
1
www.semtech.com
SC803
Fully Integrated High Current
Lithium-Ion Battery Charger System
POWER MANAGEMENT
Description
Revision 4, November 2004
Features
Fully integrated charger with FET pass transistor,
reverse-blocking diode, sense resistor and thermal
protection
Complete voltage ranges of 4.1V, 4.2V &
adjustable
Programmable precharge, fastcharge & termination
current
Battery voltage controlled to 1% accuracy
Soft-start for step load and adaptor plug-in
Up to 1.5A continuous charge current
Charge current monitor output from microcontroller
or ADC Interface
Input voltages range from 4.2V to 7V
0.1μA Battery drain current in shutdown and
monitor modes
Operates without a battery in regulated LDO mode
Small 4mm x 4mm 16 lead MLP package
Low thermal impedance of 50°C/watt
Few external components
Over current protection in all charging modes
Over voltage protection with fault pin output
All outputs able to drive LED’s and interface to host
processor
Remote Kelvin sensing at the battery terminal
Small input & output filter capacitors
Status output communicates charging and end of
charge cycle
Applications
Cellular phones
PDA’s
Handheld meters
Charging stations
Handheld computers
Digital cameras
Programmable current source
Typical Application Circuit
The SC803 is a fully integrated, single cell, constant-cur-
rent constant-voltage Lithium-Ion battery charger man-
agement system. The SC803 has built in intelligence and
extreme functionality. When the battery voltage is below
2.8V the charger operates in a pre-charge mode with a
charging current of up to 125mA based on the ITERM
pin resistor. This pre-charge mode is set to limit power
dissipation due to an undercharged battery. When the
battery voltage exceeds 2.8V, the charger enters a fast
charge mode. In this mode, the SC803 delivers up to
1.5A to the battery based on the IPRGM pin resistor.
The part also features current termination, ending the
charge cycle when the battery is charged and the charge
current drops below the current programmed by the
ITERM pin resistor. In addition, the charge current can
be monitored by the voltage on the IPRGM pin allowing a
microcontroller or ADC to access the current informa-
tion to determine when to externally terminate the charge
cycle. Once the charge cycle is complete and terminates,
the device enters the charge monitor mode where the
output voltage of the battery is monitored. If this voltage
drops below the recharge threshold the device will enter
the fast charge mode again, to bring the battery to its
fully charged state. Both the shutdown and monitor
modes drain no more than 1uA from the battery guaran-
teed.
The output voltage to the battery is controlled to within
1% of the programmed voltage for either 4.1V or 4.2V.
The SC803 can also function as a general purpose cur-
rent source or as a current source for charging nickel-
cadmium (NiCd) and nickel-metal-hydride (NiMH) batter-
ies using external termination.
88
R2
1.5
Current
Terminatio
=
1000
R1
1.5
Current
Charge
Fast
=
88
R2
2.8
Current
Charge
Pre
=
R1
CHARGER VIN
SC803
14
13
1
16
3
7
4
8
6
15
12
9
2
10
11
5
VCC
VCC
BSEN
VOUT
IPRGM
EN
ITERM
BIP
GND
VOUT
NC
OVP
STAT
VPRGM
CP
NC
STATUS
CHARGER
PRESENT
FAULT
R2
BATTERY
C1
1uF
C2
2.2uF