th July 2011 33 www.semtech.com SX8654/SX8655/SX8656 H" />
參數資料
型號: SX8655IWLTRT
廠商: Semtech
文件頁數: 27/62頁
文件大?。?/td> 0K
描述: IC TOUCH SCREEN 12BIT 20QFN
標準包裝: 1
類型: 電阻式,觸感驅動器
觸摸面板接口: 4,5 線
輸入數/鍵: 1 TSC,雨刷,鑰匙
分辨率(位): 12 b
評估套件: *
數據接口: I²C,串行
電壓基準: 內部
電源電壓: 2.3 V ~ 3.6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 20-WFQFN 裸露焊盤
供應商設備封裝: 20-QFN(4x4)
包裝: 標準包裝
其它名稱: SX8655IWLDKR
ADVANCED COMMUNICATIONS & SENSING
Rev 1 – 25
th July 2011
33
www.semtech.com
SX8654/SX8655/SX8656
Haptics Enabled 4/5-Wire
Resistive Touchscreen Controller with Proximity Sensing
5.4
Host Operation
5.4.1
General Description
If PROXIRQSEL = 0, an interrupt can be triggered when the user is detected to be close, detected to be far, or
both (PROXCLOSEIRQEN, PROXFARIRQEN).
Figure 41 – Proximity Sensing Host Operation (Pen Trigger Mode ; RegIrqMsk[6:4] = 110 ; PROXIRQSEL = 0)
If PROXIRQSEL = 1, instead of the proximity “Far” state, an interrupt can be triggered at the end of each
proximity sensing
operation
indicating
to
the
host
when
the
proximity sensing
block
is
running
(PROXCONVDONEIRQEN). This may be used by the host to synchronize noisy system operations or to read
PROXRAW, PROXUSEFUL, PROXAVG, PROXDIFF synchronously for monitoring purposes.
Figure 42 – Proximity Sensing Host Operation (Pen Trigger Mode ; RegIrqMsk[6:4] = 010 ; PROXIRQSEL = 1)
In both cases above, an interrupt can also be triggered at the end of compensation (PROXCOMPDONEEN).
5.4.2
Proximity Sensing vs Touch Operations
As previously mentioned, touch and proximity operations share the same ADC and hence the chip implements
time multiplexing between these two types of operations. Also, proximity sensing doesn’t need to be performed
while pen is down (not needed as host knows already something touches the screen).
In all operating modes, if PROXSCANPERIOD = 0, no proximity operation is performed (i.e. §4.6). The following
hence assumes PROXSCANPERIOD != 0. For simplicity we also assume that NIRQ is only used for reporting
touch operations i.e. RegIrqMsk[6:4] = 000 (PROXSTAT mapped to AUX pin, or polled via I2C).
In MAN mode, a CONVERT command (if not preceded by a SELECT command) will perform a proximity
sensing operation before the touchscreen operation, whatever the pen status. Hence please note that if the
Pen Detection
NIRQ
I2C Read RegIrqSrc
Proximity Sensing (Analog + Digital)
PROXSTAT
CONVSTAT
PROXSCANPERIOD
tick
User in range
User out of range
Pen Detection
NIRQ
I2C Read RegIrqSrc
Proximity Sensing (Analog + Digital)
PROXSTAT
CONVSTAT
PROXSCANPERIOD
tick
User in range
User out of range
相關PDF資料
PDF描述
LDS6128NQGI8 IC SENSOR TCH PURETOUCH 40VFQFPN
LDS6104NQGI8 IC SENSOR TCH PURETOUCH 28VFQFPN
D38999/24WG39SC CONN RCPT 39POS JAM NUT W/SCKT
MS3120E20-41PW CONN RCPT 41POS WALL MNT W/PINS
LDS6000PYGI8 IC SENSOR TCH PURETOUCH 28SSOP
相關代理商/技術參數
參數描述
SX8656ICSTRT 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Haptics Enabled 4/5-Wire Resistive Touchscreen Controller with Proximity Sensing
SX8656IWLTRT 功能描述:IC TOUCH SCREEN 12BIT 20QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:- 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率(位):- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS,BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
SX8657 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Haptics Enabled 4/5-Wire Resistive Touchscreen Controller with Proximity Sensing
SX8657ICSTRT 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Haptics Enabled 4/5-Wire Resistive Touchscreen Controller with Proximity Sensing
SX8657IWLTRT 功能描述:IC TOUCH SCREEN 12BIT 20QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:- 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率(位):- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS,BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)