- 您現在的位置：買賣IC網 > PDF目錄385860 > SRC4184 4-Channel, Asynchronous Sample Rate Converter PDF資料下載
參數資料
| 型號： | SRC4184 |
| 英文描述： | 4-Channel, Asynchronous Sample Rate Converter |
| 中文描述： | 4通道，異步采樣率轉換器 |
| 文件頁數： | 27/40頁 |
| 文件大小： | 508K |
| 代理商： | SRC4184 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
"#$%#
SBFS026A JUNE 2004 REVISED JULY 2004
www.ti.com
27
Figure 8 illustrates the protocol for register write and read
operations via the SPI port. Figure 9 shows the critical
timing parameters for the SPI port interface, which are
listed in the Electrical Characteristics table.
Byte 0 indicates the register bank, register address, and
read/write status for the operation. The functions
contained within this byte are clearly shown in Figure 8. It
should be noted that either one or both of the SRC A and
SRC B register banks may be written to in the same
operation, but only one bank can be selected at any time
for a read operation. Byte 1 is a
don’t care
byte. This byte
is included in the protocol in order to maintain compatibility
with current and future Texas Instruments’ digital audio
interface products, including the DIT4096, DIT4192, and
SRC4193. Bytes 0 and 1 are followed by register data
bytes.
As shown in Figure 8, a write or read operation starts by
bringing the CS input low. Bytes 0, 1, and 2 are then written
to write or read a single register. Byte 2 is not needed for
reading registers, so the CDIN pin can be forced low after
Byte 0 for a read operation. Bringing the CS input high after
the third byte will write or read a single register address.
However, if CS remains low after writing or reading the first
control or status byte, the port will automatically increment
the address by 1, allowing successive addresses to be
written or read sequentially. The address is automatically
incremented by 1 after each byte is written or read, as long
as the CS input remains low. This is referred to as
Auto-Increment operation, and is always enabled for the
SPI port.
Set CS = 1 here to write/read one register location.
Keep CS = 0 to enable the autoincrement mode.
Byte 0
HiZ
Byte 1
HiZ
Byte 2
Data for A[2:0]
Byte 3
Data for A[2:0] + 1
Byte N
Data for A[2:0] + N
CS
CDIN
CDOUT
CCLK
Byte 0:
Byte 1: Don’t Care
Byte 2 through Byte N: Register Data
Byte Definition:
Header
Register Data
Register Data
RWB
0
0
SB
SA
A2
A1
A0
MSB
LSB
Set to 0.
Set to 0 for Write; set to 1 for Read.
Register
Bank Select
Register
Address
SB
0
0
1
1
SA
0
1
0
1
Write Access
Disabled
SRC A
SRC B
SRC A and B
Read Access
Disabled
SRC A
SRC B
SRC B
Figure 8. SPI Protocol for the SRC4184
CSB
CCLK
CDIN
CDOUT
HiZ
HiZ
t
CSCR
t
CFCS
t
CDS
t
CFDO
t
CSZ
t
CDH
Figure 9. SPI Port Timing
相關PDF資料 |
PDF描述 |
|---|---|
| SRD00111Z | Silicon PIN Photodiode in TO-Package |
| SRD00212Z | Ternary PIN Photodiode in TO-Package with Integrated Optics |
| SRD00214C | Ternary PIN Photodiode with Pigtail |
| SRD00214H | Ternary PIN Photodiode with Pigtail |
| SRD00214X | Ternary PIN Photodiode with Pigtail |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SRC4184IPAG | 功能描述:音頻采樣頻率轉換器 4Ch A Synch Smpl Rate Cnvrtr RoHS:否 制造商:Texas Instruments THD + 噪聲:- 140 dB 接口:I2C, SPI 工作電源電壓:1.65 V to 2 V / 3 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:TQFP-48 安裝風格:SMD/SMT |
| SRC4184IPAGG4 | 功能描述:音頻采樣頻率轉換器 4-Ch Asynch Sample Rate Converter RoHS:否 制造商:Texas Instruments THD + 噪聲:- 140 dB 接口:I2C, SPI 工作電源電壓:1.65 V to 2 V / 3 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:TQFP-48 安裝風格:SMD/SMT |
| SRC4184IPAGR | 功能描述:音頻采樣頻率轉換器 4-Ch Asynch Sample Rate Converter RoHS:否 制造商:Texas Instruments THD + 噪聲:- 140 dB 接口:I2C, SPI 工作電源電壓:1.65 V to 2 V / 3 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:TQFP-48 安裝風格:SMD/SMT |
| SRC4184IPAGRG4 | 功能描述:音頻采樣頻率轉換器 4-Ch Asynch Sample Rate Converter RoHS:否 制造商:Texas Instruments THD + 噪聲:- 140 dB 接口:I2C, SPI 工作電源電壓:1.65 V to 2 V / 3 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:TQFP-48 安裝風格:SMD/SMT |
| SRC4184IPAGT | 功能描述:音頻采樣頻率轉換器 4-Ch Asynch Sample Rate Converter RoHS:否 制造商:Texas Instruments THD + 噪聲:- 140 dB 接口:I2C, SPI 工作電源電壓:1.65 V to 2 V / 3 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:TQFP-48 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。