參數資料
型號: SDWA.01
廠商: Taoglas Limited
文件頁數: 14/16頁
文件大?。?/td> 740K
描述: RF ANTENNA
標準包裝: 1
天線類型: 芯片
頻帶數目: 2
頻率: 2.4GHz ~ 2.5GHz,4.9GHz ~ 5.85GHz
VSWR: 3
增益: 3dBi
端子: 表面貼裝型
安裝類型: 表面貼裝
高度(最大): 0.059"(1.5mm)
包裝: *
其它名稱: 931-1159-6
SPE-11-8-129/C/NB
Page 14 of 16
7. Recommended Soldering Conditions
 
 
1.
Time shown in the above figures is measured from the point when chip surface
reaches temperature.
2.
Temperature difference in high temperature part should be within 110癈.
3.
 After soldering, do not force cool, allow the parts to cool gradually.
 
*General attention to soldering:
?High soldering temperatures and long soldering times can cause leaching of the
termination, decrease in adherence strength, and the change of characteristic may
occur.
?for soldering, please refer to the soldering curves above. However, please
Keep exposure to temperatures exceeding 200癈 to under 50 seconds.
?please use a mild flux (containing less than 0.2wt% Cl). Also, if the flux is water
soluble, be sure to wash thoroughly to remove any residue from the underside of
components that could affect resistance.
Cleaning:
When using ultrasonic cleaning, the board may resonate if the output power is too high.
Since this vibration can cause cracking or a decrease in the adherence of the termination, we
recommend that you use the conditions below.
Frequency: 40 kHz max.
Output power: 20W/Iiter
Cleaning time: 5minutes max.
相關PDF資料
PDF描述
SGP.1575.25.4.D.02 RF ANTENNA
SI4012-A0-GT TRANSMITTER RF 27-960MHZ 10-MSOP
SI4020-I1-FT IC TX FSK 915MHZ 5.4V 16-TSSOP
SI4021-A1-FT IC TX FSK 915MHZ 5.4V 16-TSSOP
SI4022-A0-FT IC TX FSK UNI 868/915MHZ 16TSSOP
相關代理商/技術參數
參數描述
SDWA-013 制造商:Carlo Gavazzi 功能描述:
SDWA-035 制造商:Carlo Gavazzi 功能描述:
SDWA-040 制造商:Carlo Gavazzi 功能描述:
SDWAD.01 功能描述:天線 Dual-Band 2.4/5GHz Wi-Fi Ceramic RoHS:否 制造商:Molex 技術類型:Cellular Antenna 頻率: 帶寬: 尺寸:106.7 mm L x 13 mm W
SD-WC15 功能描述:D-Sub工具與硬件 15P STRAIN RELIEF RoHS:否 制造商:3M Electronic Solutions Division 產品:Accessories 類型:Strain Relief, 36 Position 用于:Wiremount D-Sub Connectors