參數資料
型號: SAB-C504-2RM
廠商: SIEMENS A G
元件分類: 微控制器/微處理器
英文描述: 8-Bit CMOS Microcontroller
中文描述: 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP44
文件頁數: 33/49頁
文件大?。?/td> 962K
代理商: SAB-C504-2RM
Semiconductor Group
33
C504
Power Saving Modes
Two power down modes are available, the idle mode and power down mode.
– In the
idle mode
the oscillator of the C504 continues to run, but the CPU is gated off from the
clock signal. However, the interrupt system, the serial port, the A/D converter, and all timers
with the exception of the watchdog timer are further provided with the clock. The CPU status
is preserved in its entirety: the stack pointer, program counter, program status word,
accumulator, and all other registers maintain their data during idle mode.
– In the
power down
mode, the RC oscillator and the on-chip oscillator which operates with the
XTAL pins is stopped. Therefore all functions of the microcontroller are stopped and only the
contents of the on-chip RAM, XRAM and the SFR's are maintained. The port pins, which are
controlled by their port latches, output the values that are held by their SFR's.
Table 10
gives a general overview of the power saving modes.
In the power down mode of operation,
V
CC
can be reduced to minimize power consumption. It must
be ensured, however, that
V
CC
is not reduced before the power down mode is invoked, and that
V
CC
is restored to its normal operating level, before the power down mode is terminated.
The idle mode can be terminated by activating any enabled peripheral interrupt or by resetting the
C504. The power down mode can be terminated using an interrupt by a short low pulse at the pin
P3.2/AN4/INT0 or by resetting the C504. If a power saving mode is left through an interrupt, the
microcontroller state (CPU, ports, peripherals) remains preserved. If a power saving mode is left by
a reset operation, the microcontroller state is disturbed and replaced by the reset state of the C504.
Table 10
Power Saving Modes Overview
Mode
Entering
2-Instruction
Example
Leaving by
Remarks
Idle mode
ORL PCON, #01H
ORL PCON, #20H
Ocurrence of an
interrupt from a
peripheral unit
CPU clock is stopped;
CPU maintains their data;
peripheral units are active (if
enabled) and provided with
clock
Hardware Reset
Power-Down
Mode
ORL PCON, #02H
ORL PCON, #40H
Hardware Reset
Oscillator is stopped;
contents of on-chip RAM and
SFR’s are maintained;
Wake-up from power
down
相關PDF資料
PDF描述
SAB-C504-L24M 8-Bit CMOS Microcontroller
SAB-C504-L40M 8-Bit CMOS Microcontroller
SAB-C541U-1EN 8-Bit CMOS Microcontroller
SAB-C540U-EN 8-Bit CMOS Microcontroller
SAB-C540U-EP 8-Bit CMOS Microcontroller
相關代理商/技術參數
參數描述
SAB-C504-L24M 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
SAB-C504-L24MAC-T 制造商:Rochester Electronics LLC 功能描述: 制造商:Infineon Technologies AG 功能描述:
SAB-C504-L40M 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
SABC504LM 制造商:Infineon Technologies AG 功能描述:MCU 8-Bit C500 8051 CISC ROMLess 5V 44-Pin MQFP
SAB-C504-LM 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller