- 您現在的位置：買賣IC網 > PDF目錄98229 > THS7364IPW (TEXAS INSTRUMENTS INC) 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 PDF資料下載
參數資料
| 型號： | THS7364IPW |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
| 封裝： | GREEN, PLASTIC, TSSOP-20 |
| 文件頁數： | 24/47頁 |
| 文件大?。?/td> | 1134K |
| 代理商： | THS7364IPW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
Level
Shift
Internal
Circuitry
+V
S
800kW
Input
Pin
Input
0.1 mF
g
m
+V
S
STCLPF
SBOS530 – AUGUST 2010
www.ti.com
INPUT MODE OF OPERATION: AC SYNC TIP
CLAMP
Some video DACs or encoders are not referenced to
ground but rather to the positive power supply. The
resulting video signals are generally at too great a
voltage for a dc-coupled video buffer to function
properly. To account for this scenario, the THS7364
incorporates a sync-tip clamp circuit. This function
requires a capacitor (nominally 0.1 mF) to be in series
with the input. Although the term sync-tip-clamp is
used throughout this document, it should be noted
that the THS7364 would probably be better termed as
Figure 79. Equivalent AC Sync-Tip-Clamp Input
a dc restoration circuit based on how this function is
Circuit
performed. This circuit is an active clamp circuit and
not a passive diode clamp function.
While this feature may not fully eliminate overshoot
The input to the THS7364 has an internal control loop
issues on the input signal, in cases of extreme
that sets the lowest input applied voltage to clamp at
overshoot and/or ringing, the STC system should help
ground (0 V). By setting the reference at 0 V, the
minimize improper clamping levels. As an additional
THS7364 allows a dc-coupled input to also function.
method to help minimize this issue, an external
Therefore, the sync-tip-clamp (STC) is considered
capacitor (for example, 10 pF to 47 pF) to ground in
transparent because it does not operate unless the
parallel with the external termination resistors can
input signal goes below ground. The signal then goes
help filter overshoot problems.
through the same 150-mV level shifter, resulting in an
output voltage low level of 300 mV. If the input signal
It should be noted that this STC system is dynamic
tries to go below 0 V, the THS7364 internal control
and does not rely upon timing in any way. It only
loop sources up to 6 mA of current to increase the
depends on the voltage that appears at the input pin
input voltage level on the THS7364 input side of the
at any given point in time. The STC filtering helps
coupling capacitor. As soon as the voltage goes
minimize
level
shift
problems
associated
with
above the 0-V level, the loop stops sourcing current
switching noises or very short spikes on the signal
and becomes very high impedance.
line. This architecture helps ensure a very robust
STC system.
One of the concerns about the sync-tip-clamp level is
how the clamp reacts to a sync edge that has
When the ac STC operation is used, there must also
overshoot—common in VCR signals, noise, DAC
be some finite amount of discharge bias current. As
overshoot, or reflections found in poor printed circuit
previously described, if the input signal goes below
board (PCB) layouts. Ideally, the STC should not
the 0-V clamp level, the internal loop of the THS7364
react to the overshoot voltage of the input signal.
sources current to increase the voltage appearing at
Otherwise, this response could result in clipping on
the input pin. As the difference between the signal
the rest of the video signal because it may raise the
level and the 0-V reference level increases, the
bias voltage too much.
amount
of
source
current
increases
proportionally—supplying up to 6 mA of current.
To help minimize this input signal overshoot problem,
Thus, the time to re-establish the proper STC voltage
the control loop in the THS7364 has an internal
can be very fast. If the difference is very small, then
low-pass filter, as shown in Figure 79. This filter
the source current is also very small to account for
reduces the response time of the STC circuit. This
minor voltage droop.
delay is a function of how far the voltage is below
ground, but in general it is approximately a 400-ns
However, what happens if the input signal goes
delay for the SD channel filters and approximately a
above the 0-V input level? The problem is the video
150-ns delay for the FHD filters. The effect of this
signal is always above this level and must not be
filter is to slow down the response of the control loop
altered in any way. Thus, if the sync level of the input
so as not to clamp on the input overshoot voltage but
signal is above this 0-V level, then the internal
rather the flat portion of the sync signal.
discharge (sink) current reduces the ac-coupled bias
signal to the proper 0-V level.
As a result of this delay, sync may have an apparent
voltage shift. The amount of shift depends on the
amount of droop in the signal as dictated by the input
capacitor and the STC current flow. Because sync is
used primarily for timing purposes with syncing
occurring on the edge of the sync signal, this shift is
transparent in most systems.
30
Copyright 2010, Texas Instruments Incorporated
Product Folder Link(s): THS7364
相關PDF資料 |
PDF描述 |
|---|---|
| THS7365IPWR | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
| THS7365IPW | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
| THS7368IPWR | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
| THS7368IPW | 6 CHANNEL, VIDEO AMPLIFIER, PDSO20 |
| THS7372IPWR | 4 CHANNEL, VIDEO AMPLIFIER, PDSO14 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS7364IPWR | 功能描述:視頻放大器 6-Ch Video Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| THS7365 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:6-Channel Video Amplifier with 3-SD and 3-HD Sixth-Order Filters and 6-dB Gain |
| THS7365EVM | 功能描述:放大器 IC 開發工具 THS7365EVM Eval Mod RoHS:否 制造商:International Rectifier 產品:Demonstration Boards 類型:Power Amplifiers 工具用于評估:IR4302 工作電源電壓:13 V to 23 V |
| THS7365IPW | 功能描述:視頻放大器 6Ch Video Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| THS7365IPWR | 功能描述:視頻放大器 6Ch Video Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。