• <dl id="mgqtn"><optgroup id="mgqtn"><li id="mgqtn"></li></optgroup></dl>
    參數資料
    型號: TLV5604IDR
    廠商: TEXAS INSTRUMENTS INC
    元件分類: DAC
    英文描述: SERIAL INPUT LOADING, 8.5 us SETTLING TIME, 10-BIT DAC, PDSO16
    封裝: GREEN, PLASTIC, SOIC-16
    文件頁數: 13/31頁
    文件大?。?/td> 572K
    代理商: TLV5604IDR
    TLV5604
    2.7-V TO 5.5-V 10-BIT 3-
    S QUADRUPLE DIGITAL-TO-ANALOG CONVERTERS
    WITH POWER DOWN
    SLAS176B – DECEMBER 1997 – REVISED JULY 2002
    20
    POST OFFICE BOX 655303
    DALLAS, TEXAS 75265
    APPLICATION INFORMATION
    TLV5604 interfaced to MCS51 microcontroller
    hardware interfacing
    Figure 18 shows an example of how to connect the TLV5604 to an MCS51 Microcontroller. The serial DAC
    input data and external control signals are sent via I/O Port 3 of the controller. The serial data is sent on the RxD
    line, with the serial clock output on the TxD line. Port 3 bits 3, 4, and 5 are configured as outputs to provide the
    DAC latch update (LDAC), chip select (CS) and frame sync (FS) signals for the TLV5604. The active low power
    down pin (PD) of the TLV5604 is pulled high to ensure that the DACs are enabled.
    RxD
    TxD
    P3.3
    P3.4
    MCS
    51
    SDIN
    SCLK
    FS
    CS
    LDAC
    REF
    VDD
    PD
    VOUTA
    VOUTB
    VOUTC
    VOUTD
    VSS
    TLV5604
    P3.4
    REFINAB
    REFINCD
    Figure 18. TLV5604 Interfaced with MCS51
    software
    The example is the same as for the TMS320C203 in this datasheet, but adapted for a MCS
    51 controller. It
    generates a differential in-phase (sine) signal between the VOUTA and VOUTB pins, and it’s quadrature
    (cosine) signal as the differential signal between VOUTC and VOUTD.
    The on-chip timer is used to generate interrupts at a fixed frequency. The related interrupt service routine pulses
    LDAC low to update all 4 DACs simultaneously, then fetches and writes the next sample to all 4 DACs. The
    samples are stored as a look-up table, which describes one full period of a sine wave.
    The serial port of the controller is used in Mode 0, which transmits 8 bits of data on RxD, accompanied by a
    synchronous clock on TxD. Two writes concatenated together are required to write a complete word to the
    TLV5604. The CS and FS signals are provided in the required fashion through control of IO port 3, which has
    bit addressable outputs.
    MCS is a registered trademark of Intel Corporation.
    相關PDF資料
    PDF描述
    TLV5604IPWR SERIAL INPUT LOADING, 8.5 us SETTLING TIME, 10-BIT DAC, PDSO16
    TLV5604CPWG4 SERIAL INPUT LOADING, 8.5 us SETTLING TIME, 10-BIT DAC, PDSO16
    TLV5604ID SERIAL INPUT LOADING, 8.5 us SETTLING TIME, 10-BIT DAC, PDSO16
    TLV5604CPWR SERIAL INPUT LOADING, 8.5 us SETTLING TIME, 10-BIT DAC, PDSO16
    TLV5604CPWLE QUAD, SERIAL INPUT LOADING, 8.5 us SETTLING TIME, 10-BIT DAC, PDSO16
    相關代理商/技術參數
    參數描述
    TLV5604IDRG4 功能描述:數模轉換器- DAC 10-Bit 3 us Quad DAC Serial Input RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
    TLV5604IPW 功能描述:數模轉換器- DAC 10bit Quad Serial D RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
    TLV5604IPW 制造商:Texas Instruments 功能描述:IC 10BIT DAC QUAD SMD TSSOP16
    TLV5604IPW 制造商:Texas Instruments 功能描述:Digital-Analog Converter IC Interface Ty
    TLV5604IPWG4 功能描述:數模轉換器- DAC 10-Bit 3 us Quad DAC Serial Input RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube