
Voltage
Across
Load
0 V
–5 V
+5 V
Current
OUT+
OUT–
Differential
Voltage
Across
Load
Output = 0 V
Output > 0 V
Figure 2. The TPA2001D2 Output Voltage and Current Waveforms Into an Inductive Load
efficiency: why you must use a filter with the traditional class-D modulation scheme
The main reason that the traditional class-D amplifier needs an output filter is that the switching waveform
results in maximum current flow. This causes more loss in the load, which causes lower efficiency. The ripple
current is large for the traditional modulation scheme because the ripple current is proportional to voltage
multiplied by the time at that voltage. The differential voltage swing is 2
× VDD and the time at each voltage is
half the period for the traditional modulation scheme. An ideal LC filter is needed to store the ripple current from
each half cycle for the next half cycle, while any resistance causes power dissipation. The speaker is both
resistive and reactive, whereas an LC filter is almost purely reactive.
The TPA2001D2 modulation scheme has very little loss in the load without a filter because the pulses are very
short and the change in voltage is VDD instead of 2 × VDD. As the output power increases, the pulses widen
making the ripple current larger. Ripple current could be filtered with an LC filter for increased efficiency, but for
most applications the filter is not needed.
An LC filter with a cut-off frequency less than the class-D switching frequency allows the switching current to
flow through the filter instead of the load. The filter has less resistance than the speaker that results in less power
dissipated, which increases efficiency.
相關PDF資料
PDF描述
TPA2001D2PWP 1 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24
TPA2001D2PWPG4 1 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24
TPA2001D2PWPRG4 1 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24
TPA2005D1DRBRQ1 1.45 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO8
TPA2005D1GQYRQ1 1.45 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA
相關代理商/技術參數
參數描述
TPA2001D2PWPRG4 功能描述:音頻放大器 Stereo Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA2005D1 制造商:TI 制造商全稱:Texas Instruments 功能描述:1.1 W MONO FILTER FREE CLASS D AUDIO POWER AMPLIFIER
TPA2005D1DGN 功能描述:音頻放大器 Mono Fully Diff Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA2005D1DGN 制造商:Texas Instruments 功能描述:AUDIO POWER AMPLIFIER IC ((NW)) 制造商:Texas Instruments 功能描述:IC, AUDIO PWR AMP, CLASS D, 1.4W, MSOP-8
TPA2005D1DGNG4 功能描述:音頻放大器 Mono Fully Diff Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel