參數資料
型號: TC500CPE
廠商: Microchip Technology
文件頁數: 10/38頁
文件大?。?/td> 0K
描述: IC ANALOG FRONT END 16BIT 16DIP
標準包裝: 30
位數: 16
通道數: 1
功率(瓦特): 10mW
電壓 - 電源,模擬: 5V
電壓 - 電源,數字: 4.5 V ~ 7.5 V
封裝/外殼: 16-DIP(0.300",7.62mm)
供應商設備封裝: 16-PDIP
包裝: 管件
產品目錄頁面: 673 (CN2011-ZH PDF)
其它名稱: 158-1021
158-1021-ND
TC500/A/510/514
DS21428E-page 18
2008 Microchip Technology Inc.
8.6
Integrator Output Zero Phase
The comparator delay and the controller’s response
latency may result in overshoot, causing charge
buildup on the integrator at the end of a conversion.
This charge must be removed or performance will
degrade. The integrator output zero phase should be
activated (AB = 00) until CMPTR goes high. It is
absolutely critical that this phase be terminated
immediately so that overshoot is not allowed to occur in
the opposite direction. At this point, it can be assured
that the integrator is near zero. Auto-zero should be
entered (AB = 01) and the TC5XX held in this state until
the next cycle is begun (see Figure 8-2).
FIGURE 8-2:
Overshoot.
8.7
Using the TC510/TC514
8.7.1
NEGATIVE SUPPLY VOLTAGE
CONVERTER (TC510, TC514)
A capacitive charge pump is employed to invert the
voltage on VDD for negative bias within the TC510/
TC514. This voltage is also available on the VOUT– pin
to provide negative bias elsewhere in the system. Two
external capacitors are required to perform the
conversion.
Timing is generated by an internal state machine driven
from an on-board oscillator. During the first phase,
capacitor CF is switched across the power supply and
charged to VS+. This charge is transferred to capacitor
COUT– during the second phase. The oscillator
normally runs at 100 kHz to ensure minimum output
ripple. This frequency can be reduced by placing a
capacitor from OSC to VDD. The relationship between
the capacitor value is shown in Section 2.0 “Typical
.
8.7.2
ANALOG INPUT MULTIPLEXER
(TC514)
The TC514 is equipped with a four-input differential
analog multiplexer. Input channels are selected using
select inputs (A1, A0). These are high-true control
signals (i.e., channel 0 is selected when (A1, A0 = 00).
Integrator
Output
Comparator
Output Comp
Integrate
Phase
De-integrate Phase
Integrator
Zero Phase
Zero
Crossing
Overshoot
相關PDF資料
PDF描述
MCP3901A0-E/ML IC AFE 24BIT 64KSPS 2CH 20QFN
MCP3901A0-E/SS IC ENERGY METER AFE 2CH 20-SSOP
VI-B34-IV-S CONVERTER MOD DC/DC 48V 150W
MCP3901A0-I/ML IC AFE 24BIT 64KSPS 20-QFN
MCP3911A0-E/ML IC AFE 24BIT 125KSPS 2CH 20-QFN
相關代理商/技術參數
參數描述
TC500CPE 制造商:Microchip Technology Inc 功能描述:A/D Converter (A-D) IC
TC500CPF 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Precision Analog Front Ends with Dual Slope ADC
TC500CPJ 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Precision Analog Front Ends with Dual Slope ADC
TC500IJE 功能描述:電信線路管理 IC 16 Bit Analog Proces RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
TC500IOE 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Precision Analog Front Ends with Dual Slope ADC