- 您現在的位置：買賣IC網 > PDF目錄383955 > TLE6254-2G (INFINEON TECHNOLOGIES AG) Fault Tolerant Differential CAN-Transceiver PDF資料下載
參數資料
| 型號： | TLE6254-2G |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 英文描述： | Fault Tolerant Differential CAN-Transceiver |
| 中文描述： | 容錯微分的CAN收發器 |
| 文件頁數： | 7/24頁 |
| 文件大?。?/td> | 291K |
| 代理商： | TLE6254-2G |
Data Sheet Version 1.4
7
2003-07-22
Final Data TLE 6254-2G
Circuit Description
5.1
Operation Modes, Wake-Up
In addition to the normal operation mode, the TLE 6254-2G offers a receive-only mode
as well as two low power operation modes to save power during periods that do not
require communication on the CAN bus: sleep mode,
V
Bat
stand-by mode (see
Table 2
and
Figure 4
). Via the control input pins NSTB and ENT the operation modes are
selected by the microcontroller. In the low power modes neither receiving nor
transmitting of messages is possible.
In sleep operation mode the lowest power consumption is achieved. In order to minimize
the overall current consumption of the ECU (electronic control unit) the external voltage
regulator (5 V supply) is deactivated by the INH output in this mode, when connected.
For that purpose the INH output is switched to high impedance. In parallel the CANL line
is pulled-up to the battery supply voltage via the RTL output and the pull-up paths at the
input pins TxD and RxD are disabled from the internal supply.
To enter the sleep operation mode the transition mode “Go-to-Sleep” has to be selected
(
Figure 4
) for a minimum time
t
h(min)
. After the minimum hold time
t
h(min)
the sleep mode
can be actively selected. Otherwise the TLE 6254-2G will automatically fall in sleep
mode because of the not powered microcontroller.
On a wake-up request either by bus line activities or via the WAKE input, the transceiver
is automatically set in
V
Bat
-stand-by mode. Now the voltage regulator (5 V supply) is
enabled by the INH output. The WAKE input reacts to both, transition from high to low
voltage level as well as the other way round. To avoid faulty wake-ups due to transients
on the bus lines or the WAKE input circuitry respectively, a certain filter time is
implemented. As soon as
V
CC
is provided, the wake-up request is monitored on both, the
NERR and RxD outputs, by setting them low. Upon this the microcontroller can activate
the normal operation mode by setting the control inputs NSTB and ENT high.
The
V
Bat
stand-by mode corresponds to the sleep mode, but a voltage regulator
connected to the INH output will remain active. Wake-up requests via the WAKE pin or
the bus lines are immediately reported to the microcontroller by setting RxD and NERR
low. A power-on condition (
V
BAT
pin is supplied) automatically switches the TLE 6254-2G
to
V
Bat
stand-by mode.
In the receive-only mode data on the CAN-bus are transvered to the RxD output, but both
output stages, CANH as well as CANL are disabled. This means that data at the TxD
input are not transmitted to the CAN bus. This mode is useful in combination to a
dedicated network-management software that allows separate diagnosis for all nodes.
A wake-up request in the receive-only mode is only reported at the RxD-output. The
NERR output in this mode is used to indicate a battery fail condition. When entering the
normal mode the
V
bat
-flag is reset and the NERR output becomes high again. This
feature is useful e.g. when changing the ECU and therefore a presetting routine of the
microcontroller has to be started.
相關PDF資料 |
PDF描述 |
|---|---|
| TLE6255G | Single Wire CAN-Transceiver |
| TLE6259-2 | Single-Wire-Transceiver |
| TLE6259-2G | Single-Wire-Transceiver |
| TLE6262G | Fault Tolerant CAN - LDO |
| TLE6263 | LS CAN, LDO and HS Switch |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE6254-3G | 功能描述:網絡控制器與處理器 IC FAULT TOLERANT LW SPEED CAN-TRANSCEIVE RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| TLE6254-3G_07 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Fault Tolerant Low Speed CAN-Transceiver |
| TLE62543GNT | 制造商:Infineon Technologies AG 功能描述:CAN 125KBd Sleep/Standby 5V/9V/12V/15V/18V/24V 14-Pin DSO T/R |
| TLE62543GT | 制造商:Infineon Technologies AG 功能描述:CAN 125KBd Sleep/Standby 5V/9V/12V/15V/18V/24V 14-Pin DSO T/R |
| TLE62543GXUMA1 | 制造商:Infineon Technologies AG 功能描述:CAN 125KBd Sleep/Standby 5V/9V/12V/15V/18V/24V 14-Pin DSO T/R 制造商:Infineon Technologies AG 功能描述:TRANSCEIVER - Tape and Reel 制造商:Infineon Technologies AG 功能描述:TXRX CAN FAULT TOLERANT PDSO-14 |
發布緊急采購，3分鐘左右您將得到回復。