參數資料
型號: TLE6217
廠商: INFINEON TECHNOLOGIES AG
英文描述: MOSFET N-CH 500V 4.5A TO-262
中文描述: 智能四通道低側開關
文件頁數: 8/20頁
文件大小: 207K
代理商: TLE6217
Preliminary Datasheet TLE 6217
V5
Page 8 of 20
30. 07. 2002
Application Description
This IC is especially designed to drive inductive loads (relays, electromagnetic valves).
Integrated clamp-diodes limit the output voltage when inductive loads are discharged.
Four open-drain logic outputs indicate the status of the integrated circuit. The following conditions are
monitored and signalled:
- Overloading of output (also shorted load to supply) in active mode
- Open and shorted load to ground in active and inactive mode
- Overtemperature
Circuit Description
Input Circuits
The control and enable inputs, both active high, consist of schmitt triggers with hysteresis. All inputs are
provided with pull-down current sources. Not connected inputs are interpreted as low and the respective
output stages are switched off.
In standby mode (STBY = LOW) the current consumption is greatly reduced.
The circuit is active when STBY = HIGH.
If the standby function is not used, it is allowed to connect the standby pin directly to VS.
Status Signals: The status signals are undefined for 2ms after a power up event or a STBY low to high
transition.
Output Stages
The four power outputs consist of DMOS-power transistors with open drains. The output stages are
short circuit protected throughout the operating range. Each output has it's own zenerclamp. This
causes a voltage limitation at the power transistor when inductive loads are switched off.
Parallel to the DMOS transistors there are internal pull down current sources. They are provided to de-
tect an open load condition in the off state. They will be disconnected in the standby mode.
Due to EMI measures there is an internal zenerclamp in parallel to the output stage. It gets active above
33V drain source voltage. This leads to an increasing leakage current up to 1 mA @ V
DS
= 40V.
Protective Circuits
The outputs are protected against current overload and overtemperature. If the output current increases
above the overload detection threshold I
QO
for a longer time then t
DSO
or the temperature increases
above T
th
, then the power transistor is immediately switched off. It remains off until the control signal at
the input is switched off and on again.
Fault Detection
The status outputs indicate the switching state of the output stage. Under normal conditions is: ST = low
Output off; ST = high
Output on. If an error occurs, the logic level of the status output is inverted,
as listed in the diagnostic table.
If current overload or overtemperature occurs for a longer time than t
DSO
, the fault condition is latched
into an internal register and the output is shutdown. The reset is done by switching off the corresponding
control input for a time longer than t
D-IN
.
相關PDF資料
PDF描述
TLE6217C Smart Quad Channel Low-Side Switch
TLE6217G Smart Quad Channel Low-Side Switch
TLE6220 Smart Quad Low-Side Switch
TLE6220GP Smart Quad Low-Side Switch
TLE6225 Smart Quad Low-Side Switch
相關代理商/技術參數
參數描述
TLE6217C 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Smart Quad Channel Low-Side Switch
TLE6217G 功能描述:電源開關 IC - 配電 SMART HIGH/LOW SIDE SWITCHES RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻(最大值):85 mOhms 開啟時間(最大值):400 us 關閉時間(最大值):20 us 工作電源電壓:3.2 V to 6.5 V 電源電流(最大值): 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5
TLE6217G_08 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Smart Quad Channel Low-Side Switch
TLE6217GAUMA1 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 3A 20-Pin DSO EP 制造商:Infineon Technologies AG 功能描述:ENGINECONTROL_IC - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC LOW SIDE SWITCH 4CHAN PDSO-20
TLE6217GNT 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 3A 20-Pin DSO EP T/R