
PX1014A 82.0 MHz SAW Filter
RF Monolithics, Inc.
Phone: +1(972)233-2903
European Sales Office
4347 Sigma Road
Fax: +1(972)387-8148
Dallas, Texas 75244
e-mail: info@rfm.com
USA
Home page:
www.rfm.com
PX1014A 7/22/1999 R
Electrical Connections
Connection
Terminals
Port 1 Hot
2
Port 1 Gnd Return
3
Port 2 Hot
8
Port 2 Gnd Return
9
Case Ground
All others
Absolute Maximum Ratings
Rating
Value
Units
Maximum Incident Power in Passband
+10
dBm
Max. DC voltage between any 2 terminals
30
VDC
Storage Temperature Range
-40 to +85
°C
Max Soldering Profile
265
°C for 10 s
Designed for TDMA, CDPD, & CATV Narrow-Band Data
Low Insertion Loss
Excellent Selectivity
Hermetic 13.3 x 6.5 mm Surface-Mount Case
Unbalanced Input and Output
See Associated Plots
Characteristic
Sym
Min
Typ
Max
Units
Notes
Nominal Center Frequency
fc
82.000
MHz
IL
3
5.0
dB
1
BW3
±15
±25
kHz
1.0
dBP-P
Passband
Insertion Loss at fc
3 dB Passband
Amplitude Ripple over fc
±15 kHz
Group Delay Variation over fc
±15 kHz GDV
3.5
10.0
sP-P
1, 2
15
50
35
60
Rejection
fc -120 to -60 kHz and fc +60 to +120 kHz
fc -400 to -120 kHz and fc +120 to +400 kHz
fc -40 to -0.4 MHz and fc +0.4 to +40 MHz
52
55
dB
1, 2, 3
Operating Temperature Range
TA
-30
+75
°C
1
Impedance Matching to 50
unbalanced
External L-C
Case Style
SM13365-12 13.3 x 6.5 mm Nominal Footprint
Lid Symbolization (YY = year, WW = week) See note 4
RFM PX1014A YYWW
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified
demonstration board with impedance matching to 50
and measured with 50 network analyzer.
2.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent
on PCB layout and external impedance matching design. See Application Note No. 42 for details.
4.
“LRIP” or “L” after the part number indicates “l(fā)ow rate initial production” and “ENG” or “E” indicates “engineering prototypes.”
5.
The design, manufacturing process, and specifications of this filter are subject to change.
6.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may
vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design.
7.
US and international patents may apply.
8.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
9.
Copyright 1999, RF Monolithics Inc.
10. Electrostatic Sensitive Device. Observe precautions for handling.
PRELIMINARY