參數資料
型號: RT9209APS
廠商: Richtek Technology Corporation
英文描述: Synchronous Buck PWM DC-DC with Enable & PGOOD
中文描述: 同步降壓PWM直流與直流啟用
文件頁數: 10/14頁
文件大?。?/td> 217K
代理商: RT9209APS
RT9209/A
10
DS9209/A-08 March 2007
www.richtek.com
Application Information
The RT9209/A operates at either single 5V power supply
with a bootstrap UGATE driver or a 5V/12V dual-power
supply form the ATX SMPS. The dual- power supply is
recommended for high current applications, the
RT9209/A can deliver higher gate driving current while
operating with ATX SMPS based on a dual-power supply.
The Bootstrap Operation
In a single power supply system, the UGATE driver of
RT9209/A is powered by an external bootstrap circuit, as
shown in the Figure1. The boot capacitor, C
BOOT
,
generates a floating reference. Typically a 0.1
μ
F C
BOOT
is enough for most of MOSFETs used with the
RT9209/A. The voltage drop between BOOT and A node
is refreshed to a voltage of V
CC
diode drop (V
D
) while the
lower MOSFET turning on.
Figure 1. Single 5V power Supply Operation
Dual Power Operation
The RT9209/A is designed to supply a regulated 6.5V at
VCC pin automatically when BOOT pin is powered by a
12V. In a system with ATX 5V/12V power supply, the
RT9209/A is ideal for higher current applications due to
the higher gate driving capability, V
UGATE
= 12V and V
LGATE
= 6.5V. A RC (10
Ω
/1
μ
F) filter is also recommended at
BOOT pin to prevent the ringing induced from fast power-
on, as shown in Figure 2.
Figure 2. Dual Power Supply Operation
Power On Reset
The Power-On Reset (POR) monitors the supply voltage
(normal +5V) at the VCC pin. The VCC POR level is set
to 4.1V with 0.5V hysteresis. The POR function initiates
soft-start operation after all supply voltages exceed their
POR thresholds.
Soft Start
A built-in soft-start is used to prevent surge current from
power supply input during power on. The soft-start voltage
is controlled by an internal 22
μ
A to change a capacitor
slowly. It clamps the ramping of reference voltage at the
input of error amplifier and the pulse-width of the output
driver slowly.
Under Voltage and Over Voltage Protection
The voltage at FB pin is monitored and protected against
OC (over current), and OV (over voltage). The UV
threshold is 0.5V and OV-threshold is 1.0V. Both UV/OV
detection have 30ms triggered delay. When OC or UV
trigged, a hiccup re-start sequence will be initialized, as
shown in Figure 3. Only 3 times of trigger are allowed to
latch off. Hiccup is disabled during soft-start interval.
Shutdown
Pulling low the SS pin by a small single transistor can
shutdown the RT9209/A PWM controller as shown in
typical application circuit.
+
C2
1uF
C1
+
-
0.1uF
D1
VCC
UGATE
BOOT
LGATE
VCC
RT9209/A
5V
A
+
C2
1uF
C1
1uF
VCC
LGATE
RT9209/A
5V
6.5V
Regulator
VCC
UGATE
BOOT
12V
R1
10
5V
A
相關PDF資料
PDF描述
RT9209GS Synchronous Buck PWM DC-DC with Enable & PGOOD
RT9209PS Synchronous Buck PWM DC-DC with Enable & PGOOD
RT9210 Dual 5V Synchronous Buck DC-DC PWM Controller for DDR Memory VDDQ and VTT Termination
RT9210GC Dual 5V Synchronous Buck DC-DC PWM Controller for DDR Memory VDDQ and VTT Termination
RT9210GS Dual 5V Synchronous Buck DC-DC PWM Controller for DDR Memory VDDQ and VTT Termination
相關代理商/技術參數
參數描述
RT9209GS 制造商:RICHTEK 制造商全稱:Richtek Technology Corporation 功能描述:Synchronous Buck PWM DC-DC with Enable & PGOOD
RT9209PS 制造商:RICHTEK 制造商全稱:Richtek Technology Corporation 功能描述:Synchronous Buck PWM DC-DC with Enable & PGOOD
RT9210 制造商:RICHTEK 制造商全稱:Richtek Technology Corporation 功能描述:Dual 5V Synchronous Buck DC-DC PWM Controller for DDR Memory VDDQ and VTT Termination
RT9210GC 制造商:RICHTEK 制造商全稱:Richtek Technology Corporation 功能描述:Dual 5V Synchronous Buck DC-DC PWM Controller for DDR Memory VDDQ and VTT Termination
RT9210GS 制造商:RICHTEK 制造商全稱:Richtek Technology Corporation 功能描述:Dual 5V Synchronous Buck DC-DC PWM Controller for DDR Memory VDDQ and VTT Termination