- 您現在的位置：買賣IC網 > PDF目錄98189 > TDA2030-TB5-T (UNISONIC TECHNOLOGIES CO LTD) 14 W, 1 CHANNEL, AUDIO AMPLIFIER, ZFM5 PDF資料下載
參數資料
| 型號： | TDA2030-TB5-T |
| 廠商： | UNISONIC TECHNOLOGIES CO LTD |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 14 W, 1 CHANNEL, AUDIO AMPLIFIER, ZFM5 |
| 封裝： | TO-220B, 5 PIN |
| 文件頁數： | 12/13頁 |
| 文件大?。?/td> | 207K |
| 代理商： | TDA2030-TB5-T |
TDA2030
LINEAR INTEGRATED CIRCUIT
UNISONICTECHNOLOGIESCO.,LTD
8 of 13
www.unisonic.com.tw
QW-R107-004,D
MULTIWAY SPEAKER SYSTEMS AND ACTIVE BOXES
Multiway loudspeaker systems provide the best possible acoustic performance since each loudspeaker is
specially designed and optimized to handle a limited range of frequencies. Commonly, these loudspeaker systems
divide the audio spectrum two or three bands.
To maintain a flat frequency response over the Hi-Fi audio range the bands cobered by each loudspeaker must
overlap slightly. Imbalance between the loudspeakers produces unacceptable results therefore it is important to
ensure that each unit generates the correct amount of acoustic energy for its segments of the audio spectrum. In this
respect it is also important to know the energy distribution of the music spectrum to determine the cutoff frequencies
of the crossover filters(see Fig. 2).As an example, a 100W three-way system with crossover frequencies of 400Hz
and 3KHz would require 50W for the woofer,35W for the midrange unit and 15W for the tweeter.
Both active and passive filters can be used for crossovers but active filters cost significantly less than a good
passive filter using aircored inductors and non-electrolytic capacitors. In addition active filters do not suffer from the
typical defects of passive filters:
--Power less;
--Increased impedance seen by the loudspeaker(lower damping)
--Difficulty of precise design due to variable loudspeaker impedance.
Obviously, active crossovers can only be used if a power amplifier is provide for each drive unit. This makes it
particularly interesting and economically sound to use monolithic power amplifiers.
In some applications complex filters are not relay necessary and simple RC low-pass and high-pass
networks(6dB/octave) can be recommended.
The result obtained are excellent because this is the best type of audio filter and the only one free from phase and
transient distortion.
The rather poor out of band attenuation of single RC filters means that the loudspeaker must operate linearly well
beyond the crossover frequency to avoid distortion.
A more effective solution is shown in Fig. 3.
The proposed circuit can realize combined power amplifiers and 12dB/octave or high-pass or low-pass filters.
In proactive, at the input pins amplifier two equal and in-phase voltages are available, as required for the active
filter operations.
The impedance at the Pin(-) is of the order of 100
,while that of the Pin (+) is very high, which is also what was
wanted.
The components values calculated for fc=900Hz using a Bessel 3rd Sallen and Key structure are:
C1=C2=C3=22nF,R1=8.2K
,R2=5.6K,R3=33K.
Using this type of crossover filter, a complete 3-way 60W active loudspeaker system is shown in Fig. 20.
It employs 2nd order Buttherworth filter with the crossover frequencies equal to 300Hz and 3kHz.
The midrange section consistors of two filters a high pass circuit followed by a low pass network. With Vs=36V the
output power delivered to the woofer is 25W at d=0.06%( 30W at d=0.5%).The power delivered to the midrange and
the tweeter can be optimized in the design phase taking in account the loudspeaker efficiency and impedance
(RL=4
to 8).
相關PDF資料 |
PDF描述 |
|---|---|
| TDA2030L-TA5-T | 14 W, 1 CHANNEL, AUDIO AMPLIFIER, SFM5 |
| TDA2030L-TB5-T | 14 W, 1 CHANNEL, AUDIO AMPLIFIER, ZFM5 |
| TDA2030A-TA5-T | 18 W, 1 CHANNEL, AUDIO AMPLIFIER, SFM5 |
| TDA2030A-TB5-T | 18 W, 1 CHANNEL, AUDIO AMPLIFIER, ZFM5 |
| TDA2030AL-TA5-T | 18 W, 1 CHANNEL, AUDIO AMPLIFIER, SFM5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA2030V | 功能描述:音頻放大器 14W Hi-Fi Audio Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TDA2030V | 制造商:STMicroelectronics 功能描述:IC AUDIO AMP 14W |
| TDA2030音頻功率放大器 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TDA2030音頻功率放大器 |
| TDA2039 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TDA2039具有靜音和待機功能的8W單聲道或4W雙聲道音頻功放電路. |
| TDA2039A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TDA2039 是一塊具有靜音和待機功能的8W 單聲道或4W 雙聲道音頻功放電路，該電路最適合用在多媒體音響和電視伴音系統。TDA2039A可以根據要求使用立體聲和BTL 單聲道功能，TDA2039B只能使用BTL 單聲道功能。 |
發布緊急采購，3分鐘左右您將得到回復。