- 您現在的位置：買賣IC網 > PDF目錄383837 > ST16C554CQ64 (EXAR CORP) Linear Voltage Regulator IC; Output Current Max:350mA; Supply Voltage Max:6V; Package/Case:8-TSSOP; Current Rating:350mA; Leaded Process Compatible:No; Output Voltage Max:2.8V; Peak Reflow Compatible (260 C):No PDF資料下載
參數資料
| 型號： | ST16C554CQ64 |
| 廠商： | EXAR CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Linear Voltage Regulator IC; Output Current Max:350mA; Supply Voltage Max:6V; Package/Case:8-TSSOP; Current Rating:350mA; Leaded Process Compatible:No; Output Voltage Max:2.8V; Peak Reflow Compatible (260 C):No |
| 中文描述： | 4 CHANNEL(S), 1.5M bps, SERIAL COMM CONTROLLER, PQFP64 |
| 封裝： | 10 X 10 MM, 1.40 MM HEIGHT, LQFP-64 |
| 文件頁數： | 15/40頁 |
| 文件大?。?/td> | 518K |
| 代理商： | ST16C554CQ64 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
ST16C554/554D/68C554
15
Rev. 3.10
DMA Operation
The 554D FIFO trigger level provides additional
flexibility to the user for block mode operation. LSR
bits 5-6 provide an indication when the transmitter is
empty or has an empty location(s). The user can
optionally operate the transmit and receive FIFOs in
the DMA mode (FCR bit-3). When the transmit and
receive FIFOs are enabled and the DMA mode is
deactivated (DMA Mode 0), the 554D activates the
interrupt output pin for each data transmit or receive
operation. When DMA mode is activated (DMA Mode
1), the user takes the advantage of block mode
operation by loading or unloading the FIFO in a block
sequence determined by the preset trigger level. In
this mode, the 554D sets the interrupt output pin when
characters in the transmit FIFOs are below the trans-
mit trigger level, or the characters in the receive FIFOs
are above the receive trigger level.
Loopback Mode
The internal loopback capability allows onboard diag-
nostics. In the loopback mode the normal modem
interface pins are disconnected and reconfigured for
loopback internally. MCR register bits 0-3 are used for
controlling loopback diagnostic testing. In the
loopback mode OP1 and OP2 in the MCR register
(bits 3/2) control the modem -RI and -CD inputs
respectively. MCR signals -DTR and -RTS (bits 0-1)
are used to control the modem -CTS and -DSR inputs
respectively. The transmitter output (TX) and the
receiver input (RX) are disconnected from their asso-
ciated interface pins, and instead are connected to-
gether internally (See Figure 12). The -CTS, -DSR, -
CD, and -RI are disconnected from their normal
modem control inputs pins, and instead are connected
internally to -DTR, -RTS, -OP1 and -OP2. Loopback
test data is entered into the transmit holding register
via the user data bus interface, D0-D7. The transmit
UART serializes the data and passes the serial data to
the receive UART via the internal loopback connec-
tion. The receive UART converts the serial data back
into parallel data that is then made available at the
user data interface, D0-D7. The user optionally com-
pares the received data to the initial transmitted data
for verifying error free operation of the UART TX/RX
circuits.
In this mode, the receiver and transmitter interrupts
are fully operational. The Modem Control Interrupts
are also operational. However, the interrupts can only
be read using lower four bits of the Modem Control
Register (MCR bits 0-3) instead of the four Modem
Status Register bits 4-7. The interrupts are still con-
trolled by the IER.
相關PDF資料 |
PDF描述 |
|---|---|
| ST16C554DCQ64 | QUAD UART WITH 16-BYTE FIFOS |
| ST16C554 | Quad UART with 16-Byte FIFO(四通用異步接收器/發送器（帶16字節的先進先出）) |
| ST16C554D | Quad UART with 16-Byte FIFO(四通用異步接收器/發送器（帶16字節的先進先出）) |
| ST16C580 | UART WITH 16-BYTE FIFO’s AND INFRARED (IrDA) ENCODER/DECODER |
| ST16C580CQ48 | UART WITH 16-BYTE FIFO’s AND INFRARED (IrDA) ENCODER/DECODER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST16C554CQ64-F | 功能描述:UART 接口集成電路 2.97V-5.5V 16B FIFO temp 0C to 70C; UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| ST16C554D | 制造商:EXAR 制造商全稱:EXAR 功能描述:QUAD UART WITH 16-BYTE FIFOS |
| ST16C554DCJ | 制造商:Exar Corporation 功能描述: |
| ST16C554DCJ68 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述: 制造商:Exar Corporation 功能描述:IC,UART,LDCC,68PIN,PLASTIC |
| ST16C554DCJ-68 | 制造商:Exar Corporation 功能描述:IC,UART,LDCC,68PIN,PLASTIC |
發布緊急采購，3分鐘左右您將得到回復。