- 您現在的位置：買賣IC網 > PDF目錄374683 > SA5.0 (Won-Top Electronics Co., Ltd.) 500W TRANSIENT VOLTAGE SUPPRESSORS PDF資料下載
參數資料
| 型號： | SA5.0 |
| 廠商： | Won-Top Electronics Co., Ltd. |
| 元件分類： | TVS-瞬態抑制二極管 |
| 英文描述： | 500W TRANSIENT VOLTAGE SUPPRESSORS |
| 中文描述： | 500W的瞬態電壓抑制器 |
| 文件頁數： | 5/5頁 |
| 文件大?。?/td> | 97K |
| 代理商： | SA5.0 |
- 636 -
TVS APPLICATION NOTES:
Transient Voltage Suppressors may be used at various points in a circuit to provide various degrees of
protection. The following is a typical linear power supply with transient voltage suppressor units placed at
different points. All provide protection of the load.
FIGURE 1
Transient Voltage Suppressors 1 provides maximum protection. However, the system will probably require
replacement of the line fuse(F) since it provides a dominant portion of the series impedance when a surge is
encountered.
However, we do not recommend to use the TVS diode here, unless we can know the electric circuit
impedance and the magnitude of surge rushed into the circuit. Otherwise the TVS diode is easy to be
destroyed by voltage surge.
Transient Voltage Suppressor 2 provides execllent protection of circuitry excluding the transformer(T).
However, since the transformer is a large part of the series impedance, the chance of the line fuse opening
during the surge condition is reduced.
Transient Voltage Suppressor 3 provides the load with complete protection. It uses a unidirectional
Transient Voltage Suppressor, which is a cost advantage. The series impedance now includes the line fuse,
transformer, and bridge rectifier(B) so failure of the line fuse is further reduced. If only Transient Voltage
Suppressor 3 is in use, then the bridge rectifier is unprotected and would require a higher voltage and current
rating to prevent failure by transients.
Any combination of these three, or any one of these applications, will prevent damage to the load. This would
require varying trade-offs in power supply protection versus maintenance(changing the time fuse).
An additional method is to utilize the Transient Voltage Suppressor units as a controlled avalanche bridge.
This reduces the parts count and incorporates the protection within the bridge rectifier.
FIGURE 2
相關PDF資料 |
PDF描述 |
|---|---|
| SA40 | 500W TRANSIENT VOLTAGE SUPPRESSORS |
| SA30 | 500W TRANSIENT VOLTAGE SUPPRESSORS |
| SA20 | 500W TRANSIENT VOLTAGE SUPPRESSORS |
| SA10 | 500W TRANSIENT VOLTAGE SUPPRESSORS |
| SA7.0 | SE Series Environmentally Sealed, Single Pole Double Throw Circuitry, 5 A at 250 Vac, Pin Plunger Actuator, Leadwire Termination |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S-A-500 | 制造商:Easy Braid Co 功能描述:BRAID UNFLUXED SILVER .025"X500' |
| SA500-2 | 制造商:Panduit Corp 功能描述:Splice Terminal 3.87mm 1.32mm Tin 制造商:Panduit Corp 功能描述:SPLICE TERM 3.87MM 1.32MM TIN - Bulk |
| SA500-2Y | 制造商:Panduit Corp 功能描述: |
| SA5007 | 制造商:Hubbell Wiring Device-Kellems 功能描述:FLUSH PLUG, 1 1/2, ALU |
| SA500PS1C1D | 功能描述:工業壓力 / 力傳感器 SST Pressure Xducers SA Transducers RoHS:否 制造商:Honeywell 工作壓力:0 bar to 25 bar 壓力類型:Sealed Gauge 準確性:0.25 % 輸出類型: 安裝風格:Screw 工作電源電壓:8 V to 30 V 輸出電壓:8 V to 30 V 封裝: |
發布緊急采購，3分鐘左右您將得到回復。