
www.ti.com
DESIGN TOOLS
Evaluation
Information
Fixtures
and
Application
Support
P
Dmax
T
max
–T
A
JA
where
:
P
Dmax
is the maximum power dissipation in the amplifier (W).
T
max
is the absolute maximum junction temperature (
°
C)
.
T
A
is the ambient temperature (
°
C).
θ
JA
=
θ
JC
+
θ
CA
θ
JC
is the thermal coefficient from the silicon junctions to
the case (
°
C/W).
θ
CA
is the thermal coefficient from the case to ambient air
(
°
C/W).
4
3
2
0
-40
-20
T
A
- Ambient Temperature -
°
C
0
20
-
P
5
6
7
40
60
80
16-Pin RGT Package
θ
JA
= 39.5
°
C/W for 16-Pin MSOP (RGT)
T
J
= 150
°
C, No Airflow
1
THS4302
SLOS403G–OCTOBER 2002–REVISED JANUARY 2005
The thermal characteristics of the device are dictated
by the package and the PC board. For a given
Θ
JA
,
maximum power dissipation for a package can be
calculated using the following formula.
When determining whether or not the device satisfies
the maximum power dissipation requirement, it is
important to consider not only quiescent power dissi-
pation, but also dynamic power dissipation. Often
maximum power is difficult to quantify because the
signal pattern is inconsistent, but an estimate of the
RMS power dissipation can provide visibility into a
possible problem.
Texas Instruments is committed to providing its cus-
tomers with the highest quality of applications sup-
port. To support this goal, an evaluation board has
been developed for the THS4302 operational ampli-
fier. The evaluation board is available and easy to
use allowing for straight-forward evaluation of the
device. This evaluation board can be obtained by
ordering through the Texas Instruments Web site,
www.ti.com, or through your local Texas Instruments
Sales Representative. A schematic for the evaluation
board with default component values is shown in
vide insight into design flexibility(1)
The THS4302 is offered in a 16-pin leadless MSOP
with PowerPAD. The thermal coefficient for the
MSOP PowerPAD package is substantially improved
over
the
traditional
packages.
dissipation levels are depicted in the graph below.
The data for the RGT package assumes a board
layout that follows the PowerPAD layout guidelines
referenced above and detailed in the PowerPAD
application notes in the
Additional Reference Material
section at the end of the data sheet.
Maximum
power
Computer simulation of circuit performance using
SPICE is often useful when analyzing the perform-
ance of analog circuits and systems. This is particu-
larly true for video and RF amplifier circuits where
parasitic capacitance and inductance can have a
major effect on circuit performance. A SPICE model
for the THS4500 family of devices is available
through the Texas Instruments web site (
www.ti.com
).
The Product Information Center (PIC) is available for
design assistance and detailed product information.
These models do a good job of predicting small
signal ac and transient performance under a wide
variety of operating conditions. They are not intended
to model the distortion characteristics of the amplifier,
nor do they attempt to distinguish between the
package types in their small signal ac performance.
Detailed information about what is and is not modeled
is contained in the model file itself.
Figure 51. Maximum Power Dissipation vs
Ambient Temperature
19