參數資料
型號： TMX320F28069PFPA
廠商： Texas Instruments
文件頁數： 89/174頁
文件大?。?/td> 0K
描述： IC MCU 32BIT 128KB FLASH 80LQFP
產品培訓模塊： ControlSUITE
Piccolo F2806x
Motor Signal Chain Overview
TPS75005 Single IC Power for C2000 MCU
標準包裝： 1
系列： TMS320F2806x, Piccolo™, C2000™
核心處理器： C28x
芯體尺寸： 32-位
速度： 80MHz
連通性： CAN，I²C，McBSP，SCI，SPI，UART/USART
外圍設備： 欠壓檢測/復位，DMA，POR，PWM，WDT
輸入/輸出數： 40
程序存儲器容量： 256KB（128K x 16）
程序存儲器類型： 閃存
RAM 容量： 50K x 16
電壓 - 電源 (Vcc/Vdd)： 1.71 V ~ 1.995 V
數據轉換器： A/D 12x12b
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 80-TQFP 裸露焊盤
包裝： 托盤
其它名稱： 296-32777
TMX320F28069PFPA-ND
SPRS698D – NOVEMBER 2010 – REVISED DECEMBER 2012
2.4
Signal Descriptions
Table 2-5 describes the signals. With the exception of the JTAG pins, the GPIO function is the default at
reset, unless otherwise mentioned. The peripheral signals that are listed under them are alternate
functions. Some peripheral functions may not be available in all devices. See Table 2-1 for details. Inputs
are not 5-V tolerant. All GPIO pins are I/O/Z and have an internal pullup, which can be selectively enabled
or disabled on a per-pin basis. This feature only applies to the GPIO pins. The pullups on the PWM pins
are not enabled at reset. The pullups on other GPIO pins are enabled upon reset. The AIO pins do not
have an internal pullup.
NOTE: When the on-chip VREG is used, the GPIO19, GPIO34, GPIO35, GPIO36, GPIO37, and GPIO38
pins could glitch during power up. If this is unacceptable in an application, 1.8 V could be supplied
externally. There is no power-sequencing requirement when using an external 1.8-V supply. However, if
the 3.3-V transistors in the level-shifting output buffers of the I/O pins are powered prior to the 1.9-V
transistors, it is possible for the output buffers to turn on, causing a glitch to occur on the pin during power
up. To avoid this behavior, power the VDD pins prior to or simultaneously with the VDDIO pins, ensuring that
the VDD pins have reached 0.7 V before the VDDIO pins reach 0.7 V.
Table 2-5. Terminal Functions(1)
PIN NO.
PIN NAME
I/O/Z
DESCRIPTION
PZ
PN
PZP
PFP
JTAG
JTAG test reset with internal pulldown. TRST, when driven high, gives the scan system
control of the operations of the device. If this signal is not connected or driven low, the
device operates in its functional mode, and the test reset signals are ignored.
NOTE: TRST is an active-high test pin and must be maintained low at all times during
TRST
12
10
I
normal device operation. An external pull-down resistor is required on this pin. The
value of this resistor should be based on drive strength of the debugger pods
applicable to the design. A 2.2-k
resistor generally offers adequate protection. Since
this is application-specific, it is recommended that each target board be validated for
proper operation of the debugger and the application. (
↓)
TCK
See GPIO38
I
See GPIO38. JTAG test clock with internal pullup. (
↑)
See GPIO36. JTAG test-mode select (TMS) with internal pullup. This serial control
TMS
See GPIO36
I
input is clocked into the TAP controller on the rising edge of TCK. (
↑)
See GPIO35. JTAG test data input (TDI) with internal pullup. TDI is clocked into the
TDI
See GPIO35
I
selected register (instruction or data) on a rising edge of TCK. (
↑)
See GPIO37. JTAG scan out, test data output (TDO). The contents of the selected
TDO
See GPIO37
O/Z
register (instruction or data) are shifted out of TDO on the falling edge of TCK.
