
Preliminary
PJ2596
150KHz, 3A PWM Buck Switching Regulator
1-6
2004/07.rev.B
The PJ2596 is a monolithic integrated circuit that
provide all the active function for a step-down
switching regulator, capable of driving a 3A load without
additional transistor component. The external shutdown
function can be controlled by TTL logic level and then into
standby mode. The internal compensation makes feedback
control have good line and load regulation without external
design. Regarding protected function, thermal shutdown is to
prevent over temperature operating from damage, and current
limit is against over current operating of the output switch.
The PJ2596 operates at a switching frequency of PJ2596 thus
allowing smaller sized filter components than what would be
needed with lower frequency switching regulators. Other
features include a guaranteed ±4% tolerance on output voltage
under specified input voltage and output load conditions, and
±15% on the oscillator frequency. The output version included
fixed 3.3V, 5V, 12V, and an adjustable type.
____________
3.3V, 5V, 12V and adjustable output versions
Input voltage range up to 25V
Output load current: 3A
Built-in switching transistor on chip
Low power standby mode
ON/OFF shutdown control input
Thermal-shutdown and current-limit protection
150kHz fixed frequency internal oscillator
Voltage mode non-synchronous PWM control
Adjustable version output voltage range, 1.23V to
25V±4% max over line and load condition
Simple High-efficiency step-down(buck) regulator
Battery Charger
Positive to negative converter
On-card switching regulator
Efficient preregulator for linear regulator
TO-220-5L
TO-263-5L
PIN 1. Input
PIN 2. Output
PIN 3. Ground
PIN 4. Feed Back
PIN 5.On/off
Device
Operating Temperature
Package
PJ2596CZ-xx
TO-220-5L
PJ2596CM-xx
-40℃ to +85℃
TO-263-5L
Note: xx is output voltage available for Adj /3.3V/ 5.0v/
12V. Contact factory for additional voltage option.
T
ORDERING INFORMATION
TYPICAL APPLICATION CIRCUIT
APPLICATIONS
FEATURES