- 您現在的位置：買賣IC網 > PDF目錄383840 > ST7LITE09Y0M6 FUSE, FORK LIFT TRUCK, 250A; Current, fuse rating:250A; Voltage rating, DC:80V; Approval category:DIN 43560/1; Depth, external:20mm; Height:1mm; Length / Height, external:0.5mm; Width, external:82mm RoHS Compliant: Yes PDF資料下載
參數資料
| 型號： | ST7LITE09Y0M6 |
| 英文描述： | FUSE, FORK LIFT TRUCK, 250A; Current, fuse rating:250A; Voltage rating, DC:80V; Approval category:DIN 43560/1; Depth, external:20mm; Height:1mm; Length / Height, external:0.5mm; Width, external:82mm RoHS Compliant: Yes |
| 中文描述： | ST7LITE0。 ST7SUPERLITE - 8位微控制器單電壓閃存。數據EEPROM。 ADC的。定時器。的SPI |
| 文件頁數： | 13/122頁 |
| 文件大?。?/td> | 1716K |
| 代理商： | ST7LITE09Y0M6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁
ST7LITE0, ST7SUPERLITE
13/122
FLASH PROGRAM MEMORY
(Cont’d)
4.4 ICC interface
ICP needs a minimum of 4 and up to 6 pins to be
connected to the programming tool. These pins
are:
– RESET: device reset
– V
SS
: device power supply ground
– ICCCLK: ICC output serial clock pin
– ICCDATA: ICC input serial data pin
– CLKIN: main clock input for external source
– V
: application board power supply (option-
al, see Note 3)
Notes:
1. If the ICCCLK or ICCDATA pins are only used
as outputs in the application, no signal isolation is
necessary. As soon as the Programming Tool is
plugged to the board, even if an ICC session is not
in progress, the ICCCLK and ICCDATA pins are
not available for the application. If they are used as
inputs by the application, isolation such as a serial
resistor has to be implemented in case another de-
vice forces the signal. Refer to the Programming
Tool documentation for recommended resistor val-
ues.
2. During the ICP session, the programming tool
must control the RESET pin. This can lead to con-
flicts between the programming tool and the appli-
Figure 5. Typical ICC Interface
cation reset circuit if it drives more than 5mA at
high level (push pull output or pull-up resistor<1K).
A schottky diode can be used to isolate the appli-
cation RESET circuit in this case. When using a
classical RC network with R>1K or a reset man-
agement IC with open drain output and pull-up re-
sistor>1K, no additional components are needed.
In all cases the user must ensure that no external
reset is generated by the application during the
ICC session.
3. The use of Pin 7 of the ICC connector depends
on the Programming Tool architecture. This pin
must be connected when using most ST Program-
ming Tools (it is used to monitor the application
power supply). Please refer to the Programming
Tool manual.
4. Pin 9 has to be connected to the CLKIN pin of
the ST7 when the clock is not available in the ap-
plication or if the selected clock option is not pro-
grammed in the option byte.
5. During reset, this pin must be held at high level
to avoid entering ICC mode unexpectedly (this is
guaranteed by the internal pull-up if the application
leaves the pin floating).
ICC CONNECTOR
HE10 CONNECTOR TYPE
I
I
R
V
APPLICATION
POWER SUPPLY
1
2
4
6
8
10
9
7
5
3
PROGRAMMING TOOL
ICC CONNECTOR
APPLICATION BOARD
ICC Cable
OPTIONAL
(See Note 3)
ST7
C
OPTIONAL
(See Note 4)
See Note 1
See Notes 1 and 5
See Note 2
APPLICATION
RESET SOURCE
APPLICATION
I/O
1
相關PDF資料 |
PDF描述 |
|---|---|
| ST7LITE10F1B6 | ST7LITE1 - 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY.DATA EEPROM. ADC. 4 TIMERS. SPI |
| ST7LITE10F1M6 | FUSE PULLER/TESTERFUSE PULLER/TESTER; Depth, external:15mm; Length:60mm; Voltage rating, AC:24V; Voltage rating, DC:24V; Width, external:20mm |
| ST7LITE15F1B6 | CLIP FUSE 10A 5X20MM PC MOUNT |
| ST7LITE15F1M6 | CLIP FUSE 15A VERT ATO PC MOUNT |
| ST7LITE19F1B6 | FUSE CLIP 3AG SLDR LUG TIN BRASS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST7LITE0X | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT MICROCONTROLLER WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI |
| ST7LITE0XY0 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-bit microcontroller with single voltage Flash memory, data EEPROM, ADC, timers, SPI |
| ST7LITE1 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 4 TIMERS, SPI |
| ST7LITE10F1B6 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ST7LITE1 - 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY.DATA EEPROM. ADC. 4 TIMERS. SPI |
| ST7LITE10F1M6 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ST7LITE1 - 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY.DATA EEPROM. ADC. 4 TIMERS. SPI |
發布緊急采購，3分鐘左右您將得到回復。