(8-mA drive)
FLASH
VDD3VFL
46
37
3.3-V Flash Core Power Pin. This pin should be connected to 3.3 V at all times.
TEST2
45
36
I/O
Test Pin. Reserved for TI. Must be left unconnected.
(1)
I = Input, O = Output, Z = High Impedance, OD = Open Drain,
↑ = Pullup, ↓ = Pulldown
Copyright 2010–2012, Texas Instruments Incorporated
Device Overview
21
相關PDF資料
PDF描述
VI-26R-IX-F2 CONVERTER MOD DC/DC 7.5V 75W
VI-26P-IX-F3 CONVERTER MOD DC/DC 13.8V 75W
VI-26N-IX-F3 CONVERTER MOD DC/DC 18.5V 75W
VI-26M-IX-F4 CONVERTER MOD DC/DC 10V 75W
DSPIC30F6013-20E/PF IC DSPIC MCU/DSP 132K 80TQFP
相關代理商/技術參數
參數描述
TMX320F28069PNA 功能描述:IC MCU 32BIT 128KB FLASH 80LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:TMS320F2806x, Piccolo™, C2000™ 產品培訓模塊:Asynchronous Stimulus 標準包裝:90 系列:dsPIC™ 30F 核心處理器:dsPIC 芯體尺寸:16-位 速度:20 MIPS 連通性:CAN，I²C，SPI，UART/USART 外圍設備:AC'97，欠壓檢測/復位，I²S，LVD，POR，PWM，WDT 輸入/輸出數:52 程序存儲器容量:144KB（48K x 24） 程序存儲器類型:閃存 EEPROM 大小:4K x 8 RAM 容量:8K x 8 電壓 - 電源 (Vcc/Vdd):2.5 V ~ 5.5 V 數據轉換器:A/D 16x12b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:64-TQFP 包裝:托盤 配用:XLT64PT4-ND - SOCKET TRAN ICE 64MQFP/TQFPAC164313-ND - MODULE SKT FOR PM3 64PF 其它名稱:DSPIC30F601220EPF
TMX320F28069PZA 功能描述:IC MCU 32BIT 128KB FLASH 100LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:TMS320F2806x, Piccolo™, C2000™ 產品培訓模塊:Asynchronous Stimulus 標準包裝:90 系列:dsPIC™ 30F 核心處理器:dsPIC 芯體尺寸:16-位 速度:20 MIPS 連通性:CAN，I²C，SPI，UART/USART 外圍設備:AC'97，欠壓檢測/復位，I²S，LVD，POR，PWM，WDT 輸入/輸出數:52 程序存儲器容量:144KB（48K x 24） 程序存儲器類型:閃存 EEPROM 大小:4K x 8 RAM 容量:8K x 8 電壓 - 電源 (Vcc/Vdd):2.5 V ~ 5.5 V 數據轉換器:A/D 16x12b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:64-TQFP 包裝:托盤 配用:XLT64PT4-ND - SOCKET TRAN ICE 64MQFP/TQFPAC164313-ND - MODULE SKT FOR PM3 64PF 其它名稱:DSPIC30F601220EPF
TMX320F28069PZPA 功能描述:32位微控制器 - MCU Octave rev 0 RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
TMX320F28069UPFPA 功能描述:IC MCU 32BIT 128KB FLASH 80HTQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:TMS320F2806x, Piccolo™, C2000™ 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA，UART/USART 外圍設備:欠壓檢測/復位，LED，POR，PWM，WDT 輸入/輸出數:16 程序存儲器容量:4KB（4K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND
TMX320F28069UPZPA 功能描述:IC MCU 32BIT 128KB FLSH 100HTQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:TMS320F2806x, Piccolo™, C2000™ 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA，UART/USART 外圍設備:欠壓檢測/復位，LED，POR，PWM，WDT 輸入/輸出數:16 程序存儲器容量:4KB（4K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*