參數資料
型號： S29PL256N70GAW003
廠商： SPANSION LLC
元件分類： DRAM
英文描述： 740; 38000/740 Series; Microcontroller; Bit Size: 8-bit; ROM: 48K; RAM: 2048; ROM Type: QzROM; CPU: 740 core; Minimum Instruction Execution Time (ns): 320 (@12.5MHz); Operating Frequency / Supply Voltage: 1.8 to 5.5V; Operating Ambient Temperature (°C): -20 to 85; Package Code: PLQP0080KB-A (80P6Q-A)
中文描述： 16M X 16 FLASH 3V PROM, 70 ns, PBGA84
封裝： 8 X 11.60 MM, LEAD FREE COMPLIANT, FBGA-84
文件頁數： 47/74頁
文件大小： 1968K
代理商： S29PL256N70GAW003
June 6, 2007 S29PL-N_00_A5
S29PL-N MirrorBit
Flash Family
47
D a t a
S h e e t
( P r e l i m i n a r y )
8.4
Persistent Protection Bit Lock Bit
The Persistent Protection Bit Lock Bit is a global volatile bit for all sectors. When set (programmed to
0
), this
bit locks all PPB and when cleared (programmed to
1
), unlocks each sector. There is only one PPB Lock Bit
per device.
Notes
1. No software command sequence unlocks this bit unless the device is in the password protection
mode; only a hardware reset or a power-up clears this bit.
2. The PPB Lock Bit must be set (programmed to
0
) only after all PPBs are configured to the desired
settings.
8.5
Password Protection Method
The Password Protection Method allows an even higher level of security than the Persistent Sector Protection
Mode by requiring a 64-bit password for unlocking the device PPB Lock Bit. In addition to this password
requirement, after power up and reset, the PPB Lock Bit is set
0
to maintain the password mode of operation.
Successful execution of the Password Unlock command by entering the entire password clears the PPB Lock
Bit, allowing for sector PPBs modifications.
Notes
1. There is no special addressing order required for programming the password. Once the Password
is written and verified, the Password Mode Locking Bit must be set to prevent access.
2. The Password Program Command is only capable of programming
0
s. Programming a
1
after a
cell is programmed as a
0
results in a time-out with the cell as a
0
.
3. The password is all
1
s when shipped from the factory.
4. All 64-bit password combinations are valid as a password.
5. There is no means to verify what the password is after it is set.
6. The Password Mode Lock Bit, once set, prevents reading the 64-bit password on the data bus and
further password programming.
7. The Password Mode Lock Bit is not erasable.
8. The lower two address bits (A1 – A0) are valid during the Password Read, Password Program, and
Password Unlock.
9. The exact password must be entered in order for the unlocking function to occur.
10.The Password Unlock command cannot be issued any faster than 1 μs at a time to prevent a
hacker from running through all the 64-bit combinations in an attempt to correctly match a
password.
11.Approximately 1 μs is required for unlocking the device after the valid 64-bit password is given to
the device.
12.Password verification is only allowed during the password programming operation.
13.All further commands to the password region are disabled and all operations are ignored.
14.If the password is lost after setting the Password Mode Lock Bit, there is no way to clear the PPB
Lock Bit.
15.Entry command sequence must be issued prior to any of any operation and it disables reads and
writes for Bank A. Reads and writes for other banks excluding Bank A are allowed.
16.If the user attempts to program or erase a protected sector, the device ignores the command and
returns to read mode.
17.A program or erase command to a protected sector enables status polling and returns to read
mode without having modified the contents of the protected sector.
18.The programming of the DYB, PPB, and PPB Lock for a given sector can be verified by writing
individual status read commands DYB Status, PPB Status, and PPB Lock Status to the device.
相關PDF資料
PDF描述
S29PL256N70GAWW00 256/128/128 Mb (16/8/8 M x 16-Bit) CMOS, 3.0 Volt-only Simultaneous Read/Write, Page-Mode Flash Memory
S29PL256N70GAWW02 256/128/128 Mb (16/8/8 M x 16-Bit) CMOS, 3.0 Volt-only Simultaneous Read/Write, Page-Mode Flash Memory
S29PL256N70GAWW03 740; 38000/740 Series; Microcontroller; Bit Size: 8-bit; ROM: 60K; RAM: 2048; ROM Type: QzROM; CPU: 740 core; Minimum Instruction Execution Time (ns): 320 (@12.5MHz); Operating Frequency / Supply Voltage: 1.8 to 5.5V; Operating Ambient Temperature (°C): -20 to 85; Package Code: PRQP0080GB-A (80P6N-A)
S29PL256N70GFW000 740; 38000/740 Series; Microcontroller; Bit Size: 8-bit; ROM: 60K; RAM: 2048; ROM Type: QzROM; CPU: 740 core; Minimum Instruction Execution Time (ns): 320 (@12.5MHz); Operating Frequency / Supply Voltage: 1.8 to 5.5V; Operating Ambient Temperature (°C): -20 to 85; Package Code: PLQP0080KB-A (80P6Q-A)
S29PL256N70GFW002 256/128/128 Mb (16/8/8 M x 16-Bit) CMOS, 3.0 Volt-only Simultaneous Read/Write, Page-Mode Flash Memory
相關代理商/技術參數
參數描述
S29PL256N70GAWW00 制造商:SPANSION 制造商全稱:SPANSION 功能描述:256/128/128 Mb (16/8/8 M x 16-Bit) CMOS, 3.0 Volt-only Simultaneous Read/Write, Page-Mode Flash Memory
S29PL256N70GAWW02 制造商:SPANSION 制造商全稱:SPANSION 功能描述:256/128/128 Mb (16/8/8 M x 16-Bit) CMOS, 3.0 Volt-only Simultaneous Read/Write, Page-Mode Flash Memory
S29PL256N70GAWW03 制造商:SPANSION 制造商全稱:SPANSION 功能描述:256/128/128 Mb (16/8/8 M x 16-Bit) CMOS, 3.0 Volt-only Simultaneous Read/Write, Page-Mode Flash Memory
S29PL256N70GFI000 制造商:SPANSION 制造商全稱:SPANSION 功能描述:256/128/128 Mb (16/8/8 M x 16-Bit) CMOS, 3.0 Volt-only Simultaneous Read/Write, Page-Mode Flash Memory
S29PL256N70GFI002 制造商:SPANSION 制造商全稱:SPANSION 功能描述:256/128/128 Mb (16/8/8 M x 16-Bit) CMOS, 3.0 Volt-only Simultaneous Read/Write, Page-Mode Flash Memory
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*