- 您現在的位置：買賣IC網 > PDF目錄385805 > S2E16 (Minmax Technology Co., Ltd.) 1.5W, Ultra-High Isolation DIP, Single & Dual Output DC/DC Converters PDF資料下載
參數資料
| 型號： | S2E16 |
| 廠商： | Minmax Technology Co., Ltd. |
| 英文描述： | 1.5W, Ultra-High Isolation DIP, Single & Dual Output DC/DC Converters |
| 中文描述： | 1.5W，超隔離下滑，單 |
| 文件頁數： | 5/6頁 |
| 文件大?。?/td> | 241K |
| 代理商： | S2E16 |
Test Configurations
Input Reflected-Ripple Current Test Setup
Input reflected-ripple current is measured with a inductor
Lin (4.7uH) and Cin (220uF, ESR < 1.0[ at 100 KHz) to
simulate source impedance.
Capacitor Cin, offsets possible battery impedance.
Current ripple is measured at the input terminals of the
module, measurement bandwidth is 0-500 KHz.
Peak-to-Peak Output Noise Measurement Test
Use a Cout 0.33uF ceramic capacitor.
Scope measurement should be made by using a BNC
socket, measurement bandwidth is 0-20 MHz. Position the
load between 50 mm and 75 mm from the DC/DC Converter.
Design & Feature Considerations
Maximum Capacitive Load
The S2E00 series has limitation of maximum connected
capacitance at the output.
The power module may be operated in current limiting
mode during start-up, affecting the ramp-up and the startup
time.
For optimum performance we recommend 220uF
maximum capacitive load
for each dual outputs and 470
u
F
capacitive load
for single outputs.
The maximum capacitance can be found in the data sheet.
Input Source Impedance
The power module should be connected to a low
ac-impedance input source. Highly inductive source
impedances can affect the stability of the power module.
In applications where power is supplied over long lines and
output loading is high, it may be necessary to use a capacitor
at the input to ensure startup.
Capacitor mounted close to the power module helps
ensure stability of the unit, it is recommended to use a good
quality low Equivalent Series Resistance (ESR < 1.0[ at 100
KHz) capacitor of a 2.2uF for the 5V input devices, a 1.0uF for
the 12V input devices and a 0.47uF for the 15V devices.
Output Ripple Reduction
A good quality low ESR 1.5uF capacitor connected as
colse as possible to the load is recommended.
Thermal Considerations
Many conditions affect the thermal performance of the
power module, such as orientation, airflow over the module
and board spacing. To avoid exceeding the maximum
temperature rating of the components inside the power
module, the case temperature must be kept below 95°C.
The derating curves are determined from measurements
obtained in an experimental apparatus.
S2E00 Series
REV:0 2005/04
MINMAX
5
+Out
-Out
+Vin
-Vin
DC / DC
Converter
Load
Battery
+
Lin
+
Cin
To Oscilloscope
Current
Probe
+Out
-Out
+Vin
-Vin
Dual Output
DC / DC
Converter
Resistive
Load
Scope
Copper Strip
Cout
Com.
Scope
Cout
+Out
-Out
+Vin
-Vin
Single Output
DC / DC
Converter
Resistive
Load
Scope
Copper Strip
Cout
+
+Out
-Out
+Vin
-Vin
DC / DC
Converter
Load
DC Power
Source
+
-
Cin
+Out
-Out
+Vin
-Vin
Load
DC Power
Source
+
-
Cout
Com.
Dual Output
DC / DC
Converter
+Out
-Out
+Vin
-Vin
Load
DC Power
Source
+
-
Cout
Single Output
DC / DC
Converter
DUT
Position of air velocity
probe and thermocouple
50mm / 2in
Air Flow
15mm / 0.6in
相關PDF資料 |
PDF描述 |
|---|---|
| S2E17 | 1.5W, Ultra-High Isolation DIP, Single & Dual Output DC/DC Converters |
| S2E18 | 1.5W, Ultra-High Isolation DIP, Single & Dual Output DC/DC Converters |
| S2L20U | Super Fast Recovery Rectifiers(200V 1.5A) |
| S2L40 | HEL-700 Series temperature sensor, platinum RTD, ceramic case, leadwires |
| S2V20 | General Purpose Rectifiers(200V 1.7A) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S2E17 | 制造商:MINMAX 制造商全稱:Minmax Technology Co., Ltd. 功能描述:1.5W, Ultra-High Isolation DIP, Single & Dual Output DC/DC Converters |
| S2E170-DA05-06 | 制造商:ebm-papst Inc 功能描述: |
| S2E18 | 制造商:MINMAX 制造商全稱:Minmax Technology Co., Ltd. 功能描述:1.5W, Ultra-High Isolation DIP, Single & Dual Output DC/DC Converters |
| S2E200-AI38-01 | 功能描述:鼓風機 AC AXIAL FAN RoHS:否 制造商:Murata 產品:Blowers 電流類型:DC 電源電壓:5.3 V 氣流:1 l/min 軸承類型: 噪聲: 速度: 功率額定值: 框架尺寸 (mm):20 mm x 20 mm x 1.85 mm 外殼材料: 端接類型:SMD/SMT 系列:MZB |
| S2E200-BA01-16 | 制造商:ebm-papst Inc 功能描述:230V 2MF "V" - Bulk |
發布緊急采購，3分鐘左右您將得到回復。