參數資料
型號: RA18H1213G-01
廠商: Mitsubishi Electric Corporation
英文描述: 1.24-1.30GHz 18W 12.5V, 3 Stage Amp. For MOBILE RADIO
中文描述: 1.24 - 1.30GHz 18W 12.5V,3階段制造。對于移動通信
文件頁數: 8/9頁
文件大小: 96K
代理商: RA18H1213G-01
MITSUBISHI RF POWER MODULE
R A18H1213G
RA18H1213G
MITSUBISHI ELECTRIC
8/9
5 April 2004
ELECTROSTATIC SENSITIVE DEVICE
OBSERVE HANDLING PRECAUTIONS
Output Power Control:
Depending on linearity, the following two methods are recommended to control the output power:
a) Non-linear FM modulation:
By the gate voltage (V
GG
).
When the gate voltage is close to zero, the RF input signal is attenuated up to 60 dB and only a small leakage
current flows from the battery into the drain.
Around V
GG
=4V, the output power and drain current increases substantially.
Around V
GG
=4.5V (typical) to V
GG
=5V (maximum), the nominal output power becomes available.
b) Linear AM modulation:
By RF input power P
in
.
The gate voltage is used to set the drain’s quiescent current for the required linearity.
Oscillation:
To test RF characteristics, this module is put on a fixture with two bias decoupling capacitors each on gate and drain,
a 4.700 pF chip capacitor, located close to the module, and a 22 μF (or more) electrolytic capacitor.
When an amplifier circuit around this module shows oscillation, the following may be checked:
a) Do the bias decoupling capacitors have a low inductance pass to the case of the module
b) Is the load impedance Z
L
=50
c) Is the source impedance Z
G
=50
Frequent on/off switching:
In base stations, frequent on/off switching can cause thermal expansion of the resin that coats the transistor chips
and can result in reduced or no output power. The bond wires in the resin will break after long-term thermally induced
mechanical stress.
Quality:
Mitsubishi Electric is not liable for failures resulting from base station operation time or operating conditions
exceeding those of mobile radios.
This module technology results from more than 20 years of experience, field proven in tens of millions of mobile
radios. Currently, most returned modules show failures such as ESD, substrate crack, and transistor burnout, which
are caused by improper handling or exceeding recommended operating conditions. Few degradation failures are
found.
Mitsubishi Electric Corporation puts the maximum effort into making semiconductor products better and more reliable, but
there is always the possibility that trouble may occur. Trouble with semiconductors may lead to personal injury, fire or property
damage. Remember to give due consideration to safety when making your circuit designs, with appropriate measures such as
(i) placement of substitutive, auxiliary circuits, (ii) use of non-flammable material, or (iii) prevention against any malfunction or
mishap.
Keep safety first in your circuit designs!
相關PDF資料
PDF描述
RA204800A General Purpose Rectifier (4800 Amperes Average 1200 Volts)
RA20H8087M 806-825/ 851-870MHz 20W 12.5V, 3 Stage Amp. For MOBILE RADIO
RA20H8087M-01 806-825/ 851-870MHz 20W 12.5V, 3 Stage Amp. For MOBILE RADIO
RA20H8087M-E01 806-825/ 851-870MHz 20W 12.5V, 3 Stage Amp. For MOBILE RADIO
RA20H8994M-01 896-902/ 935-941MHz 20W 12.5V, 3 Stage Amp. For MOBILE RADIO
相關代理商/技術參數
參數描述
RA18H1213G-101 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:1.24-1.30GHz 18W 12.5V, 3 Stage Amp. For MOBILE RADIO
RA-18W-K 功能描述:低信號繼電器 - PCB Mini Signal 18VDC RoHS:否 制造商:NEC 觸點形式:2 Form C (DPDT-BM) 觸點電流額定值: 線圈電壓:5 V 最大開關電流:1 A 線圈電流:1 A 線圈類型:Non-Latching 功耗:140 mW 端接類型:SMT 絕緣: 介入損耗:
RA1A104F 制造商:IMB 功能描述:AF410X100 1% Axial Polycarbonate 6mmX10mm Round
RA1A14331200 功能描述:搖臂開關與扳鈕開關 ROCKER RoHS:否 制造商:C&K Components 觸點形式: 開關功能: 電流額定值:50 mA 電壓額定值 AC: 電壓額定值 DC:30 V 功率額定值: 端接類型: 執(zhí)行器:Paddle 顏色: 安裝風格:Panel 端子密封: 觸點電鍍: 照明:Not Illuminated 照明顏色:
RA1A14431100 功能描述:搖臂開關與扳鈕開關 ROCKER RoHS:否 制造商:C&K Components 觸點形式: 開關功能: 電流額定值:50 mA 電壓額定值 AC: 電壓額定值 DC:30 V 功率額定值: 端接類型: 執(zhí)行器:Paddle 顏色: 安裝風格:Panel 端子密封: 觸點電鍍: 照明:Not Illuminated 照明顏色: